JETWAY JBC38AZ02-2LU Manuale utente
Quick Installation Guide
NO: G03-JC38AZ02QIG-F
Rev: 1.0
Release Date: 2022-02-11
Notice:
The photos in this file are for illustration purpose only. The model may not be the latest version. Please refer
to the product you purchased for actual specification.
I/O Outlets:
Dimension and Outlines:
I. To Dissemble the Chassis
1. Put the system upon a stable platform with this side up, as the photo shows.
2. Locate the screws at the spots marked on this cover and unscrew them one by one to open the chassis.
3. Remove the screw in the marked spot on front panel.
4. Remove the screw in the marked spot on rear panel.
5. Lift the cover up to open the chassis.
6. The overview of the internal layout of the system.
II. To Install SO-DIMM to the Board
1. Locate the SO-DIMM slots on the board.
2. Insert the gold-figure side of the compatible SO-DIMM into the slot at a 30 degree angle. See to it that the
break of the module fit into the notch of the slot.
3. Press down to secure the SO-DIMM to the slot. The eject tabs will lock automatically if installing direction is
correct.
III.To Install M.2 E-key (2230) PCIe Card
1. Locate the M.2 E-Key, type-2230 slot on the board.
2. Remove the marked screw with a screwdriver.
3. Insert the gold-figure side of compatible M.2 PCIe card into the slot until the golden finger side fully emerged
into the slot.
4. Install the screw back to the original spot.
5. Locate the reserved antenna holes on the rear panel. Remove the dust-proof plugs on the marked spots from
the panel to install the antenna.
6. Push this antenna screw head into antenna hole of the rear panel from the backside of the panel.
6-1 6-2
The washer ①& the hexagonal screw nut ②.Push the washer ①through the antenna head.
7. And then lock the antenna screw head to the front side of the rear panel with the hexagonal screw nut②and
tighten it up.
8. Press the metal hat on the end of the antenna string to corresponding antenna slot on the card as showed.
9. Repeat step 6 to 8, to finish installation of the other antenna.
10. Connect the external Wi-Fi receiver antenna to the antenna screw head on the rear panel.
IV.To Install M.2 M-key (2242/2280) SATA Card
1. Locate the M.2 SATAslot on the board. System supports two types of M.2 M-Key card in different lengths
(2280/2242). Prepare compatible M.2 SATA card.
Questo manuale è adatto per i seguenti modelli
19
Altri manuali JETWAY PC industriale
