HHP IMAGETEAM 5600 Manuale utente

™

IMAGETEAM™ 5600

Light Commercial Hand Held Linear Imager

User’s Guide

Disclaimer

Hand Held Products, Inc. d/b/a HHP (“HHP”) reserves the right to make changes

in specifications and other information contained in this document without prior

notice, and the reader should in all cases consult HHP to determine whether any

such changes have been made. The information in this publication does not

represent a commitment on the part of HHP.

HHP shall not be liable for technical or editorial errors or omissions contained

herein; nor for incidental or consequential damages resulting from the furnishing,

performance, or use of this material.

This document contains proprietary information which is protected by copyright.

All rights are reserved. No part of this document may be photocopied,

reproduced, or translated into another language without the prior written consent

of HHP.

Web Address: www.HHP.com

Statement of Agency Compliance

This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that

may cause undesired operation.

FCC Class B Compliance Statement

This equipment has been tested and found to comply with the limits for a Class

B digital device pursuant to part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses, and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following

measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

•Consult the dealer or an experienced radio or television technician for

help.

Caution: Any changes or modifications made to this device that are not

expressly approved by Hand Held Products, Inc. may void the user’s authority to

operate the equipment.

Note: To maintain compliance with FCC Rules and Regulations, cables

connected to this device must be shielded cables, in which the cable shield

wire(s) have been grounded (tied) to the connector shell.

Canadian Notice

This equipment does not exceed the Class B limits for radio noise emissions as

described in the Radio Interference Regulations of the Canadian Department of

Communications.

Le present appareil numerique n’emet pas de bruits radioelectriques depassant

les limites applicables aux appareils numeriques de la classe B prescrites dans

le Reglement sur le brouillage radioelectrique edicte par le ministere des

Communications du Canada.

The CE mark on the product indicates that the system has been

tested to and conforms with the provisions noted within the 89/336/

EEC Electromagnetic Compatibility Directive and the 73/23/EEC

Low Voltage Directive.

For further information please contact:

Hand Held Products, Inc.

Nijverheidsweg 9

5627 BT Eindhoven

The Netherlands

HHP shall not be liable for use of our product with equipment (i.e., power

supplies, personal computers, etc.) that is not CE marked and does not comply

with the Low Voltage Directive.

UL and cUL Statement

UL listed UL1950 and CSA 22.2 No.950. cUL listed UL1950 and CSA 22.2 No

950.

LED Safety Statement

This device has been tested in accordance with EN60825-1 LED safety, and has

been certified to be under the limits of a Class 1 LED device.

TÜV Statement

TÜV or GS marked to EN60950 and EN60825-1.

C-Tick Statement

Conforms to AS/NZS 3548. C-Tick number: N10410.

Patents

Please refer to the IT5600 packaging for patent information.

Chapter 1 - Getting Started

About This Manual ............................................................... 1-1

Unpacking the Scanner ......................................................... 1-1

IT5600 Models...................................................................... 1-2

IT5600 Scanner Identification .............................................. 1-3

Connecting the Scanner When Powered by Host

(Keyboard Wedge)............................................................. 1-4

Reading Techniques.............................................................. 1-5

Resetting the Standard Product Defaults .............................. 1-5

Plug and Play ........................................................................ 1-5

Keyboard Wedge............................................................ 1-6

Laptop Direct Connect ................................................... 1-6

RS-232............................................................................ 1-6

Wand Emulation Same Code ......................................... 1-7

Wand Emulation Code 39 .............................................. 1-7

IBM 4683 Ports 5B, 9B, and 17 Interface...................... 1-8

Connecting the Scanner with USB ....................................... 1-9

Connecting the Scanner with Serial Wedge ....................... 1-10

Chapter 2 - Terminal Interfaces

Keyboard Wedge Connection............................................... 2-1

Terminal ID .......................................................................... 2-1

Supported Terminals............................................................. 2-2

Keyboard Country ................................................................ 2-3

Keyboard Style ..................................................................... 2-4

Keyboard Modifiers.............................................................. 2-5

Connecting the Scanner with RS-232 Serial Port................. 2-6

RS-232 Baud Rate.......................................................... 2-7

RS-232 Word Length: Data Bits, Stop Bits, and Parity. 2-8

RS-232 Handshaking ..................................................... 2-9

Wand Emulation Connection ......................................... 2-9

Wand Emulation Transmission Rate............................ 2-10

Wand Emulation Polarity............................................. 2-10

Wand Emulation Idle ................................................... 2-11

Table of Contents

Chapter 3 - Output

Good Read Indicators............................................................ 3-1

Beeper – Good Read....................................................... 3-1

Beeper Volume – Good Read.........................................3-1

Beeper Pitch – Good Read..............................................3-1

Beeper Duration – Good Read........................................3-2

LED – Good Read ..........................................................3-2

Number of Beeps – Good Read...................................... 3-2

Reread Delay ......................................................................... 3-2

Good Read Delay .................................................................. 3-3

Trigger Modes....................................................................... 3-3

Manual/Serial Trigger..................................................... 3-3

Automatic Trigger ..........................................................3-5

Presentation Mode .......................................................... 3-5

Centering ............................................................................... 3-5

Chapter 4 - Data Editing

Prefix/Suffix Overview ......................................................... 4-1

To Clear One or All Prefixes or Suffixes: ......................4-3

To Add a Carriage Return Suffix to all Symbologies ....4-3

Prefix Selections ............................................................. 4-4

Suffix Selections............................................................. 4-4

Function Code Transmit .................................................4-4

Intercharacter, Interfunction, and Intermessage Delays........ 4-4

Intercharacter Delay ....................................................... 4-5

User Specified Intercharacter Delay...............................4-5

Interfunction Delay......................................................... 4-6

Intermessage Delay......................................................... 4-6

iii

Chapter 5 - Data Formatting

Data Format Editor Introduction ...........................................5-1

To Add a Data Format ....................................................5-1

Other Programming Selections.......................................5-2

Data Format Editor Commands ......................................5-2

Data Format Editor .........................................................5-4

Data Formatter ................................................................5-5

Alternate Data Formats...................................................5-5

Chapter 6 - Secondary Interface

Secondary Code 39 Wand Emulation ...................................6-1

Secondary RS-232 Connection .............................................6-1

Secondary Non Decoded Output Laser Emulation ...............6-2

Non Decoded Output Laser Emulation Transmission Rate ..6-2

Non Decoded Output Laser Emulation Polarity....................6-2

Non Decoded Laser Emulation Idle ......................................6-3

Disabling the Secondary Interface ........................................6-3

Secondary Trigger Mode.......................................................6-3

Chapter 7 - Symbologies

Introduction ...........................................................................7-1

All Symbologies ....................................................................7-1

Message Length.....................................................................7-2

Codabar .................................................................................7-3

Codabar Start/Stop Characters .......................................7-3

Codabar Check Character ...............................................7-3

Codabar Concatenation...................................................7-4

Codabar Message Length................................................7-5

Code 39..................................................................................7-5

Code 39 Start/Stop Characters .......................................7-5

Code 39 Check Character ...............................................7-6

Code 39 Message Length................................................7-6

Code 39 Append .............................................................7-7

Code 32 Pharmaceutical (PARAF).................................7-7

Full ASCII.......................................................................7-8

Interleaved 2 of 5 .................................................................. 7-9

Check Digit..................................................................... 7-9

Interleaved 2 of 5 Message Length............................... 7-10

Code 93 ............................................................................... 7-10

Code 93 Message Length ............................................. 7-10

Code 2 of 5 .......................................................................... 7-11

Code 2 of 5 Message Length ........................................7-11

IATA Code 2 of 5 Message Length..............................7-12

Matrix 2 of 5........................................................................ 7-12

Matrix 2 of 5 Message Length......................................7-13

Code 11 ............................................................................... 7-13

Check Digits Required.................................................. 7-13

Code 11 Message Length ............................................. 7-14

Code 128 ............................................................................. 7-14

ISBT 128 Concatenation ..............................................7-15

Code 128 Message Length ........................................... 7-15

Telepen................................................................................ 7-16

Telepen Output ............................................................. 7-16

Telepen Message Length .............................................. 7-16

UPC A ................................................................................. 7-17

UPC A Check Digit ...................................................... 7-17

UPC A Number System................................................7-17

UPC A Addenda ........................................................... 7-18

UPC A Addenda Required ...........................................7-18

UPC A Addenda Separator........................................... 7-18

UPC-A/EAN-13 with Extended Coupon Code................... 7-19

UPC E0 and UPC E1........................................................... 7-19

UPC E0 and UPC E1 Expand.......................................7-20

UPC E0 and UPC E1 Addenda Required.....................7-20

UPC E0 and UPC E1 Addenda Separator ....................7-20

UPC E0 Check Digit.....................................................7-21

UPC E0 Number System ..............................................7-21

UPC E0 Addenda..........................................................7-21

EAN/JAN 13 .......................................................................7-22

EAN/JAN 13 Check Digit ............................................7-22

EAN/JAN 13 Addenda .................................................7-22

EAN/JAN 13 Addenda Required..................................7-23

EAN/JAN 13 Addenda Separator .................................7-23

ISBN Translate .............................................................7-23

EAN/JAN 8 .........................................................................7-24

EAN/JAN 8 Check Digit ..............................................7-24

EAN/JAN 8 Addenda ...................................................7-24

EAN/JAN 8 Addenda Required....................................7-25

EAN/JAN 8 Addenda Separator ...................................7-25

MSI......................................................................................7-25

MSI Check Character....................................................7-26

MSI Message Length....................................................7-26

Plessey Code........................................................................7-27

Plessey Message Length ...............................................7-27

RSS Limited ........................................................................7-28

RSS Expanded.....................................................................7-29

RSS Expanded Message Length ...................................7-29

China Post Code ..................................................................7-29

Korea Post Code..................................................................7-30

Korea Post Message Length .........................................7-31

PosiCode A and B ...............................................................7-31

PosiCode Message Length............................................7-32

Codablock F ........................................................................7-33

Codablock F Message Length.......................................7-33

Code 16K.............................................................................7-34

Code 16K Message Length...........................................7-34

Code 49................................................................................7-34

Code 49 Message Length..............................................7-35

Chapter 8 - Interface Keys

Keyboard Function Relationships .........................................8-1

Supported Interface Keys ......................................................8-3

Chapter 9 - Utilities

To Add a Test Code I.D. Prefix to All Symbologies ............ 9-1

Show Software Revision ....................................................... 9-1

Show Data Format................................................................. 9-1

Resetting the Standard Product Defaults...............................9-1

Temporary Visual Menu Configuration................................9-2

Chapter 10 - Serial Programming Commands

Conventions......................................................................... 10-1

Menu Command Syntax......................................................10-1

Query Commands ......................................................... 10-2

Concatenation of Multiple Commands......................... 10-2

Responses ..................................................................... 10-2

Examples of Query Commands.................................... 10-3

Trigger Commands.............................................................. 10-4

Resetting the Standard Product Defaults.............................10-4

Menu Commands ................................................................ 10-5

Chapter 11 - Product Specifications

IMAGETEAM 5600 Product Specifications ...................... 11-1

Depth of Field ..................................................................... 11-2

Standard Cable Pinouts ....................................................... 11-3

Chapter 12 - Maintenance

Repairs................................................................................. 12-1

Maintenance ........................................................................ 12-1

Cleaning the Scanner’s Window .................................. 12-1

Inspecting Cords and Connectors.................................12-1

Replacing the Interface Cable.......................................12-2

Troubleshooting ..................................................................12-2

Chapter 13 - Customer Support

Obtaining Factory Service...................................................13-1

Indice

Altri manuali HHP Lettore di codici a barre

HHP

HHP Scanteam 4800 Manuale utente

Manuali Lettore di codici a barre popolari di altre marche

POSMicro

POSMicro Datalogic PowerScan D7100 Manuale utente

Marson

Marson MT780 Guida rapida alla configurazione

NCR

NCR RealPOS Manuale utente

Motorola

Motorola SE3300 Guida rapida alla configurazione

Element

Element P130BT Manuale utente

Motorola

Motorola Symbol LS3008 Manuale di installazione e funzionamento

Meec tools

Meec tools OBD-II / VAG Manuale utente

SICK

SICK CLP 100 Manuale utente

Royal Tag SA

Royal Tag SA I-Read Manuale utente

Welch Allyn

Welch Allyn IMAGETEAM 3800 Manuale utente

Meteor

Meteor 8310 Manuale utente

Denso

Denso BHT-500B Manuale utente

Datalogic

Datalogic Heron HD3130 Manuale utente

Motorola

Motorola MP6000 Istruzioni di montaggio

Newland

Newland NLS-HR15-BT Manuale utente

ARTDEV

ARTDEV AS-1310 Manuale utente

Aopos

Aopos AS290 Manuale utente

ENS

ENS 367-5455 Manuale utente