Page 3 of 36
GENERAL SAFETY RULES
1. Read and understand the entire instruction manual before operating the machine.
Know it’s limitations, as well as the specic potential hazards peculiar to it.
2. Make certain the machine is properly grounded.
3. Before operating the machine, remove ties, rings, watches other jewelry, and roll up
sleeves above the elbows. Remove all loose clothing and conne long hair. Do not
wear gloves.
4. Keep the oor around the machine clean.
5. Keep machine guards in place at all times when the machine is in use.
6. Do not overreach. Maintain a balanced stance at all times so that you do not fall or
lean against blades or other moving parts.
7. Make all machine adjustments or maintenance with the machine unplugged from the
power source.
8. Replace warning labels if they become obscured or removed.
9. Made sure the power source switch is in the OFF position before connecting the
machine to the power source
10.Make a habit of checking to see that the keys and adjusting wrenches are removed
before turning on the machine.
11. Keep belt guard and blade guards in place and in working order.
12.Failure to comply with all of these warnings could lead to serious injury.
POWER SOURCE WIRING
1. Before connecting, make sure the voltage is the same for both the machine and
the power source.The machine has been wired before shipment, and all electrical
information (such as voltage) indicated on the electrical instruction label.
2. Connect the power source wires to the “R.S.T.” connection points.The machine must
be properly grounded to prevent damage from electric shocks. (3 phase only)
3. After the power source wires have been connected, check to see if the wires are
connected to the correct points by the running direction of the left and right driving
belts. If the driving belts run in the correct direction, then the power source wires are
connected to the correct points. If the driving belts run in the opposite direction, cut
off the power source and change any two of the three power source wires to obtain
the correct running direction. (3 phase only)
