HP StorageWorks 2000fc Guida

Page 1

481596-001

About this document

The chassis field replacement unit (FRU) replaces a chassis that has

been damaged or whose midplane has been damaged. To make a

fully functional chassis, you must install the following components

from the replaced chassis:

•Drive modules and air management modules

•Two power-and-cooling modules

•One or two controller modules (for a controller enclosure)

•One or two I/O modules (for a drive enclosure)

This document details procedures for removing drive modules/air

management modules, power-and cooling-modules, controller

modules, and I/O modules from the failed chassis and installing

them into the replacement chassis of an HP StorageWorks 2000

Family Modular Smart Array.

NOTE: Make sure you obtain the latest version of these

instructions from http://www.hp.com/go/msa. Select MSA SAN

Arrays, select your product, and go to Support.

Before you begin

•Turn the power-and-cooling supply modules off and disconnect

the power cables.

•Disconnect and label all cables.

CAUTION: Parts can be damaged by electrostatic discharge.

Use proper anti-static protection:

•Keep the replacement component in the ESD bag until needed.

•Wear an ESD wrist strap grounded to an unpainted surface of

the chassis.

•If an ESD wrist strap is unavailable, touch an unpainted surface

of the chassis before handling the component.

•Never touch connector pins.

Removing drive modules

NOTE: Air management modules are removed and installed

using the same procedure as removing and installing drive modules.

Printed on at least 50% total recycled fiber with at least 10%

post-consumer paper

First edition: March 2008

Product names mentioned herein may be trademarks of their

respective companies as reflected by an associated footnote. The

information in this document is subject to change without notice.

Printed in the US.

www.hp.com

HP StorageWorks

2000 Family Modular Smart

Array

chassis and midplane

replacement instructions

Page 2

1. Press and slide the release latch button to the right to disengage

the latch.

2. Pull the latch out toward the left to disengage the drive module

from the enclosure’s internal connector.

3. Wait 20 seconds for the internal disks to stop spinning, and pull

the drive module out of the enclosure.

Installing drive modules

1. Push the release latch button to the right to open the locking

mechanism.

2. Slide the drive module into the drive slot as far as it will go.

Removing power-and-cooling modules

1. Turn the thumbscrew (1) until it is disengaged from the

power-and-cooling module.

2. Rotate the latch (2) downward to disconnect the power module

from the internal connector, and slide it out from the slot (3).

Installing power-and-cooling modules

1. Slide the power-and-cooling module into the slot as far as it will

go.

2. Press the latch upward to engage the power-and-cooling module;

turn the thumbscrews finger-tight.

Removing controller modules

1. Turn the thumbscrews (2) until the screws disengage from the

controller.

1Release latch button

1Thumbscrew 2Latch

1Latch 2Thumbscrew

12 1 2

Page 3

2. Press both latches downward to disconnect the module from the

midplane.

3. Pull outward on the latches to slide the module out of the

enclosure.

Installing controller modules

1. Loosen the controller’s thumbscrews; press the latches downward.

2. Slide the controller into the enclosure as far as it will go (1).

3. Press the latches upward to engage the controller (2); turn the

thumbscrews finger-tight.

Removing I/O modules

1. Turn the thumbscrews (2) until the screws disengage from the I/O

module.

2. Press both latches downward to disconnect the I/O module from

the midplane.

3. Pull outward on the latches to slide the I/O module out of the

enclosure.

1Latch 2Thumbscrew

Service

12 1 2

Service

Page 4

Installing I/O modules

1. Loosen the controller’s thumbscrews; press the latches downward.

2. Slide the I/O module into the enclosure as far as it will go (1).

3. Press the latches upward to engage the I/O module (2); turn the

thumbscrews finger-tight.

Verifying component installation

•Reconnect cables and power on the system and associated data

host in the following order:

a. Drive enclosure first

b. Controller enclosure next

c. Data host last

•On the power-and-cooling modules, check that the AC Power

Good LED (top) is on.

•On the controller and I/O modules, check that the OK LED

(back) illuminates green, indicating that the module has

completed initializing and is online.

Additional information

See the MSA web site: http://www.hp.com/go/msa.

Service

Altri manuali per StorageWorks 2000fc

Questo manuale è adatto per i seguenti modelli

Indice

Altri manuali HP Magazzinaggio

HP Ultrium 230e Manuale utente

HP Surestore 6164 - Switch Manuale utente

HP AutoRAID 12H Guida di riferimento rapido

HP Q153090901 Manuale del prodotto

HP STORAGEWORKS ALL-IN-ONE STORAGE SYSTEM Manuale utente

HP 9840 Manuale utente

HP StoreEasy 1X60 Series Manuale utente

HP P9000 Manuale utente

HP Surestore Disk Array 12h - And FC60 Istruzioni per il montaggio

HP Surestore DLT 80 Manuale utente

HP C6388B Manuale utente

HP StorageWorks 400r All-in-One Istruzioni utente

HP StorageWorks ESL E-Series Manuale utente

HP 3PAR StoreServ 7200 2-node Manuale utente

HP D2D Manuale utente

HP DW017B - StorageWorks Ultrium 448 Tape Drive Manuale utente

HP StorageWorks 8000 - NAS Manuale utente

HP StorageWorks 4000/6000/8000 - Enterprise Virtual... Manuale di istruzioni

HP StoreEver Series Manuale utente

HP Surestore Disk Array 12h - And FC60 Manuale utente

HP AD510A - StorageWorks Modular Smart Array 1500 cs 2U Fibre Channel SAN Attach Controller Shelf Hard... Guida

HP STORAGEWORKS XP24000 Manuale utente

HP AD510A - StorageWorks Modular Smart Array 1500 cs 2U Fibre Channel SAN Attach Controller Shelf Hard... Manuale utente

HP StoreOnce B6000 Manuale utente

Manuali Magazzinaggio popolari di altre marche

QNAP

QNAP TS 32PXU Series Manuale utente

LaCie

LaCie RUGGED RAID Manuale utente

Freecom

Freecom CLS DOCK Manuale utente

PNY

PNY Attache P-FD64MBATT3 Manuale utente

OLT

OLT 6x6 Maximizer Manuale utente

Transcend

Transcend JetFlash 160 Manuale utente

LaCie

LaCie RUGGED MINI Manuale utente

Thunderbolt

Thunderbolt 600 Manuale utente

Panasonic

Panasonic LB-DH8 series Manuale

Intel

Intel RAID High Availability Manuale utente

LaCie

LaCie 12big Thunderbolt 3 Manuale utente

Spectra Logic

Spectra Logic T-Series Spectra T50e Manuale utente

Panasonic

Panasonic LKM-F931-1 Manuale utente

Tabernus

Tabernus Enterprise Erase E2400 Manuale utente

Rocstor

Rocstor COMMANDER 3F series Manuale utente

Western Digital

Western Digital Ultrastar Data60 Manuale utente

Dell

Dell PowerVault MD3600f Series Manuale utente

CFI

CFI TERA STOR SATA RAID IV Manuale utente