Intel NUC Kit NUC5PGYH Manuale utente

Intel NUC Kit NUC5PGYH User Guide

Intel®

NUC Kit

NUC5PGYH

User

Guide

Intel NUC Kit NUC5PGYH User Guide

Before You Begin

CAUTIONS

The steps in this guide assume you’re familiar with computer terminology and with the safety

practices and regulatory compliance required for using and modifying computer equipment.

Disconnect the computer from its power source and from any network before performing any of the steps

described in this guide.

Failure to disconnect power or networks before you open the computer or perform any procedures can

result in personal injury and/or equipment damage. Some circuitry on the board can continue to

operate even though the front panel power button is off.

Follow these guidelines before you begin:

Always follow the steps in each procedure in the correct order.

Create a log to record information about your computer, such as model, serial numbers,

installed options, and configuration information.

Electrostatic discharge (ESD) can damage components. Perform the procedures described in

this chapter only at an ESD workstation using an antistatic wrist strap and a conductive foam

pad. If such a station isn’t available, you can provide some ESD protection by wearing an

antistatic wrist strap and attaching it to a metal part of the computer chassis.

Installation Precautions

When you install and test the Intel NUC, observe all warnings and cautions in the installation

instructions.

To avoid injury, be careful of:

Sharp pins on connectors

Sharp pins on circuit boards

Rough edges and sharp corners on the chassis

Hot components (such as SSDs, processors, voltage regulators, and heat sinks)

Damage to wires that could cause a short circuit

Observe all warnings and cautions that instruct you to refer computer servicing to qualified

technical personnel.

Observe Safety and Regulatory Requirements

If you don’t follow these instructions, you increase your safety risk and the possibility of noncompliance

with regional laws and regulations.

Intel NUC Kit NUC5PGYH User Guide

This guide tells you how to:

•

Install a 2.5” drive

•

Upgrade system memory

•

Install a VESA mount bracket

•

Set up Microsoft® Windows® 10

•

Install the latest device drivers and software

•

Recover the operating system

Open the Chassis

Unscrew the four corner screws on the bottom of the chassis and lift the cover.

Install a 2.5” SSD or Hard Drive (Optional)

Find compatible drives in the Intel® Product Compatibility Tool.

Follow these instructions to install a 2.5” Solid State Drive (SSD) or Hard Disk Drive (HDD):

1. Observe the precautions in "Before You Begin" on page 2.

Intel NUC Kit NUC5PGYH User Guide

2. Slide the 2.5” drive into the drive bay, ensuring the SATA connectors are fully seated into the

connectors of the SATA daughter card (A).

3. Secure the drive into the drive bay with the two small silver screws that were included in the box (B).

4. Set the drive bay bracket down inside the chassis (C), taking care not to pinch the SATA cables along

the edge.

Intel NUC Kit NUC5PGYH User Guide

Upgrade System Memory

Intel NUC Kit NUC5PGYH has a 2GB DDR3L memory module already installed. You can upgrade to a

larger capacity module if you wish. Memory requirements:

1.35V low voltage memory

1066 MHz or 1600 MHz SO-DIMMs (1333 MHz modules will operate at 1066 MHz)

Non-ECC

Max memory –8GB

Find compatible memory modules in the Intel® Product Compatibility Tool.

To upgrade memory:

1. Remove the pre-installed SO-DIMM, following these steps:

a. Observe the precautions in "Before You Begin" on page 2.

b. Gently spread the retaining clips at each end of the SO-DIMM socket. The SO-DIMM

pops out of the socket.

c. Hold the SO-DIMM by the edges, lift it away from the socket, and store it in an

anti-static package.

d. Reinstall and reconnect any parts you removed or disconnected to reach the SO-DIMM

sockets.

e. Replace the computer’s cover and reconnect the AC power cord.

2. Install the new SO-DIMM, following these steps:

a. Align the small notch at the bottom edge of the SO-DIMM with the key in the socket

(A).

b. Insert the bottom edge of the SO-DIMM into the socket.

c. When the SO-DIMM is inserted, push down on the outer edge of the SO-DIMM (B)

until the retaining clips snap into place. Make sure the clips are firmly in place (C).

Intel NUC Kit NUC5PGYH User Guide

Close the Chassis

After all components have been installed, close the Intel NUC chassis. Intel recommends this be done by

hand with a screwdriver to avoid over-tightening and possibly damaging the screws.

Attach and Use the VESA Bracket

Follow these instructions to attach and use the VESA mount bracket:

1. Using the four small black screws that were included in the box, attach the VESA bracket to the

back of the monitor or TV.

Intel NUC Kit NUC5PGYH User Guide

2. Attach the two slightly larger black screws to the bottom chassis cover of the Intel NUC.

3. Slide the Intel NUC onto the VESA mount bracket.

Set Up Microsoft® Windows® 10

Microsoft Windows 10 is already installed on the Intel NUC. The first time you start the computer, you’re

guided through the following Setup steps:

1. Select your region and language.

2. Accept the Microsoft Windows license terms.

3. Personalize Windows and assign a PC Name.

4. "Get Online" dialog to pick a wireless network (this step is optional).

5. Choose Express Settings or Customize.

6. Assign a User Name and Password.

Intel NUC Kit NUC5PGYH User Guide

Install the Latest Device Drivers and Software

Here are the options for keeping device drivers current:

Allow the Intel® Driver & Support Assistant (Intel® DSA) to detect out-of-date drivers

Manually download drivers, BIOS, and software from Download Center.

The following device drivers and software are available.

Intel® Chipset Device Software

Intel® HD Graphics

Intel® Trusted Execution Technology

Intel® Serial I/O

Realtek* High Definition Audio

Realtek* Gigabit Ethernet

ITE Tech* Consumer Infrared

Near Field Communication (NFC)

Operating System Recovery

There’s a Windows recovery partition on the Intel NUC. You can use this partition to Refresh, Reset, or

Restore Windows. Here is what each of these actions do:

Refresh

If your PC isn't performing as well as it once did, and you don't know why, you can

refresh your PC. This action doesn’t delete any of your personal files or change your

settings. Refresh does the following:

Files and personalization settings won’t change.

PC settings are changed back to their defaults.

Apps from the Windows Store are kept.

Apps installed from disks or websites are removed.

List of removed apps is saved on the desktop.

Reset

If you want to recycle your PC, give it away, or start over with it, you can reset it

completely. This process removes everything. Reset does the following:

All personal files and apps are removed.

PC settings are changed back to their defaults.

Windows is reinstalled.

Restore

If a recently installed app or driver is causing problems with your PC, you can

restore Windows back to an earlier point in time, called a restore point. System

Restore doesn’t change your personal files, but it can remove recently installed

apps and drivers.

Intel NUC Kit NUC5PGYH User Guide

Caution - Before performing a reset or refresh:

Make sure to back up all personal data to external storage.

Remove SD card from the card slot, if one is inserted.

To access the recovery media:

If Windows starts

From Windows Start, type Recovery and select Recovery Options.

See Recovery options in Windows 10 for complete details on how

to use the recovery options.

If Windows doesn’t start

The recovery process should automatically start. If Recovery

doesn’t automatically start, you can try to initiate it as follows:

1. Press F8 during boot, when you see the prompt “F8 to

Activate Windows 8.1/10 Recovery Mode”.

2. Follow the recovery steps.

Altri manuali per NUC Kit NUC5PGYH

Indice

Altri manuali Intel Scrivania

Intel

Intel NUC6i3SYK Manuale utente

Intel

Intel NUC Series Manuale utente

Intel

Intel NUC7i3BNHXF Manuale utente

Intel

Intel NUC11PAKi7 Manuale utente

Intel

Intel NUC10i7FNKN Manuale utente

Intel

Intel Compute Stick STCK1A8LFC Manuale utente

Intel

Intel NUC8i7HVKVAW Manuale utente

Intel

Intel Compute Card Dock Manuale utente

Intel

Intel inside MINIS FORUM Manuale utente

Intel

Intel DC53427HYE Manuale utente

Intel

Intel NUC7i5BNHXF Manuale utente

Intel

Intel DC3217IYE Manuale utente

Intel

Intel SR2520SAXSR - Server System - 0 MB RAM Manuale utente

Intel

Intel SRSH4 - Server Platform - 0 MB RAM Manuale utente

Intel

Intel CareFusion DMS-SA1300-A1E Manuale utente

Intel

Intel NUC Kit DE3815TYKHE Manuale utente

Intel

Intel D34010WYK1 Guida di riferimento

Intel

Intel NUC 13 Pro Desk Edition Manuale utente

Intel

Intel INTELLEC Guida rapida per l'utente

Intel

Intel NUC8i3BEK Manuale utente

Intel

Intel Learning Series Manuale utente

Intel

Intel NUC6CAYH Manuale utente

Intel

Intel NUC8i7BEK Manuale utente

Intel

Intel NUC 12 Pro Manuale utente

Manuali Scrivania popolari di altre marche

HP m9060n - Pavilion - Elite Scheda tecnica

Asus

Asus E210 Series Manuale utente

Dell

Dell Inspiron 600m Manuale utente

Dell

Dell Inspiron 3662 Manuale utente

TotalFlow

TotalFlow uFLO Manuale utente

HP Presario SV7000 - Desktop PC Manuale utente

HP ProDesk 400 G5 Manuale

Logitech

Logitech MK320 Manuale utente

Dell

Dell XPS 730 H2C Manuale utente

Sony

Sony Vaio Series Manuale utente

Sony

Sony VGC-LT32E - Vaio All-in-one Desktop Computer Manuale utente

Alto

Alto MD 250 Manuale utente

Lenovo

Lenovo ThinkCentre Edge 72 Manuale

Lenovo

Lenovo ThinkStation D20 Manuale

Arbor Technology

Arbor Technology FPC-7800 Series Manuale utente

Sony

Sony VAIO VGX-TP1 Series Manuale utente

Asus

Asus Eee Box B204 Manuale utente

Dell

Dell Optiplex 9010 All In One Manuale utente