4
7. Warranty Information
One Year Limited Warranty
The quality controls used in the manufacture of this product will ensure your satisfaction.
This warranty applies only to the original purchaser of this product from an authorized
iSimple®dealer. This warranty covers any supplied or manufactured parts of this product that,
upon inspection by iSimple®authorized personnel, is found to have failed in normal use due
to defects in material or workmanship. This warranty does not apply to installation expenses.
Attempting to service or modify this unit, operating this unit under conditions other than the
recommended voltage will render this
WARRANTY VOID.
Unless otherwise prescribed by law, iSimple®shall not be liable for any personal injury, prop-
erty damage and or any incidental or consequential damages of any kind (including water
damage) resulting from malfunctions, defects, misuse, improper installation or alteration of
this product. All parts of this iSimple®product are guaranteed for a period of 1 year as follows:
Within the rst 12 months from date of purchase, subject to the conditions above, iSimple®
will repair or replace the product at our discretion, if it is defective in material or workmanship
providing it is returned to an Authorized iSimple®’ dealer, with PROOF OF PURCHASE from
an authorized iSimple®dealer.
Warning:
This equipment may be reset by unintentional electrostatic discharge during operation.
Exposure to direct sunlight or extreme heat may cause damage or malfunction.
FCC Class B Radio Frequency Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment gener-
ates, uses, and can radiate radio frequency energy and, if not installed and used in accor-
dance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
1. Re-orientate or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that of which the receiver
is connected.
4. Consult the dealer or an experienced radio / television technical for help.
Notice : The changes or modications not expressly approved by the party responsible com-
pliance could void the user authority to operate the equipment.
