Intel NUC 7 ENTHUSIAST Manuale utente

User Guide for NUC7i5BNKP, NUC7i7BNKQ

Intel® NUC 7 Home, a Mini PC with Windows® 10 –NUC7i5BNKP

Intel® NUC 7 Enthusiast, a Mini PC with Windows® 10 –NUC7i7BNKQ

User Guide

User Guide for NUC7i5BNKP, NUC7i7BNKQ

Before You Begin

CAUTION

The steps in this guide assume you’re familiar with computer terminology and with the safety

practices and regulatory compliance required for using and modifying computer equipment.

Disconnect the computer from its power source and from any network before performing any of the

steps described in this guide.

Failure to disconnect power or networks before you open the computer or perform any procedures can

result in personal injury and/or equipment damage. Some circuitry on the board can continue to

operate even though the front panel power button is off.

Follow these guidelines before you begin:

Always follow the steps in each procedure in the correct order.

Create a log to record information about your computer, such as model, serial numbers,

installed options, and configuration information.

Electrostatic discharge (ESD) can damage components. Perform the procedures described in

this chapter only at an ESD workstation using an antistatic wrist strap and a conductive foam

pad. If such a station isn’t available, you can provide some ESD protection by wearing an

antistatic wrist strap and attaching it to a metal part of the computer chassis.

Installation Precautions

When you install and test the Intel NUC, observe all warnings and cautions in the installation

instructions.

To avoid injury, be careful of:

Sharp pins on connectors

Sharp pins on circuit boards

Rough edges and sharp corners on the chassis

Hot components (such as SSDs, processors, voltage regulators, and heat sinks)

Damage to wires that could cause a short circuit

Observe Safety and Regulatory Requirements

If you don’t follow these instructions, you increase your safety risk and the possibility of

noncompliance with regional laws and regulations.

User Guide for NUC7i5BNKP, NUC7i7BNKQ

This guide tells you how to:

•

Upgrade system memory

•

Change/install an M.2 SSD

•

Use a VESA mount bracket

•

Connect power

•

Set up Microsoft® Windows® 10

•

Install the latest device drivers and software

•

Recover the operating system

Open the Chassis

Unscrew the four corner screws on the bottom of the chassis and lift the cover.

User Guide for NUC7i5BNKP, NUC7i7BNKQ

Upgrade System Memory

The Intel NUC Mini PCs NUC7i5BNKP and NUC7i7BNKQ have two 260-pin DDR4 SO-DIMM sockets,

that include pre-installed memory.

Pre-installed memory

NUC7i5BNKP

Two 4GB memory modules

NUC7i7BNKQ

Two 8GB memory modules

To upgrade memory, be sure to select memory modules that meet these requirements:

1.2V low voltage memory

2133 MHz SO-DIMMs

Non-ECC

Find compatible memory modules in the Intel Product Compatibility Tool:

NUC7i5BNKP

NUC7i7BNKQ

To upgrade or add memory, follow these steps:

1. Observe the precautions in "Before You Begin" on page 2.

2. Turn off all peripheral devices connected to the computer. Turn off the computer and

disconnect the power cord.

3. Remove the computer’s bottom chassis cover.

Upgrade to different memory

a. Remove the pre-installed memory module

i. Gently spread the retaining clips at each end of the memory socket, which causes

the module to pop out of the socket (C).

ii. Holding the module by the edges, lift it away from the socket, and store it

in an anti-static package.

b. Install the new memory module

i. Align the space at the bottom edge of the memory module with the key in

the socket.

ii. Insert the bottom edge of the module at a 45 degree angle into the socket

(A).

iii. When the module is inserted, push down on the outer edges of the

module until the retaining clips snap into place (B). Make sure the clips

are firmly in place (C).

User Guide for NUC7i5BNKP, NUC7i7BNKQ

Install an additional memory module

a. Align the space at the bottom edge of the memory module with the key on the socket.

b. Insert the bottom edge of the module at a 45 degree angle into the socket (A).

c. When the module is inserted, push down on the outer edges of the module until

the retaining clips snap into place (B). Make sure the clips are firmly in place (C).

4. Reinstall and reconnect any parts you removed or disconnected to reach the memory sockets.

5. Replace the computer’s cover and reconnect the power cord.

Changing an M.2 SSD

The Intel NUC Kits NUC7i5BNKP and NUC7i7BNKQ support either an 80mm or 42mm SSD. Both mini

PCs come pre-installed with an m.2 SSD.

Pre-installed M.2

NUC7i5BNKP

One 256GB Intel® 600p NVMe SSD

NUC7i7BNKQ

One 512GB Intel® 600p NVMe SSD

Find compatible M.2 SSDs in the Intel Product Compatibility Tool

NUC7i5BNKP

NUC7i7BNKQ

To Change an M.2 SSD:

1. Remove the small silver screw from the 80mm or 42mm metal standoff on the board (A).

2. Remove the pre-installed SSD from the connector.

3. Align the space at the bottom of the new M.2 SSD to the key on the connector.

4. Insert the bottom edge of the M.2 SSD into the connector (B).

5. Secure the card to the standoff with the small silver screw (C).

User Guide for NUC7i5BNKP, NUC7i7BNKQ

Close the Chassis

After all components have been installed, close the Intel NUC chassis. Intel recommends this be done

by hand with a screwdriver to avoid over-tightening and possibly damaging the screws.

User Guide for NUC7i5BNKP, NUC7i7BNKQ

Attach and Use the VESA Bracket (Optional)

Follow these instructions to attach and use the VESA mount bracket:

1. Using the four small black screws that are included in the box, attach the VESA bracket to the

back of the monitor or TV.

2. Attach the two slightly larger black screws to the bottom chassis cover of the Intel NUC.

User Guide for NUC7i5BNKP, NUC7i7BNKQ

3. Slide the Intel NUC onto the VESA mount bracket.

Power Adapters

Country-specific power plug adapters are included in the box.

1. Choose the correct adapter for your region.

Plug

Code

AUS

Country

United States

United Kingdom

European Union

Australia

Plug

Code

CHN

IND

KOR

ARG

Country

China

India

South Korea

Argentina

User Guide for NUC7i5BNKP, NUC7i7BNKQ

Plug

Code

BRA

Country

Brazil

2. Slide the adapter (B) onto the power plug, locking it into place (A).

User Guide for NUC7i5BNKP, NUC7i7BNKQ

3. Connect AC power.

Set Up Microsoft® Windows® 10

Microsoft Windows 10 is already installed on the Intel NUC. The first time you start the computer,

you’re guided through the Windows 10 setup steps, including:

Selecting your region and language.

Accepting the Microsoft Windows license terms.

Personalizing Windows and assign a PC Name.

"Get Online" dialog to pick a wireless network (this step is optional).

Choosing Express Settings or Customize.

Assigning a User Name and Password.

Reinstalling the Operating System

If you upgrade or replace the computer’s drive, you may need to install a new version of the operating

system. See these resources:

Supported Operating Systems

Windows Setup Guide

Questo manuale è adatto per i seguenti modelli

Indice

Altri manuali Intel Scrivania

Intel

Intel NUC Kit NUC5PGYH Manuale utente

Intel

Intel SR1530AH - Server System - 0 MB RAM Manuale utente

Intel

Intel NUC 8 Enthusiast Manuale utente

Intel

Intel NUC7i3BNHXF Manuale utente

Intel

Intel NUC 13 Pro NUC13ANHi7 Manuale utente

Intel

Intel NUC 13 Pro Desk Edition Manuale utente

Intel

Intel NUC 13 Pro Kit NUC13ANHv7 Manuale utente

Intel

Intel NUC10i7FNKN Manuale utente

Intel

Intel System 310 Manuale del proprietario

Intel

Intel NUC6i3SYK Manuale utente

Intel

Intel STCK1A32WFC Manuale utente

Intel

Intel inside MINIS FORUM Manuale utente

Intel

Intel NUC6i7KYK Manuale utente

Intel

Intel NUC 12 Pro X Manuale utente

Intel

Intel NUC 11 Performance Manuale utente

Intel

Intel SR4850HW4 - Server Platform - 0 MB RAM Manuale utente

Intel

Intel NUC Series Manuale utente

Intel

Intel SR2600UR - Server System - 0 MB RAM Manuale utente

Intel

Intel NUC8i7HVKVAW Manuale utente

Intel

Intel TIGW1U - Carrier Grade Server Manuale utente

Intel

Intel NUC 12 Pro Kit NUC12WSHi3 Manuale utente

Intel

Intel PC On A Stick Manuale utente

Intel

Intel NUC12DCM Manuale utente

Intel

Intel NUC8i5BEK Manuale utente

Manuali Scrivania popolari di altre marche

HP m9060n - Pavilion - Elite Scheda tecnica

Asus

Asus E210 Series Manuale utente

Dell

Dell Inspiron 600m Manuale utente

Dell

Dell Inspiron 3662 Manuale utente

TotalFlow

TotalFlow uFLO Manuale utente

HP Presario SV7000 - Desktop PC Manuale utente

HP ProDesk 400 G5 Manuale

Logitech

Logitech MK320 Manuale utente

Dell

Dell XPS 730 H2C Manuale utente

Sony

Sony Vaio Series Manuale utente

Sony

Sony VGC-LT32E - Vaio All-in-one Desktop Computer Manuale utente

Alto

Alto MD 250 Manuale utente

Lenovo

Lenovo ThinkCentre Edge 72 Manuale

Lenovo

Lenovo ThinkStation D20 Manuale

Arbor Technology

Arbor Technology FPC-7800 Series Manuale utente

Sony

Sony VAIO VGX-TP1 Series Manuale utente

Asus

Asus Eee Box B204 Manuale utente

Dell

Dell Optiplex 9010 All In One Manuale utente