iLiving ILG8F20 Manuale utente
20" HIGH VELOCITY FAN
Model: ILG8F20
OWNER'S MANUAL
PLEASE READ AND SAVE
THESE INSTRUCTIONS
Read Instruction manual carefully before assembling or installing your
fan. It is important that you observe all safety information to help
prevent personal injury and/or property damage.
20” HIGH VELOCITY FAN
MODEL NO. ：ILG8F20
Voltage Rating: 120VAC 60Hz
Power：165W
CAUTION: Read and follow all instructions before operating fan. Do
not use fan if any part is damaged or missing.
WARNING: To reduce the risk of fire or electrical shock, DO NOT use
this fan with any solid state speed control device. This appliance has a
3-prong grounded plug that must be inserted into a matching outlet.
To reduce the risk of electrical shock, this grounding plug must not be
removed from the plug. Where a two-prong wall outlet is encountered,
it must be replaced: contact a qualified electrician. DO NOT attempt to
remove this safety feature. Use your fan only with adequate wiring
that is up to Code. Connect to properly grounded outlets only.
INSTRUCTIONS FOR SAFE OPERATIONS
This product employs overload protection (fuse). A blown fuse
indicates an overload or short-circuit situation. If the fuse blows,
unplug the product from the outlet. Replace the fuse as per the user
servicing instructions (follow product marking for proper fuse rating)
and check the product. If the replacement fuse blows, a short-circuit
may be present and the product should be discarded or returned to an
authorized service facility for examination and/or repair.
●Always unplug unit for cleaning.
●Always unplug unit when not in use.
●Always unplug when moving unit from one location to another.
●Do not place foreign objects through guard when fan is in
operation.
●Do not operate without fan guards properly locked.
●Do not use this fan with an extension cord.
●Do not use this fan near windows. Rain and moisture may create
an electrical hazard.
●Do not place fan or fan parts near an open flame, cooking or other
heating appliance.
●Do not operate this unit with a damaged cord or plug, especially
when this unit has previously malfunctioned, or been dropped or
damaged.
●Make sure fan is on a stable, flat surface when in operation.
●Close supervision is necessary when this unit is used by or near
children.
UNPACK YOUR FAN AND CHECK THE CONTENTS
●Fan Head With Two Screws &Two Adjustment Knobs
●Supporting Stand
●Wall Bracket
●Instruction Manual
ASSEMBLY INSTRUCTIONS
1. Please put the fan on a flat and stable surface as shown in the
picture.
2. Remove the two knobs from the steel tube attached to the
fan head, save them for step 4.
3. Align the hole in the stand with the hole in the steel tube
attached to the fan head.
4. Carefully insert the knobs from step 2 into the holes and tight
them. Please be sure to re-tighten the adjustment knobs to
avoid swaying of the fan head.
(If you need the fan for wall function, follow up Step 5 to 7.)
5. Mount the wall bracket with a 1/4”diameter by 2-1/2”long
lag bolt provided. Loosen set screw on the wall bracket, save it
For step 7.
6. Hold fan in an upright position, place stand in wall bracket
hook so that rubber feet on the stand rest against the wall.
Tighten back the set screw from step 6 to lock the stand in
position.
7. Tilt fan head to desired angle.
OPERATING INSTRUCTIONS:
1. Set fan on a dry, stable and flat surface.
2. Connect the plug to any standard 120-volt AC outlet. Caution:
Make sure the Speed Control is in the OFF position.
3. Change the setting on the speed control to the desired
operating speed --- OFF"0", LOW"1", MEDIUM"2" or HIGH"3".
4. To change the tilt -angle of the Fan Head, loosen the Tilt
Adjustment Knob on the side of the Grille, tilt the Fan Head to
the desired angle and tighten the knob. The knobs on both
sides are tools for tilt adjustment.
Note: It is normal for the motor to feel warm to the touch during
operation. The motor is thermally protected and will
automatically shut off when it overheats for any reason. If this
happens, immediately disconnect the fan from the power outlet.
The motor bearings are permanently lubricated at the factory
and do not require any additional lubrication.
REPLACING PLUG FUSE
When the fuse in the power cord blows, please replace the fuse
by following these steps:
1. Disconnect the plug from the wall outlet. Do not unplug by
pulling on cord. Then slide open the fuse access cover on top
of attachment plug towards blades, as shown in Figure 1.
2. Remove the fuse carefully using a flat head screwdriver, as
shown in Figure 2.
3. Replace the fuse only with 5 Amp, 125 Volt fuse, as shown in
Figure 3. (You may purchase a replacement fuse from a local
hardware store).
4. Slide the fuse access cover on top of attachment plug, as
shown in Figure 4.
Figure 1 Figure 2
Figure 3 Figure 4
CLEANING
WARNING: Unplug the fan from the wall outlet before cleaning. After
cleaning, any safety device (including grills and blades) must be
reinstalled or remounted as previously installed.
Use soft damp cloth then wipe with dry cloth. Do not use harmful
cleaners. Do not bend the blades.
Wash guards and blades with water and a soft brush. Avoid harsh
chemical cleaners. DO NOT IMMERSE MOTOR IN WATER. Allow fan to
dry completely before use.
WARNING
This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible
for their safety.
WARRANTY
This fan comes with a ONE-YEAR LIMITED COMPONENT WARRANTY.
If your fan does not appear to be working properly, please contact our
service center by calling 1-800-317-1688. Prior to your call, we
encourage you to visit our website www.ilivingusa.com for
troubleshooting tips and service instructions if needed.
Warranty Information
Register your product at our website:
Or visit iLivingUSA.com/register-product
Feedback
Love it? Help us make the product more for you.
Let us know with a customer review.
Please visit: https://www.amazon.com/review/review-your-purchases#
At iLiving USA, we are committed to bringing top quality products to our
customers.
iLIVING USA
9293 Beatty Dr,
Sacramento, CA 95826
Tel: 1-800-317-1688
Email: ser[email protected]
Like us on Facebook: https://www.facebook.com/ilivingusa/
Follow us on Twitter: @iLIVINGUSA
Check out our website: www.ilivingusa.com
Indice
Altri manuali iLiving Fan
iLiving
iLiving ILG8EF10EX Manuale
iLiving
iLiving ILG8P30-72 Manuale utente
iLiving
iLiving ILG8SF10V-ST Manuale utente
iLiving
iLiving ILG8G14-22ST Manuale utente
iLiving
iLiving ILG8SF10V-T Manuale utente
iLiving
iLiving ILG8MF30-83 Manuale utente
iLiving
iLiving ILG8M24-60DC Manuale utente
iLiving
iLiving ILG8WD24-2P Manuale utente
iLiving
iLiving ILG8SF7V Manuale utente
iLiving
iLiving ILG937 Istruzioni per l’uso
iLiving
iLiving ILG8P30M Manuale utente
iLiving
iLiving ILG8P31-93 Manuale utente
iLiving
iLiving ILG8E18-15 Manuale utente
iLiving
iLiving ILG-250 Manuale utente
iLiving
iLiving ILG8RX12 Manuale utente
iLiving
iLiving ILG8HVLS72 Manuale utente
iLiving
iLiving ILG8MF72-430 Manuale utente
iLiving
iLiving LG8VF10 Manuale utente
iLiving
iLiving ILG8SF10V(APB-10A) Manuale utente
iLiving
iLiving ILG8E18-15 Manuale utente
