HomeAware HA360BR Istruzioni per il montaggio
INSTALLATION AND SET UP FOR HOMEAWARE™
HA360BR – Basic Receiver
The HomeAware™ HA360BR Basic Receiver will alert
you to (DOOR, BABY, PHONE, FIRE etc.) with its 5
flashing bright LED’s lights and an icon that will light up,
corresponding with the alert.
Battery Backup Installation
Install (3) 1.5 volt AA alkaline batteries into the battery
compartment located on the back of the unit. Battery
backup will provide power when a power outage has
occurred. Power will be provided for a continuous
outage lasting 7 days, or for short outages up to two
years.
When the BATT icon on the display lights up it is
indicating that the batteries are low and you need to
replace them.
Link Button Set Up
This procedure will link the HA360BR – Basic Receiver
to your HA360M Main unit. The Main unit will also
provide an alert to all HomeAware™ remote receivers.
When using the Bridge unit HA360BU all original Sonic
Alert receivers (SA101, SA201, BL300, and SB1000)
will also alert you.
It is best to do the link procedure in the same room with
the HomeAware™ Main unit, and to make sure the unit
is plugged in.
To link an HA360BR Basic Receiver to your
HomeAware™ Main unit:
1. Press set up button on the Main unit and
the word LINK will be shown on the
display, press Enter. LINK will begin
blinking. (If LINK mode is entered by
accident, simply press the BACK button
to exit and return to the clock.)
2. Press the link button on the side of your
basic receiver (see diagram below) and
the LINK icon on from of unit will light up
3. Upon successful connection, the 5 bright
LEDs will flash three times.
FCC Requirements
This device complies with part 15 of the FCC
rules. Operation is subject to the following two
conditions; (1) This device might not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired operation.
HA360BR Basic Receiver UG Rev 3.pdf 1 11/10/2015 4:36:40 PM
INSTALLATION AND SET UP FOR HOMEAWARE™\
HA360BR – Basic Receiver
FCC Requirements (Continued)
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC rules. These limits are
designed to provide responsible protect against harmful
interference in a residential installation. This
equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions manual, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will
not interfere in a particular installation. If this equipment
does cause harmful interference to radio or television
reception, which can be determined by turning the
equipment on and off, the user is encouraged to try to
correct the interference by one or more of the following
measures:
i. Reorient or relocate the receiving antenna.
ii. Increase the separation between the
equipment and receiver.
iii. Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
iv. Consult the dealer or and experienced radio
/TV technician for help
Modification not expressly approved by the
manufacturer could void the user’s authority to operate
the equipment under FCC rules.
GENERAL DATA
UL listed Power Adaptor: AC100-240V~, 50/60Hz
Power Consumption: Adaptor Output: DC6V, 800mA
The Lightening
flash and
arrowhead within
the triangle is a
warning sign
alerting you of
dangerous voltage
inside the product.
CAUTION:
TO REDUCE
THE RISK
OF ELECTRICAL
SHOCK, DO
NOT
REMOVE THE
COVER
(OR BACK)
FROM THE
PRODUCT. NO
USER
SERVICEABLE
PARTS
INSIDE. REFER
SERVICING TO
YOUR SONIC
ALERT DEALER.
The exclamation
mark within the
triangle is a
warning sign
alerting you of
important
instructions
accompanying
the product.
WARNING: TO PREVENT FIRE OR SHOCK
HAZARD, DO NOT EXPOSE THIS APPLIANCE TO
RAIN OR MOISTURE.
The normal function of the product may be
disturbed by Strong Electro Magnetic Interference.
If so, simply reset the product to resume normal
operation by following the instruction manual. In
case the function could not resume, please use the
product in other location.
– Attention should be drawn to the environmental
aspects of battery disposal.
– T This indicating separate collection for
electrical and electronic equipment.
SONIC ALERT’S 1 YEAR LIMITED WARRANTY
The HomeAware™ HA360BR are warranted against
manufacturing defects in materials and workmanship
for one (1) year from the date of purchase. Within
this period Sonic Alert will repair or replace at our
option the HomeAware™ HA360BR without charge
for parts and labor.
Simply contact our customer service
department to obtain an RA (return
authorization number) and instructions on how
to process your product for return. Call 1-888-
864-2446 or e-mail to RMA@sonicalert.info.
You’ll need a copy of your receipt to process
the return authorization.
Sonic Alert Warranty Center
1081 West Innovation Dr. Kearney, MO 64060,
USA.
Made in China
Sonic Alert, Troy, MI 48083
www.SonicAlert.com 1-888-864-244
HA360BR Basic Receiver UG Rev 3.pdf 2 11/10/2015 4:36:40 PM
Altri manuali HomeAware Ricevitore
