HP X27c Manuale
Maintenance and Service Guide
X27c model
SUMMARY
This guide provides information about spare parts, removal and replacement of parts, diagnostic tests, problem
troubleshooting, and more.
© Copyright 2022 HP Development
Company, L.P.
AMD is a trademark of Advanced Micro
Devices, Inc. Bluetooth is a trademark
owned by its proprietor and used by HP
Inc. under license. NVIDIA is a trademark
and/or registered trademark of NVIDIA
Corporation in the U.S. and other
countries. USB Type-C and USB-C are
registered trademarks of USB
Implementers Forum. DisplayPort and the
DisplayPort logo are trademarks owned
by the Video Electronics Standards
Association (VESA) in the United States
and other countries.
The information contained herein is
subject to change without notice. The
only warranties for HP products and
services are set forth in the express
warranty statements accompanying such
products and services. Nothing herein
should be construed as constituting an
additional warranty. HP shall not be liable
for technical or editorial errors or
omissions contained herein.
First Edition: March 2022
Document Part Number: M45867-X27c-
MSG-V1
Assembly part number: M45867-001
Product notice
Only trained service personnel familiar with
this product should service it. Before
performing any maintenance or service, be
sure to read “Important Safety Information”.
1
Table of Contents
1 Getting started...............................................................................................................................................2
Important safety information...................................................................................................................2
Important service information and precautions.......................................................................................2
RoHS (2002/95/EC) requirements..........................................................................................................3
General descriptions...............................................................................................................................3
Firmware updates...................................................................................................................................3
Before returning the repaired product to the customer...........................................................................3
2 Monitor features............................................................................................................................................4
Features..................................................................................................................................................4
Front components...................................................................................................................................5
Rear components....................................................................................................................................6
Locating the serial number and product number....................................................................................7
3 Illustrated parts catalog.................................................................................................................................8
How to order parts ..................................................................................................................................9
4 Removal and replacement procedures.......................................................................................................11
Preparation for disassembly.................................................................................................................11
Rear Cover............................................................................................................................................11
Power board..........................................................................................................................................14
Connector repair...................................................................................................................................15
HDMI connector CN501.............................................................................................................16
DP connector CN551.................................................................................................................16
Audio Connector CN601............................................................................................................17
Function test .........................................................................................................................................18
Support and troubleshooting.................................................................................................................18
Index.....................................................................................................................................................20
2
1 Getting started
Read this chapter to learn about safety information and where to find additional HP resources.
Important safety information
Carefully read the cautions and notes within this document to minimize the risk of personal injury to
service personnel. The cautions and notes are not exhaustive. Proper service methods are important to
the safe, reliable operation of equipment. Improper service methods can damage equipment.
The service procedures recommended and described in this service manual provide effective methods of
performing service operations. Service engineers should have prior repair knowledge and experience as
well as appropriate training for the product before performing service procedures.
●Be sure your working environment is dry and clean and meets all government safety
requirements.
●Be sure that other persons are safe while you are servicing the product.
●Do not perform any action that can cause a hazard to the customer or make the product unsafe.
●Use proper safety devices to ensure your personal safety.
●Always use approved tools and test equipment for servicing.
●Never assume the product’s power is disconnected from the main power supply. Check that it
is disconnected before opening the product’s cabinet.
●Modules containing electrical components are sensitive to electrostatic discharge (ESD).
Follow ESD safety procedures while handling these parts.
●Some products contain more than one battery. Do not disassemble or expose a battery to high
temperatures, such as throwing into fire, or the battery may explode.
●Refer to government requirements for battery recycling or disposal.
This information provides general service information for the monitor. Adherence to the
procedures and precautions is essential for proper service.
IMPORTANT: Only trained service personnelwho are familiar with this HPproduct should perform service
or maintenance for it.Beforeperforming any service or maintenance, personnelmust read the important
safety information.
IMPORTANT: You must disconnect the power cord from the power source before opening the monitor
to prevent component damage.
Important service information and precautions
●Repair must be performed by professional service technicians in a repair center. End users
should not perform these procedures.
●Please note during servicing that the primary side is the high voltage area.
●This monitor meets ROHS requirements. Be sure to use lead-free solder wire when soldering.
●If you must change a capacitor, be sure to match the polarity as printed on the PCB.
●If you must replace a capacitor, make sure the specification and part number match the BOM
and location.
●If you must replace a capacitor, insert new parts carefully to avoid a short circuit caused by the
3
near pin.
●Do not get the board wet. Water and moisture can cause a short circuit that causes
malfunctions.
●To avoid damage, be sure to use lead-free solder.
●When soldering, work quickly to avoid overheating the circuit board.
●Keep the soldering iron tip clean and well tinned when replacing parts.
●After repair, perform a close inspection of the circuit board to confirm it is in good condition.
●After repair, perform a function test to confirm the power supply is working properly.
ERP Lot5 requirement
1. A professional repairer must have the technical competence to repair electronic displays and
comply with the applicable regulations for repairers of electrical equipment in the Member States
where the repairer operates. Reference to an official registration system as professional repairer,
where such a system exists in the Member States, shall be accepted as proof of compliance.
2. A professional repairer must have insurance that covers liabilities resulting from repairs,
regardless of whether required by the Member State.
RoHS (2002/95/EC) requirements
Applied to all countries that require RoHS.
The RoHS (Restriction of Hazardous Substance in Electrical and Electronic Equipment Directive) is a
legal requirement by the EU (European Union) for the global electronics industry sold in the EU and
other countries. Any electrical and electronics products launched in the market after June 2006 should
meet this RoHS requirement. Products launched in the market before June 2006 are not required to be
compliant with RoHS parts. If the original parts are not RoHS complaint, the replacement parts can be
non-ROHS complaint. If the original parts are RoHS compliant, the replacement parts MUST be RoHS
complaint.
If product service or maintenance requires replacing parts, confirm the RoHS requirement before
replacement.
General descriptions
This manual contains general information. There are two levels of service:
Level 1: Cosmetic/appearance/alignment service
Level 2: Circuit board or standard parts replacement
Firmware updates
Firmware updates for the monitor are available at support.hp.com. If no firmware is posted, the monitor
does not need a firmware update.
Before returning the repaired product to the customer
Perform an AC leakage current check on exposed metallic parts to be sure the product is safe to
operate without the potential of electrical shock. Do not use a line isolation transformer during this
check.
Measurements that are not within specified limits present a possible shock hazard. You must check and
repair the product before returning it to the customer.
4
2 Monitor features
This chapter provides an overview of the monitor’s features.
Features
Depending on the model, your monitor might include the following features:
●68,6 cm(27in) curved 1500mm radius with 2560x1440 resolution, ultra-wide backlit display,
plus full-screen support for lower resolutions
●Antiglare panel with an LEDbacklight
●Wide viewing angle to allow viewing from a sitting or standing position, or moving from side to
side
●Tilt adjustment capability
●Height adjustment capability
●DisplayPort (DP) video input
●High-Definition MultimediaInterface(HDMI) video input (cable provided)
●Audio-out (headphone)jack
●Plug and Play capability,ifsupported byyouroperatingsystem
●Security cable slot provision onrearof monitor for optional securitycable
●On-screen display (OSD) adjustments in several languages for easy setupandscreen optimization
●High-bandwidth Digital Content Protection (HDCP) copy protection on all digital inputs
●VESA mountingbracket for attaching the monitor to a wall-mount device or swing arm
●Low blue light modesettings to create a more relaxing and less stimulating image
●Energysaver feature to meetrequirements for reduced power consumption
NOTE: For safety and regulatory information, refer to the Product Notices provided in your
documentation kit. To access the latest user guides or manuals for your product, go to
http://www.hp.com/support and follow the instructions to find your product. Then select Manuals.
5
Front components
To identify the components on the front of the monitor, use this illustration and table.
Table 1-1: Front components and their descriptions
Component
Function
1
Menu/OK
If the OSD menu is open, press to confirm
selection.
If the OSD menu is closed, press to open the
OSD menu.
2
Next Active
Input/Up/Increase
button
If the OSD menu is close, switches the
monitor’s input source to the next active input.
If the OSD menu is close, press to open the
information menu at HDMI, or to perform auto
adjustment at VGA.*
3
Color Modes/Down/Decre
ase button
If the OSD menu is close, opens the Color
menu where you can adjust the monitor screen
to a comfortable
If the OSD menu is open, press to navigate
forward through the OSD menu and decrease
adjustment levels.
4
Brightness+
Input/Exit/Back
button
If the OSD menu is close, opens the
Brightness+ adjustment scale.
If the OSD menu is closed, press to switch to
the next video input port.*
5
Power button
Turns the monitor on or off.
6
Rear components
To identify the components on the rear of the monitor, use this illustration and table.
Table 1-2: Rear components and their descriptions
Component
Function
1
Power connector
Connects the power cord
2
HDMI port
Connects an HDMI cable from the monitor to a
source device such as a computer.
3
DisplayPort in connector
Connects the DisplayPort cable from the
monitor to a source device such as a
computer.
4
Headphone jack
Connect the headphone to the monitor.
7
Locating the serial number and product number
The SPEC label is located on the rear of the monitor. The serial number and product number are
located on a Safety label. You may need these numbers when contacting HP about the monitor model.
For worldwide models (except India):
Spec label
8
3 Illustrated parts catalog
To identify the monitor major components, use this illustration and table.
1
2
3
4
9
10
11
S1
S7
S6
5
67
8
12
13
S2
S3
S5
S4
Item
Description
Qty
1
DECO_BEZEL L27WR-Dblc1hp-p12
1
2
LENS_POWER
1
3
PANEL
1
4
MIDDLE_FRAME L27WR-Dblc1hp-p12
1
5
INSULATING SHEET 34.1*17
1
6
POWER BOARD
1
7
MAIN BOARD
1
8
MAINFRAME
1
9
KEY BOARD
1
10
LED BOARD
1
11
REAR_COVER
1
12
stand ass'y NA NA
1
13
BASE_ASS’Y NA NA
1
S1
0M1G3030 4120
9
S2
0D1G1030 6120
4
Indice
Altri manuali HP Monitor
HP
HP LP2480zx - DreamColor - 24" LCD Monitor Scheda tecnica
HP
HP EliteDisplay E231 Istruzioni utente
HP
HP L1710 Manuale utente
HP
HP Z32 Manuale
HP
HP P22va G4 Manuale
HP
HP D8901A - 71 - 17" CRT Display Guida di riferimento
HP
HP OMEN 25i FHD Gaming Manuale utente
HP
HP Compaq LA2206xc Manuale utente
HP
HP HP ZR2040w Manuale utente
HP
HP KD911A4 Istruzioni utente
HP
HP L1906 Istruzioni utente
HP
HP Compaq LA22f Manuale utente
HP
HP HP M32f Manuale
HP
HP LD4312 Istruzioni per l'installazione
HP
HP f1905 Manuale utente
HP
HP EliteOne 1000 G1 Istruzioni per l'installazione
HP
HP GS917AA Istruzioni utente
HP
HP L2035 Istruzioni utente
HP
HP MX703 - Pavilion - 17" CRT Display Manuale utente
HP
HP 55HP Manuale utente
