Operation and Control
•On your iPhone/Android phone, go to Settings Wi-Fi, and make sure Wi-Fi is turned on.
•Under Wi-Fi list the DragonFly would be listed using a SSID. SSID will contain “DF” followed by the last 5 numbers of
the DragonFly serial number –i.e., DF01494. Note: Serial number is found on the back side of the Dragonfly chassis
•Now connect the phone/tablet/computer to the DragonFly Wi-Fi.
•Enter password –‘imtgonow!’
•Open browser (Mozilla Firefox, Safari, and Google Chrome) and enter the URL ‘192.168.1.1’ to get to the DragonFly
Webpage GUI.
•There are 4 pages on the GUI:
oHome –Turn DFT on and off –also tells frequency status
oSettings –Changes transmitter frequency, Modulation, code rate and guard interval. It also has some advanced
setting options
oFrequency Plan –Used to change the frequency plan.
oCamera control –Used to change the camera settings through the DragonFly webpage GUI
•Home Page
oTransmission Mode
▪High –Runs the Tx and camera at High power
▪Low--Runs the Tx and camera at Low power
▪Standby –Turns RF ‘Off’ – Status bar will be black when not transmitting and green when transmitting.
▪Hibernate—It takes 10 secs to switch from hibernate to High or Low
oDevice Status –RF, Frequency Status, Video format and Encryption
oSystem Information –Encoder, Controller, Temperature and battery
•Settings
oChange channels –Touch to view frequency drop down list.
▪Choose required frequency
▪Press ‘Apply’
oModulation
▪Choose 1 of 3 predetermined modulation modes (High Quality, Good Quality, Long range) depending on
needs.
▪Press ‘Apply’ - Setting will turn black when selected and turn green when applied.
▪Choose manual for other setting options.
•Advanced Settings
oVideo Format
▪1080i59.94
▪1080i50
▪720p59.94
▪720p50
▪Press “Apply” to activate the selected setting
oLatency
▪Low Latency
