Intelix REM-PACK-8 Installation Manual
www.intelix.com
5
Wiring with Twisted Pair and 18 Gauge Cable (Cabling
Schematic A)
When wiring with twisted pair cable and 18 gauge cable, please follow the steps
below.
Wiring the Physical Remotes
The REM-PACK-8 may be wired in several different configurations. The
following steps detail the most common configuration.
1) Open the REM-PACK-8 package(s) and verify you have all of the
components listed on page 3.
2) Noting the number of the CB-1000 remote control (each remote
control’s package is labeled 1, 2, 3, 4, 5, 6, 7, or 8), remove the
remote from its packaging. You will need to know the number of
each CB-1000 for programming.
3) Determine the single-gang electrical wallbox the CB-1000 will be
installed in. Verify twisted pair and 18 gauge cable are present.
Multiple runs of twisted pair and 18 gauge cable may be present if
IR/control and power are to be daisy-chained.
4) Terminate one pair (two conductors) of the twisted pair cable to
the three conductor phoenix-style wiring block. One conductor
should be in the far left (-) slot and one conductor should be in the
far right (+) slot. Connect the wiring block to the physical CB-
1000.
5) Terminate two conductors of the 18 gauge cable to the two
conductor phoenix-style wiring block. One conductor should be in
the top (-) slot and one conductor should be in the bottom (+) slot.
Connect the wiring block to the physical remote. (Multiple 18
gauge cables may be terminated to the phoenix-style wiring block
if the remote controls are to be daisy-chained).
Note: The CB-1000 is powered by a DC power supply. Polarity
is critical at the power supply and all the CB-1000 locations.
6) If remote programming and function have been determined, select
and replace the remote control’s button caps (see page 18).
7) Secure the remote control to the single-gang electrical wallbox
with the two included mounting screws.
8) Secure a decora plate over the remote control. Your remote control
is now installed.
9) Repeat steps 2-8 for each subsequent remote control.
