Kingwo NT09E Manuale utente
+-++
CatM1 NB loT Asset GPS Tracker
NT09E
User manual
1
Declaration
The contents of this manual is expected to be renewed from time to
time without prior notice; the updated content will be added to the new
version of this manual. KINGWO will improve or update the products or
procedures described in the manual at any time. If there is a description
of the product in the manual that does not match the actual product,
the actual product shall prevail. KINGWO has the final interpretation
rights of this manual.
2
1.1 Appearance
Enclosure
IP67 waterproof
Magnets
To stick the device to metal surface
Screw hole
To fix the device to any assets without metal
Power button
Inside the enclosure for hidden installation purpose,
to turn on or turn off device
Light sensor
To detect removal alarm remove the sticker on the
light sensor, when the device expose to light, it will
trigger a removal alarm
Type-C port
Used for recharge the device and configure the
device spec
Soft switch (Near USB port)
Press switch for 2 seconds while in work mode, the
red switch and green switch will fast blink 3 seconds,
then power off
Press switch for 2 seconds in power off mode, device
will be turned on and enter in work mode
Quick press the switch, blue LED on with balance
PART 01
Product Overview
3
battery level
Enclosure
IP67 waterproof
Magnets
To stick the device to metal surface
1.2 LED status
Cellular LED (Red)
Event
Status
Network connecting
Fast flash
Network connected
Slow flash
Module error
Solid on
Position LED(Green)
GPS position
Solid on
LBS position
0.5 seconds on, 0.5 seconds off
Wifi Position
2 seconds on, 2 seconds off
No position
Off
Charging LED( Blue)
100% charging
4 lights solid on
75%-80% charging
3 lights solid on and 1 light flash
56%-74% charging
3 lights solid on and 1 light off
50%-55% charging
2 lights solid on, 1 light off,1 light
flash
30%-49% charging
2 lights solid on, 2 lights off
25%-29% charging
1 lights solid on, 2 lights off,1 light
flash
10%-24% charging
1 lights solid on, 3 lights off
1%-9% charging
1 light flash,3 lights off
1.3 Product features summary
●No wired needed, easy for installation
●Built in G-sensor
●Temperature monitor
●12000mah rechargeable battery
●Battery can be last from 15 days to one year each full charge
●Ultra low consumption, decrease to 5uA below when in sleep mode
●Strong magnetic and screws installation
4
●Support tamper proof alarm
●Multiple position mode: GPS, Wifi,AGPS, LBS
●ibeacon
●Jamming detection
●IP67 waterproof
●Periodic tracking/Adaptive tracking/Movement based tracking/Sleep mode
1.4 Hardware parameters
Physical
Dimension
154mm*82mm*30mm（L*W*H）
Weight
350±5g
Cellular
Communication
module
Quectel BG95
Frequency
Working frequency:
Cat M1: LTE-FDD B1/B2/B3/B4/B5/B8/B12/B
13/B14/B18/B19/B20/B25/B26*/B27/B28/B
66/B85
• Cat NB2: LTE-FDD B1/B2/B3/B4/B5/B8/B12
/B13/B18/B19/B20/B25/B26*/B28/B66/B71/
B85
• EGPRS: 850/900/1800/1900MHz
protocol: Embedded TCP/IP stack
Sensitivity: -107dBm@850/900MHz
-106dBm@1800/1900MHz
Output power: Class 4 (2W)@850/900MHz
Class 1
(1W)@1800/1900MHz
GPRS data: GPRS Class 10, Mobile Station
Class B
GPS
Channels: 50
Sensitivity: -147dBm
Position accuracy:5-10m
Accuracy: 5m CEP
Cold start: <27s
5
Hot start: <1s
Processor
ST
Motion sensor
DA260
Wifi position
Wifi 4.0
Power
Battery
Rechargeable Lithium-ion battery and
（3.7V，
12000mAh）
and ultra-low discharge rate：less than 2%,
store
one months below 25℃
Power consumption
Average working current <50mA; Power save
current <40uA;
GSM antenna
Internal High Gain
GPS antenna
Internal High Gain
SIM
Microsim
Indicator
3 status LEDs,
Green: GPS, Red: Network, Blue: battery
Environm
ental
Paramete
r
Working Temperature
-30℃~ +80℃
Humidity
5% ~ 95% (no fog)
Ingress Protection
Rating
IP67
PART 02
Product Functions
6
2.1 Work modes
There are 3 working modes for NT09E: real time tracking mode、sleep mode、clock
mode.
Below is the explanation for work mode priorities:
●Real time tracking mode> Sleep mode>Clock mode
●The work mode which is equal can be replaced by each other, as the last
configuration will prevail
The default working mode is real time tracking mode( upload interval 30S), the data
packets information includes GPS status, longitude and latitude, cellular signal
Strength, satellite numbers, battery level etc,
2.1.1 Real time tracking mode
Mode
SMS Command
Set Real time
tracking mode
HC, <T1>, <T2>#；
For example:
HC,30,14400#
indicates device send data every
30S during movement, send
data every 14400S during static
Command description:
T1:Upload interval in
motion status,value5-1800
seconds,default 30seconds
T2: Upload interval in static
status, value 300-43200
seconds,default
14400seconds
Note:
Device judge whether it is still or moving by it’s G-sensor;
When the value of T2 is bigger than 3600 seconds, the communication module is
shut down after sleep, If T2 is less than 3600 seconds, the communication stays
online when enters the sleep state.
7
2.1.2 Sleep Mode
Configuration
SMS Command
Set sleep mode
HX,T#
For example
HX,1440# indicates device send data
every 1440 minutes
T：Upload interval
Unit: Minutes
Value range:
5-43200minutes
（2-30 days）
Note:
Device will not wake up during sleep mode even if it is in movement.
Device close GPS and communication module during sleep mode.
2.1.3 Clock mode
Configuration
SMS Command
Set clock mode
WAKEUP,T1,T2,T3,T4#
For example :
WAKEUP,0800,1000,1530,1900#
Device send data only at
08:00AM 、10:00AM 、
15:30PM、19:00PM
WAKEUP,0900,1900#
Device send data only at
09:00AM and 19:00PM
T1-T4 is time point,
format is HHMM, for
example 0800 indicates
08:00am
Delete clock mode
WAKEUP,#
Note:
When set clock mode, device will sleep except the clock time,during sleep ,Device
will not wake up even if it is in movement.
8
2.2 AGPS
When the device successfully registers on network, AGPS is available to speed up the
position speed and improve the position accuracy
2.2 AGPS
When the device successfully registers on network, AGPS is available to speed up the
position speed and improve the position accuracy
2.3 LBS
If device enters into the blind zone and GPS cannot be fixed, the device will switch to
LBS position, LBS provides the reference location which might not be accurate
2.4 Wi-Fi
The device has built in Wi-Fi Chip, it automatically connects to the WIFI hotspot
nearby and filter the hotspot info then select the WIFI hotspots with strongest signal,
the device will pack those hotspots info and saved into the packet that will be
uploaded, after the backend receives Wi-Fi information, it will interpret the WIFI info
and acquire the current location from the Wi-Fi database, The default setting is WIFI
priority, once it detects WIFI Hotspot, it will upload WIFI info only , and do not use
GPS, if WIFI is not detected, it will use GPS to position.
Kindly reminder: To use Wi-Fi feature, please make sure your software supports
Wi-Fi database
9
2.5 Blind data storage
When the device enter into blind zone when in sleep mode, it will store the trace
data according to the preconfigured time interval and it will upload the data in the
blind zone to the backend when the cellular network recovers
2.6 Temperature detection
The device built-in temperature sensor, it detects the temperature once the device is
turned on, then will read it every 16 seconds. The temperature accuracy 95%.
2.7 OTA commands from backend
Since the wake up of the device is normally short before enter into sleep mode, it is
hardly to receive SMS , to ensure the command sending efficiently, we suggest an
OTA commands to be sent from the platform, when the device is online, the backend
will automatic send this command, to make sure the commands is properly received.
2.8 Strong Magnetic and waterproof function
NT09E is with built-in with super strong magnet that can firmly stick the device to
the metal surface, it is easy to install and conceal, and the device is with waterproof
function, which can be installed on any assets that are outdoors
Indice
Altri manuali Kingwo GPS
Kingwo
Kingwo MT02S Manuale utente
Kingwo
Kingwo MT13 Manuale utente
Kingwo
Kingwo MT200 Manuale utente
Kingwo
Kingwo MT12 Manuale utente
Kingwo
Kingwo MT02S Manuale utente
Kingwo
Kingwo MT35 Manuale utente
Kingwo
Kingwo LT03 Manuale utente
Kingwo
Kingwo NT07E Manuale utente
Kingwo
Kingwo NT08E Manuale utente
Kingwo
Kingwo MT36 Manuale utente
