Inclusive Technology it-Control Lite Manuale utente
Inclusive Technology
www.inclusive.co.uk
Compatibility
The it-Control Lite is compatible with any Simply Works
transmitter.
These include:
• it-Switch - a wireless switch.
• it-Send and it-Send Pro - to enable connection of wired
switches.
• it-Stick - can be used as a ‘wobble switch’.
Batteries
The it-Control Lite requires 2 x AAA batteries. These are tted by
removing the battery cover on the underside of the device.
Ensure the batteries are inserted correctly - match the + and –
symbols on the battery with those in the battery compartment.
Replace the battery cover and screw. It is recommended that
good quality batteries are used (such as Energiser or Duracell).
If you are not intending to use the it-Control Lite for an extended
period (e.g. a number of weeks) it is advisable to remove the
batteries to prevent leakage, which may damage the device.
Pairing it-Control Lite with a transmitter (e.g. it-Switch,
it-Send)
1. Place the it-Control Lite close to the transmitter device.
2. Press and release the PAIR button on the front of the it-Control
Lite. The red light next to it will begin ashing.
3. Within 10 seconds press and release the PAIR button on the
transmitter.
4. The light on the it-Control Lite will continue to ash while the
devices communicate with each other.
5. Once the pairing is successful the red light on the it-Control
Lite will stay on for 5 seconds.
6. If the light continues to ash for 30 seconds and then stops,
repeat the process above. If it still does not pair successfully,
refer to the Troubleshooting section.
Pairing information is retained in the it-Control Lite’s memory
even after changing the batteries.
Output rating
The output rating of the jack socket is 1 amp at up to 30V.
Exceeding this rating may cause permanent damage and is not
covered by the warranty.
Operation
If you have paired the it-Control Lite with the it-Send or it-Switch,
you must ensure the mode on these devices is set to 0.
Plug one end of the lead supplied into the socket marked
OUTPUT on the it-Control Lite. Connect the other end to your
preferred device. This may be an adapted battery toy or a mains
control device.
The it-Control Lite activates using direct (sometimes also called
‘momentary’) control. This means the attached toy is activated
while the switch is held down. When the switch is released the
toy will stop. This is good for individuals learning about cause
and effect as it provides a concrete link between the switch press
and toy activation.
Possible cause
• Not paired with a transmitter - see
pairing instructions.
• Transmitter not set to 0 - set mode
on transmitter to 0.
• No batteries in it-Control Lite, or
batteries are at – insert or replace
batteries.
• Batteries in it-Control Lite at -
replace batteries.
• Out of range - move transmitter
closer to it-Control Lite.
• Interference - move it-Control Lite
and transmitter away from sources
of interference (e.g. mobile phone).
• No batteries in it-Control Lite, or
batteries are at - insert or replace
batteries.
• No batteries in transmitter, or
batteries are at - insert or replace
batteries.
• Ensure it-Control Lite is close to
transmitter while pairing (within 1
metre).
Problem
it-Control Lite not functioning.
it-Control Lite works erratically or
intermittently.
Devices will not pair.
it-Control Lite troubleshooting
Maintenance
Your Simply Works device contains no user serviceable parts. If
it does not work as expected consult the troubleshooting guide.
If there are still problems with the device please contact your
supplier.
Warranty
Your Simply Works device is warranted against defects in
manufacture or component failure. The unit is designed for
domestic and educational applications. Use outside these areas
will invalidate the warranty. Unauthorised repair or modication,
mechanical abuse, immersion in any liquid or connection to
incompatible equipment will also invalidate the warranty.
Technical support
If you need further support with any of the Simply Works range,
please contact us:
Inclusive Technology Ltd
Riverside Court, Huddersfield Road
Delph
Oldham OL3 5FZ
United Kingdom
Tel: +44 (0)1457 819790
Fax: +44 (0)1457 819799
email: [email protected]
www.inclusive.co.uk
Notes
Inclusive Technology Ltd
Riverside Court, Huddersfield Road
Delph, Oldham OL3 5FZ
United Kingdom
Tel: +44 (0)1457 819790
Fax: +44 (0)1457 819799
email: [email protected]
www.inclusive.co.uk
Indice
Altri manuali Inclusive Technology Telecomando
