ICW EV65 Manuale utente
Screw in the VESA inter ace plate into
the VESA hole pattern on the back o your
LCD monitor using the our 4mm phillips
screws provided.
Slide the rails into the EV65 joint.
(2) VESA plates
(1 ) Wall plate w/ track
(2) EV65 track sliders
(2) 1 4x2 1 /2"
wood screws
(2) 1 0-32x1 /4 sockethead
cap screws
(4) 4mm phillips screws
(2) 5/1 6-1 8x3/4L sockethead
cap screws
(1 ) 1 /4" hex key
(1 ) 5/32" hex key
Dual monitor EV65 wall mount
Bolt the rails into place using the two
5/1 6-1 8x3/4L sockethead cap screws
provided with the 1 /4" hex key provided.
Installation instructions for the EV65 dual monitor wall/track mount - page 1 II001 - 10/19/2009 - MF
Page 1
A ter locating a wall stud and by using a
level, mark the holes or the wall place.
Create guide holes be ore screwing in the
countersunk 1 4x2 1 /2 wood screws
provided.
A ter loosening the slider plate on the
EV65, slide on to the track like shown in
the illustration. Once on, tighted the slider
place by using the indexing chrome
handle on the slider. Do this with both
monitors.
Once you have both monitors on the
track, locate the track endcaps in your
hardware bag. These will it into each end
o the track, covering the sharp edges.
Using the two 1 0-32x1 /4 sockethead cap
screws provided, asten the track endcaps
to the track like shown with the 5/32" hex
key.
Dual monitor EV65 wall mount Page 2
Installation instructions for the EV65 dual monitor wall/track mount - page 2 II001 - 10/19/2009 - MF
Indice
Altri manuali ICW Rack e supporto
ICW
ICW ELITE 5220 Manuale utente
ICW
ICW Elite Manuale utente
ICW
ICW T2 Manuale utente
ICW
ICW T2P2020 Manuale utente
ICW
ICW TITAN ELITE T2EQ-C8X5 Manuale utente
ICW
ICW UL182 OHAP Manuale utente
ICW
ICW TITAN ELITE T2E12P-WT2-KUB Manuale utente
ICW
ICW GX170 Manuale utente
ICW
ICW LTU-W3-A2 Manuale utente
ICW
ICW W2 Manuale utente
