Inside Ride E-FLEX KICKR V2 Manuale utente
KICKR E-FLEX V2 Assembly
Prep your KICKR for installation by
unscrewing the 2 adjustable pads from the
folding legs. Then remove the front pad from
the center leg, held on with a single screw.
These pads will not be used with the E-flex.
Unfold the KICKR support legs and remove
the height adjustment pin. Raise the KICKR
height adjustment as far as possible. Leave
the pin out for now. The KICKR is now ready
to place on the E-flex frame in the orientation
shown.
The E-FLEX uses a support arm to balance the
KICKR flywheel. It has two positions, firm
and soft. KICKR 14 & 18 use the firm
position, KICKR 16,17 & 20 use the soft
position. To change the firmness, unbolt the
arm and reverse it. NOTE: the arm is shipped
in the soft position as noted by the position of
the slot.
Soft
Firm
Support Arm
Lower the KICKR into position as shown.
The center leg of the KICKR fits into the 2
receiver saddles on the E-flex frame.
For proper forward positioning, the center
leg of the KICKR should extend approx. 3”
(76mm) from the front saddle. A setup
block is provided as a quick way to position
the KICKR correctly.
Use the provided setup block to check
KICKR alignment. Slide the block between
the saddle clamp and the frame as shown.
First at the front clamp and then at the rear
clamp. Adjust the KICKR position until the
setup block just fits at both points. That will
ensure the KICKR is aligned with the E-
FLEX frame
Install the 2 saddle clamps and 4 wing nuts
and tighten. The trainer should be
approximately vertical and not heavily tilted
to one side. It does not need to be perfectly
vertical to work properly. If it is tilted more
than a degree or two, you may need to go
back and adjust the support arm.
Next lower the KICKR height
adjustment to the RD650C position and
install the lock pin. This setting works
for all KICKR models except the KICKR
20 (V5) which uses the RD 24 position to
maintain a level ride height.
Fold in the KICKR support
legs. The E-Flex is now
ready to receive the bike
onto the KICKR.
Use the normal KICKR installation procedure for attaching the bike. Leave
your front wheel on for now.
After the rear of the bike is attached to the KICKR, do not fully tighten
the bike axle. Leave it slightly loose so the bike can pivot up or down as the
fork stand is installed.
ASSEMBLE THE FORK STAND
The fork stand must be unfolded and locked in the upright position with 6
screws. Two of the screws are pre-installed. The remaining 4 screws are
supplied with the hex key and must be installed and tightened to proceed
safely.
ATTACHING THE FORK STAND
Remove your front wheel and place the E-flex fork stand under the bike’s
dropouts. Lower the fork onto the fork stand and fasten it with either your
thru axle or a standard quick release.
Point your fork straight ahead for proper alignment. Now tighten the rear
dropout and you are ready to ride. The KICKR will perform normally. The
E-flex does not alter the KICKR wattage performance.
Indice
Altri manuali Inside Ride Cyclette
