SCHED HOLD CLOCK SCREEN MORE
7 8 9
MON TUE WED THU FRI SAT
Following
Schedule
OK TO PICK MULTIPLE DAYS
SUN
FAN
AUTO
SYSTEM
HEAT
Inside Set To
AM
1
2
10
3
4
5
6
Quick Reference for your
Honeywell touchscreen programmable thermostat
1Temperature warmer
2Temperature cooler
3Press day(s) to set program schedule
4Press to select fan operation
5Press to select system type
6Press to select program schedule
7Press to override program schedule
8Press to set clock
9Press to lock keypad for 30 secs to clean screen
10 Press for more options (select models only)
OVER
This thermostat is ready to go!
Your new thermostat is pre-programmed and ready to go.
Just set the time and day. Then check the settings below
and change if needed:
Clock setting
To set the current time display, press CLOCK,
then press or to adjust the time. Press and hold
or to advance the time more quickly.
Press DONE to save & exit (or press CANCEL
to exit without changing the time).
Note: The real-time clock should never require
adjustment since it automatically updates for
daylight savings time, and stores all date/time
information.
System setting
Press the SYSTEM button to select, then press DONE.
• Heat: Thermostat controls only the heating system.
• Cool: Thermostat controls only the cooling system.
• Off: Heating and cooling systems are off.
• Auto: Thermostat automatically selects heating or
cooling depending on the indoor temperature.**
• Em Heat (only for heat pumps with auxiliary heat):
Thermostat controls Emergency and Auxiliary Heat.
Compressor is locked out.**
** Select models only
Fan setting
Press FAN to select fan operation, then press DONE.
• On: Fan is always on.
• Auto: Fan runs only when the heating or cooling
system is on.
• Circ: Fan runs randomly, about 35% of the time, not
counting any run time with the heating or cooling
system.
You can press FAN to override the fan settings you’ve
programmed for different time periods. If you select On
or Circ, the setting you select will remain active until
you press FAN again to select Auto.
Battery replacement
Batteries are optional (to provide backup power)
if your thermostat was wired to run on AC power
when installed.
Install fresh batteries immediately when the LO
BATT warning begins flashing. The warning
flashes about 30 days before batteries are depleted.
Even if the warning does not appear, you should
replace batteries once a year, or before leaving
home for more than a month.
