Honeywell Excel 15 W7760A Manuale utente

Excel 15 W7760A

EPROM REPLACEMENT

DESCRIPTION 5. Remove galvanized plate. Place on adjacent work

This EPROM Replacement procedure outlines the surface in the orientation as it was removed

process to upgrade the Excel 15 W7760A Controller to

the latest firmware release.

Firmware replacement kit: Part # 32004159-002 Plate

Procedure will apply to future firmware as released. Work Surface

Material Needed

1. Replacement EPROM. Programmed with new Firmware Side View

2. #10 Tork Driver (preferred), or 3/16" thin flat-blade

screwdriver 6. Set aside paper protective sheet, then remove 2 screws

that secure board to cover.

3. Extraction Tool: AMP PLCC Extraction Tool 821903-50

00, AMP 822154-1 00, or small diameter probe/object

(i.e. paper clip)

Procedure

1. Discharge static electricity form body by touching known

earth ground. 7. Making certain you are grounded. Remove the circuit

2. Remove W7760A from wiring subbase. Place controller board and place it component side up, pin side down on

on work surface with pins and label side up. top of the galvanized plate. Extend pins over the edge

on each side of the galvanized plate.

3. Remove plastic, anti-static sheet. (This sheet contains

device information) – Set aside.

Caution: Do not tear plastic protective sheet at

corners.

oard

Plate

4. Using the #10 Tork Driver or flat-bladed screwdriver

remove the four screws around perimeter. Put the

screws aside in a secure place for later re-assembly. Work Surface

Side View

®U.S. Registered Trademark

95- 7631

Excel 15 W7760A EPROM Replacement

REPLACEMENT

PROM

Note: Orient the board with heat sink to

left. The EPROM to be replaced is the

socketed component located closest to

the component labeled Echelon Heat Sink

Home and Building Control Home and Building Control Home and Building Control Products

Honeywell Inc. Honeywell Limited-Honeywell Limitee Honeywell AG

Honeywell Plaza 155 Gordon Baker Road Böblinger Straße 17

P.O. Box 524 North York Ontario D-71101 Schönaich

Minneapolis, MN 55408-0524 M2H 3N7 Phone (49-7031) 637-01

Fax (49-7031) 637-493

Echelon

Jack

8. Insert the tips of the Extraction Tool in the diagonal slots of the micro socket, and slowly remove the EPROM with a

rocking motion.

9. Again, making certain you are grounded, insert the new EPROM into the socket, orienting the notch in the chip with the

notch in the socket in the lower right hand corner. The EPROM may be inserted into the socket by placing it on top of the

socket and pressing it into place with thumb pressure until it is seated. While pressing the EPROM into the socket, keep

another finger on the rear of the circuit board behind the socket so the board is not stressed while pressing with the thumb.

10. Turn the circuit board upside down again and orient it on the cover. Replace the two center screws.

11. Replace the protective paper and the galvanized plate. Replace the 4 screws in each corner.

12. Replace the labeled plastic sheet.

13. Keep EPROM in a safe place until system operation has been confirmed.

14. Make a record of the W7760A as being updated. It is good idea to make a mark on the controller to that effect as well.

15. Reinstall the W7760A.

Printed in U.S.A. on recycled

paper containing at least 10%

95-7631 D.B. 12-99

post-consumer paper fibers.

www.honeywell.com

Altri manuali Honeywell Controllori

Honeywell

Honeywell Touchpoint Plus Nota di rilascio

Honeywell

Honeywell R7284B Manuale utente

Honeywell

Honeywell S8600B Manuale utente

Honeywell

Honeywell Centra Line EAGLE Manuale di installazione e funzionamento

Honeywell

Honeywell UDC100 Manuale utente

Honeywell

Honeywell PRESSURETROL L404F Manuale operativo

Honeywell

Honeywell UDC2800 Manuale utente

Honeywell

Honeywell Spyder 5 WEB-RxxN Series Manuale utente

Honeywell

Honeywell HCE80R Manuale utente

Honeywell

Honeywell ML7984B Manuale utente

Honeywell

Honeywell WEB/CP-202-XPR Manuale utente

Honeywell

Honeywell 7800 SERIES RM7895A Manuale utente

Honeywell

Honeywell PP904A Manuale utente

Honeywell

Honeywell Aquastat L4006 Manuale utente

Honeywell

Honeywell SLATE Manuale utente

Honeywell

Honeywell S05 Series Manuale operativo

Honeywell

Honeywell 191238-ZCS Manuale operativo

Honeywell

Honeywell WEB-600E Manuale utente

Honeywell

Honeywell ML7999C Manuale operativo

Honeywell

Honeywell SLATE Series Manuale utente

Honeywell

Honeywell T775 Series Guida utente

Honeywell

Honeywell UDC3500 Manuale utente

Honeywell

Honeywell Elster Jeavons J125 Manuale utente

Honeywell

Honeywell UDC 6300 Guida

Manuali Controllori popolari di altre marche

Digiplex

Digiplex DGP-848 Istruzioni operative

YASKAWA

YASKAWA SGM series Manuale utente

Sinope

Sinope Calypso RM3500ZB Manuale utente

Isimet

Isimet DLA Series Style 2 Manuale di installazione

LSIS

LSIS sv-ip5a Manuale utente

Rockwell Automation

Rockwell Automation 1769-L31 Manuale utente

Airflow

Airflow Uno hab Manuale utente

ABB

ABB ACS580-01 drives Manuale utente

Panasonic

Panasonic GM1 Series Manuale utente

Emerson

Emerson SW93 Manuale utente

AutoAqua

AutoAqua Smart ATO micro SATO-120P Manuale utente

Panasonic

Panasonic FP? Positioning Unit RTEX Manuale utente

Samson

Samson Type 5824 Manuale di servizio

Alpha IP

Alpha IP MIOB 21001 Manuale utente

Siemens

Siemens OpenAir GMA 1 Series Manuale utente

Surecom

Surecom SR-629 Manuale utente

Fishman

Fishman TriplePlay Manuale utente

Regulus

Regulus SRS1 T Manuale utente