4
SAFETY
SAFETY ALERTS
The safety alert symbol is used in decals on the unit
and with proper operation procedures in this manual.
Understand the safety message. It contains
important information about personal safety on or
near the unit.
DANGER: IMMINENTLY HAZARDOUS
SITUATION! If not avoided, WILL RESULT
in death or serious injury.
DANGER: POTENTIALLY HAZARDOUS
SITUATION! If not avoided, COULD
RESULT in death or serious injury.
DANGER: POTENTIALLY HAZARDOUS
SITUATION! If not avoided, MAY RESULT
in minor or moderate injury. It may also be
used to alert against unsafe practices.
NOTATIONS
NOTE: General reference information for proper
operation and maintenance practices.
IMPORTANT: Specific procedures or information
required to prevent damage to unit or attachment.
PRACTICES AND LAWS
Practice usual and customary safe working
precautions for the benefit of yourself and others.
Be alert to unsafe conditions and the possibility of
minor, moderate, or serious injury or death. Learn
applicable rules and laws in your area.
REQUIRED OPERATOR TRAINING
Original purchaser of this unit was instructed by the
seller on safe and proper operation. If unit is to be
used by someone other than original purchaser;
loaned, rented or sold, ALWAYS provide this manual
and any needed safety training before operation.
ALWAYS read and understand the documentation
for any machine to be controlled by radio remote
control.
POSSIBLE SOURCES OF DANGER
This device is part of a system that makes remote
control via radio signals possible. However, the
transmission of control commands can take place
around obstacles and out of the operator’s direct
sight. Take the following precautions to prevent
accidental start-up and possible injury or damage:
1. Switch “OFF” the transmitter when it is not in
use. If equipped, remove the key if the unit is
placed any distance away from the operator.
2. Disconnect the power supply from the
receiver before any assembly, maintenance
or repair work is done.
IMPORTANT: AVOID SYSTEM DAMAGE -
ALWAYS disconnect receiver power
supply and control wiring before
welding on any part of the machine.
3. NEVER remove or alter any of the safety
features.
4. ALWAYS confirm that the machine and
radio remote control Stop functions work
properly BEFORE beginning any machine
operation.
PROTECTIVE FEATURES
This system is equipped with electronic and
mechanical safety features. Control signals from
other transmitters cannot be processed because
transmission coding is unique to each system
TO STOP IN AN EMERGENCY
Push the emergency stop on the machine.
MAINTENANCE
ALWAYS shut off power to the machine, transmitter
and receiver before any assembly, maintenance or
repair.
DRAWINGS AND OPERATION GUIDE
ALWAYS refer to your system drawing and
Operational Guide if you have specific questions on
how your system should operate. This manual is
intended only as a supplement to your system
drawings for reference. Your system may be
customized for your specific application.
