komodo KD42LPFDGFRZA Manuale utente
42L Portable AC/DC Fridge & Freezer
KD42LPFDGFRZA
Quick Start Guide
Product Feature
•High efficiency, low energy consumption.
•Multi-voltage system DC (12 and 2 Volt )
•Adjustable battery protection helps protect your battery (DC only).
Safety In truction
•Warning: Do not use your unit if any cabling is damaged, frayed or there is
•exposed wiring.
•Warning: Do not attempt or continue to operate your unit if it is wet.
•When using unit, ensure the circuit being used has a fuse or circuit breaker.
Recommended size for DC 12 Volt is 15 Amp, DC 2 Volt is 7.5 Amp.
•Make sure the voltage is within the correct range for socket and cable being used. The
technical data label on the side of the unit shows the voltage ranges.
•Do not place any electrical devices inside the refrigerator as they may be damaged.
Note on u ing the product
•Your unit requires good ventilation, especially around the back of the refrigerator; allow
a gap of at least 100mm around all sides.
•Do not allow a large amount of frost to build up on the inside walls as this may impair
cooling. Defrost by turning the unit off, allowing the frost to melt and wiping out the
water.
•The lower the ambient temperature, the lower the power usage. In order to maximize
efficiency, keep the unit in a cool location out of direct sunlight.
•It is recommended to operate the unit on a flat surface, but it will operate at angles up
to 30°.
Operation Specification
•Battery Protection: Selecting the Low, Med, High positions of the switch (next to the DC
power socket), you can choose different levels for battery protection.
•Press the button UP or DOWN button to adjust the temperature the unit aims to △ ▽
achieve. Press the button to increase or the button to decrease the temperature.△ ▽
•When you press the“SET” buttons, it switches the display between °C and °F.
•Press the “SET” button to enter economy running mode, the ECO indicator green LED
light will be on. Press the button again; the unit will enter the maximum running mode
(HH) MAX indicator red LED light will be on.
•The economy mode runs the compressor at a lower speed to save power; the maximum
mode runs the compressor at a higher speed increasing power usage. Maximum mode is
useful if the ambient temperature is over 30°C or fast cooling is required.
•Plug in the DC power. Press the button ON/OFF to turn the unit on. The LED display on
the control panel will turn on and the interior temperature is displayed.
•If the power supply is cut off or disconnected, the unit will switch off automatically and
once the power supply is restored it will automatically switch back on.
Battery Protection
You can choose from 3 levels of battery cut-out, which allows you to control the cut-out
voltage.
•If you are running directly from your car's starter battery, set the control to “high” so
you don't flatten your battery to the point where you can't start the car again.
•If you have a dual battery system or are running the fridge from your own battery, you
should set the control to “low”, which will allow the fridge to operate for longer before
cutting-out.
Cleaning and Maintenance
•Clean the appliance inside and out with a clean damp cloth every week. If it is dirty, use
sodium bicarbonate dissolved in lukewarm water to clean the unit.
•Never use abrasive products, detergents or soap. After cleaning, wipe out with a clean
damp cloth and dry carefully.
•Do not store food inside unit if the unit is not on.
•Do not store the unit if it is wet inside or without leaving the lid open.
•Never clean the unit under running water or in dish water. Do not use abrasive cleaning
agents or hard objects during cleaning as these can damage the unit.
Trouble hooting
The unit i not turning on
•Check whether the unit has been turned on.
•Check the power supply (try a different power source, i.e. different vehicle or power
socket).
•Check whether the plug and the socket have a good connection.
•Check whether the fuse has been burned out or blown.
Low refrigeration performance
•Too much food produce been placed inside the unit.
•There is too much warm produce inside the unit.
•The lid is unlatched and/or open.
•The lid seal is broken.
•Problems arising from poor ventilation (ensure at least 100mm of space around all
sides).
•The ambient temperature is too high.
•The temperature setting is too high.
Can hear the ound of running water from in ide the unit
•This is normal, due to the flow of refrigerant in the unit.
Unu ual noi e when refrigerator i working
•The refrigerator is not placed on a level surface
Freezer cannot be et lower than 5 degree , or not down to -20 degree
Please press and hold the SET button for 10 seconds until a beep is heard and the code “E1” is
shown on the display. Now you can set the arrows to select the lower limit of the temperature
control. Continue to press down until -20 is shown, then press the SET button.
The code “E2” will then be shown. You can now set the upper limit, which should be 10, then
press SET. The fridge/freezer will now return to normal functionality.
If you have any other i ue or querie regarding the unit, plea e contact
the Kogan cu tomer upport team.
Altri manuali komodo Frigorifero
