Heatmiser RF-Switch V2 Manuale utente
RF-Switch V2 – LED/button indication Installing the RF-Switch V2
Overriding the outputs
Output status LED’s
– Output active
when lit.
Power
status
LED
Pairing/override
buttons
Retaining Screw
To override an output on the RF-Switch V2, simplypress the override button once, the
output& LED will then be activated.
To override the output o, pressthe button once.
Rev 1.1 Model: RF-Switch V2
Want More Information?
PDF FAQ VIDEO
Call our support team on: +44 (0)1254 669090
Or view technical specications directly on our website:
www.heatmiser.com
Twitter: @heatmiseruk Facebook: facebook.com/thermostats
1 2
3
1. Using a small screwdriver,
slightly loosen the screw
located at the base of the
RF-Switch. You can then
carefully separate the front
panel from the back plate.
2. Position the RF-Switch back
plate on the wall, xing
into place using the screws
provided.
3. Terminate the cables to the
RF-Switch as shown in the
wiring diagram (section6).
4. Mount the front panel onto
the back plate, tighten the
retaining screw on the base.
5. Switch on the power supply,
the power LED will illuminate.
Heatmiser UK Ltd
Units 1-5 Hurstwood Court, Mercer Way
Shadsworth Business Park, Blackburn,
Lancashire, BB1 2QU, United Kingdom.
On the RF-Switch, press and hold the CH1 pairing button for 5 seconds.
The CH1 status LED will start to ash.
Press and release the pairing button on the UH8-RF.
When the RF-Switch detects the pairing signal from the UH8-RF, the CH1 LED
will stop ashing.
To pair your wireless thermostat to the RF-Switch, please refer to your wireless
thermostat instruction manual.
When pairing a thermostat in combined heating/hotwater mode, you do not
need to pair to the HW channel. This is done automatically when the stat is
paired to either CH1 or CH2.
RF-Switch Wiring Diagram (S Plan)
6
Pairing the RF-Switch to the UH8-RF/UH8-RF V2 Channel Reset
4 5
To reset an output of the RF-Switch;
• Press and hold the pairing/override button of the desired channel for 15 seconds.
During the button press you will see the LED ash steadily followed by a rapid ash.
Once the LED has stopped blinking, the reset procedure is complete and will erase all
devices paired to that channel..
ZONE 1
HEATING VALVE
HOT WATER
VALVE
C1 NO1 C2 NO2 C3 NC3 NO3 N EARTH L
MAINS
SUPPLY
230v
L
E
N
BOILER AND
PUMP ENABLE
HOT WATER
STAT
HW
CH1 CH2
ZONE 2
HEATING VALVE
This product must only be installed by a qualied
electrician and comply with local installation regulations.
•
•
Altri manuali Heatmiser Interruttore
