IBASE Technology IBR210 Manuale utente
IBR210
3.5” ARM-based SBC
With NXP Cortex™ A53 Quad i.MX8M
User’s Manual
Version 0.3
(May 2020)
ii
IBR210 User’s Manual
Copyright
© 2020 IBASE Technology, Inc. All rights reserved.
No part of this publication may be reproduced, copied, stored in a retrieval
system, translated into any language or transmitted in any form or by any
means, electronic, mechanical, photocopying, or otherwise, without the prior
written consent of IBASE Technology, Inc. (hereinafter referred to as
“IBASE”).
Disclaimer
IBASE reserves the right to make changes and improvements to the
products described in this document without prior notice. Every effort has
been made to ensure the information in the document is correct; however,
IBASE does not guarantee this document is error-free.
IBASE assumes no liability for incidental or consequential damages arising
from misapplication or inability to use the product or the information
contained herein, nor for any infringements of rights of third parties, which
may result from its use.
Trademarks
All the trademarks, registrations and brands mentioned herein are used for
identification purposes only and may be trademarks and/or registered
trademarks of their respective owners.
IBR210 User’s Manual
iii
Compliance
This product conforms to health, safety, and environmental protection
standards for items sold within the European Economic Area (EEA).
This product has been tested and found to comply with the limits for a Class
B device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with manufacturer’s
instructions, may cause harmful interference to radio communications.
WEEE
This product must not be disposed of as normal household
waste, in accordance with the EU directive of for waste
electrical and electronic equipment (WEEE - 2012/19/EU).
Instead, it should be disposed of by returning it to a
municipal recycling collection point. Check local
regulations for disposal of electronic products.
Green IBASE
This product is compliant with the current RoHS
restrictions and prohibits use of the following substances in
concentrations exceeding 0.1% by weight (1000 ppm)
except for cadmium, limited to 0.01% by weight (100 ppm).
• Lead (Pb)
• Mercury (Hg)
• Cadmium (Cd)
• Hexavalent chromium (Cr6+)
• Polybrominated biphenyls (PBB)
• Polybrominated diphenyl ether (PBDE)
iv
IBR210 User’s Manual
Important Safety Information
Carefully read the precautions before using the board.
Environmental conditions:
• Use this product in environments with ambient temperatures between
0˚C and 70˚C. (Industrial grade: -20° C and 85° C)
• Do not leave this product in an environment where the storage
temperature may be below -40° C or above 85° C. To prevent from
damages, the product must be used in a controlled environment.
WARNING
Attention during use:
• Do not use this product near water.
• Do not spill water or any other liquids on this product.
• Do not place heavy objects on the top of this product.
Anti-static precautions
• Wear an anti-static wrist strap to avoid electrostatic discharge.
• Place the PCB on an anti-static kit or mat.
• Hold the edges of PCB when handling.
• Touch the edges of non-metallic components of the product instead of
the surface of the PCB.
• Ground yourself by touching a grounded conductor or a grounded bit of
metal frequently to discharge any static.
CAUTION
Danger of explosion if the internal lithium-ion battery is replaced by an
incorrect type. Replace only with the same or equivalent type recommended
by the manufacturer. Dispose of used batteries according to the
manufacturer’s instructions or recycle them at a local recycling facility or
battery collection point.
IBR210 User’s Manual
v
Warranty Policy
• IBASE standard products:
24-month (2-year) warranty from the date of shipment. If the date of
shipment cannot be ascertained, the product serial numbers can be
used to determine the approximate shipping date.
• 3rd-party parts:
12-month (1-year) warranty from delivery for the 3rd-party parts that are
not manufactured by IBASE, such as CPU, CPU cooler, memory,
storage devices, power adapter, panel and touchscreen.
＊ PRODUCTS, HOWEVER, THAT FAIL DUE TO MISUSE, ACCIDENT,
IMPROPER INSTALLATION OR UNAUTHORIZED REPAIR SHALL
BE TREATED AS OUT OF WARRANTY AND CUSTOMERS SHALL
BE BILLED FOR REPAIR AND SHIPPING CHARGES.
Technical Support & Services
1. Visit the IBASE website at www.ibase.com.tw to find the latest
information about the product.
2. If you need any further assistance from your distributor or sales
representative, prepare the following information of your product and
elaborate upon the problem.
• Product model name
• Product serial number
• Detailed description of the problem
• The error messages in text or in screenshots if there is any
• The arrangement of the peripherals
• Software in use (such as OS and application software, including the
version numbers)
3. If repair service is required, you can download the RMA form at
http://www.ibase.com.tw/english/Supports/RMAService/. Fill out the
form and contact your distributor or sales representative.
vi
IBR210 User’s Manual
Table of Contents
Compliance .................................................................................... iii
Important Safety Information ....................................................... iv
Warranty Policy .............................................................................. v
Technical Support & Services ....................................................... v
Chapter 1 General Information ............................................ 1
1.1 Introduction ............................................................................................ 2
1.2 Features ................................................................................................. 2
1.3 Packing List ........................................................................................... 3
1.4 Specifications ......................................................................................... 4
1.5 Product View .......................................................................................... 6
1.6 Dimensions ............................................................................................ 7
Chapter 2 Hardware Configuration .......................................... 9
2.1 Mini-PCIe & M.2 Card Installation ........................................................ 10
2.2 Setting the Jumpers ............................................................................. 11
2.3 Jumper & Connector Locations on IBR210 ......................................... 12
2.4 Jumpers Quick Reference ................................................................... 13
2.4.1 LVDS Power Setting (P16) ..................................................... 13
2.4.2 LVDS Backlight Power Setting (P15) ..................................... 14
2.5 Connectors Quick Reference ............................................................... 15
2.5.1 RTC Lithium Cell Connector (P2) ........................................... 16
2.5.2 COM RS-232/422/485 Selection (SW3) ................................. 16
2.5.3 COM RS-232/422/485 Port (P20) .......................................... 17
2.5.4 LVDS Display Connector (P13, P14) ..................................... 18
2.5.5 COM RS232 Connector (P19) ................................................ 19
2.5.6 LVDS Backlight Control Connector (P18) .............................. 20
2.5.7 Audio Line-In & Line-Out Connector (P9) ............................... 20
2.5.8 Internal USB3.0 Connector (P7) ............................................. 21
2.5.9 Digital I/O (GPIO) Connector (P24) ........................................ 22
2.5.10 MIPI-CSI Connector (P10, P26) ............................................. 23
2.5.11 MIPI-DSI Connector (P12) ..................................................... 24
2.5.12 I2C Connector (P17) ............................................................... 25
Chapter 3 Software Setup .................................................. 29
IBR210 User’s Manual
vii
3.1 Make a Recovery SD Card ................................................................. 30
3.2 Display Parameter Setting in Kernel(Feature not ready yet) .............. 33
Chapter 4 BSP Source Guide ............................................. 34
Appendix ....................................................................................... 37
A. How to Use GPIO in Linux .................................................................. 38
B. How to Use Watchdog in Linux ........................................................... 38
C. eMMC Test ......................................................................................... 39
D. USB (flash disk) Test .......................................................................... 40
E. SD Card Test ...................................................................................... 41
F. RS-232 Test ........................................................................................ 42
G. RS-485 Test ........................................................................................ 43
H. Audio Test ........................................................................................... 43
I. Ethernet Test ...................................................................................... 44
J. LVDS Test ........................................................................................... 45
K. HDMI Test ........................................................................................... 46
L. 3G Test ............................................................................................... 47
M. Onboard Connector Types .................................................................. 48
viii
IBR210 User’s Manual
This page is intentionally left blank.
1
Chapter 1
General Information
The information provided in this chapter includes:
• Features
• Packing List
• Specifications
• Block Diagram
• Product View
• Board Dimensions
2
IBR210 User’s Manual
1.1 Introduction
IBR210 is a 3.5" Disk-Size SBC powered by the NXP i.MX8M Cortex-A53
1.3GHz processor. It offers 2D, 3D graphics and multimedia accelerations,
and supports numerous peripheral interface, including RS-232/422/485,
COM, GPIO, USB3.0/2.0, LAN and audio. For the display, it also supports 1
HDMI for a 4K display or FHD Dual-channel LVDS. Other features are an M.2
Key-E, type 2230 and mini-PCIe expansion slots that are well suited for IoT
applications.
Photo of IBR210
1.2 Features
• With NXP Cortex-A53/Cortex-M4, i.MX 8M Quad 1.3GHz Industrial-
Grade Processor
• Supports HDMI2.0a, or dual-channel FHD LVDS
• Supports 3GB LPDDR4, 16GB eMMC and SD socket
• Supports embedded I/O for COM, GPIO, USB3.0, Audio and Ethernet
• Supports M.2 Key-E (2230) and mini-PCI-E with SIM socket for wireless
and LTE connectivity
Indice
Altri manuali IBASE Technology Computer a scheda singola
IBASE Technology
IBASE Technology IB818F-I50 Manuale utente
IBASE Technology
IBASE Technology IB919 Series Manuale utente
IBASE Technology
IBASE Technology ASB200-915-i5M Manuale utente
IBASE Technology
IBASE Technology IB909F Manuale utente
IBASE Technology
IBASE Technology IB961 Manuale utente
IBASE Technology
IBASE Technology MB837-D25 Manuale utente
IBASE Technology
IBASE Technology IB953 Series Manuale utente
IBASE Technology
IBASE Technology IB918F Manuale utente
IBASE Technology
IBASE Technology IBR117 Manuale utente
IBASE Technology
IBASE Technology IB811F Series Manuale utente
