7
5. Enrolling the TX 8000 Transmitter
To register the TX 8000 transmitter code on the AMT 8000 control panel, follow one of the options below:
First registration option
Insert the LITHIUM 3 Vdc battery - CR 2450. The sensor will be ashing the red LED, register the sensor code XAS 8000 in
the AMT 8000 control panel as follows:
Press the AMT 8000 control panel’s synchronization key (the blue indicative LED will be lit) then press the sensor’s syn-
chronization button, observing if the LED will ash green, indicating the correct registration. If the LED ashes red, the
registration was not performed and the procedure must be repeated.
Second registration option
Press the AMT 8000 control panel’s synchronism key (the blue LED indicator will be on) then insert the CR 2450 battery in
the sensor, observing if the LED will ash green, indicating the correct registration. If the LED ashes red, the registration
was not performed and the procedure must be repeated.
Note: after pressing the control panel’s synchronization button, the blue LED indicative of the control panel will remain
on for approximately 3 minutes after the last registration performed, after that time it will automatically turn off and it will
not be possible to perform new registrations until the sync is pressed again. If no device is registered, the control panel’s
LED will automatically turn off after 3 minutes.
The sensors will be addressed according to the sequence performed, Example: First sensor will be registered in zone 1, the
second sensor in zone 2, the third sensor in zone 3 and so on.
To perform the registration of other sensors through keyboard commands and more information, please consult the com-
plete manual of the AMT 8000 control unit.
5.1. Deleting sensor registration
If you want to delete the sensor registration, just press and hold the sensor’s synchronization key for approximately 10
seconds, watching the LED indicator until it ashes red twice.
Note: when physically erasing sensors, they must be erased from the control unit’s memory via programming.
01 to 64
Enter71Enter Zone N° +++
6. Identied the best location for installation
The TX 8000 transmitter has signal level indications for communication with theAMT 8000 control panel, this will help you
choose the best installation location. follow the procedure:
1. After duly registered, take the sensor to the environment you want to protect;
2. Once chosen, position the sensor in the exact location where it will be installed and carry out a transmission through an
opening and a closing, if the sensor is in a door or window for example, just open and close it.
Note: it is very important to check the LED status when opening and closing.
3. Observe the color that the LED will light up and check in the following table if the sensor can be installed in that location;
LED status communication level
Green Excellent signal level (recommended installation location)
Orange Regular signal level Not recommended location for installation (communication failure may occur)
Red No communication (Do not install on site)
4. If the signal level is not excellent, reposition the TX 8000 and perform the procedure again.
