HomeSeer | 10 Commerce Park North, Unit 10 | Bedford, NH 03110 | HomeSeer.com | Doc: HS-CAM-O-en-v3.0
HS-CAM-O Outdoor IP Camera
OVERVIEW
The HS-CAM-O is an IP camera designed to be installed outdoors and help you keep tabs on your home. The video feed is
1080P (1920x1080) for clear, easily viewable video feeds to keep tabs on your home.
Installaon in HomeSeer
The HS-CAM-O is added to the HomeSeer HS3 soware via the HomeSeer Mobile app, available on Android and iOS. If you are
not using the HomeSeer HS3 soware, please review the “Installaon without a HomeSeer system” secon on page 2. It is not
recommended to ax the camera to any surface before it has been added to HomeSeer. The HS-CAM-O can be added via WiFi
or Ethernet.
1. Use the provided power supply to power on the HS-CAM-O, then wait 30 seconds for the camera to nish boong up. The
green LED on the Ethernet connecon cable will go from solid to a steady blink once it is fully booted up. NOTE: If using Wi-
Fi, aach the included antenna to the screw terminal on the back of the camera. NOTE: If using an Ethernet connecon, DO
NOT insert the cable unl instructed to. Otherwise you will need to factory reset the camera.
2. Open the HomeSeer Mobile app on your Android or iOS device, then navigate to the Cameras secon, found in the boom
right corner.
3. Tap the Add Camera buon in the top right corner to start the inclusion process for the HS-CAM-O.
4. The app will ask which model of camera is being added, select HS-CAM-O. Next, select whether the camera will use Wi-Fi or
an Ethernet connecon.
5. Give the camera a display name, click connue. The username and password will automacally be populated. These are
printed on the boom of the camera as well. When ready, click connue.
6. Enter a new secure admin password to prevent unauthorized access to your camera.
7. WIFI: Advancing to the next screen will prompt you to press and hold the reset buon for 3 seconds unl the green light on
the cable turns o. Click connue, a QR code which the HS-CAM-O will read and use to connect to Wi-Fi will be displayed
on the screen.
ETHERNET: Advancing to the next screen will prompt you to conrm that the camera is powered and the light on the Ether-
net port is blinking, click Connue.
8. WIFI: Then hold the screen directly in front of the camera so that the lens is in the center of the QR code. Slowly move the
mobile device away unl it is ~10 inches (25cm) from the lens. If the QR code is not being seen, Increase the brightness of
the mobile device to max and try again.
ETHERNET: Connect the Ethernet cable to the camera.
Note: When using Android devices, HomeSeer Mobile will request locaons permissions in order to send informaon
about your home Wi-Fi network to your camera. Your locaon data is not being tracked or stored by HomeSeer.
Requirements
HomeSeer: 3.0.0.548 or later | HomeSeer Mobile: Android— 1.1.0 or later iOS— 1.1.6 or later
Auto Discover Supported Cameras is checked in HS (Tools->Setup->Cameras).
HomeSeer Mobile must be connected via an Admin or Admin+Local account.
