Kuppersbusch EDIP 678.0 Manuale utente
Technical Manual
EDIP 678.0 / EDIP 679.0
Customer Service
GB
H5 - 60 - 02 - 01
Responsible: K.H. Hiby Küppersbusch Vertriebsges. mbH
Tel.: (0209) 401-732 Kundendienst
Fax: (0209) 401-743 Postfach 100 132
Date: 27.05.1998 45801 Gelsenkirchen
List of contents
1. General notes 4
2. Description of control: EDIP 678.0 - EDIP 679.0 5
3. Modes of operation 6
3.1 Switching on 6
3.2 Manual mode 7
3.3 Automatic mode 7
3.4 Switching over between manual/automatic mode 7
3.5 High-speed setting 7
3.6 Intermittent ventilation 7
3.7 Switching off 8
3.8 Lighting 8
3.9 Ultrasonic control 9
3.10 Sensor sensibility 10
4. Filters: Dismantling and installation 11
5. Appliance installation and dismantling: 12
5.1 Dismantling/installation of lamp cover 13
5.2 Replacing the starter 14
5.3 Replacing the charcoal filter 14
5.4 Inserting the anti-flooding shutter 14
5.5 Distance to hob 15
6. Test programs 16
7. Wiring diagrams 18
Technical Manual EDIP 678.0 / EDIP 679.0 3
For internal use only
1. General notes
The cooker hood needs a sufficient and correct supply of air to achieve an optimum
effect and maximum ventilation efficiency. If not enough fresh air is supplied, the
speed of the fan motor increases, the air throughput decreases and the noise level
rises.
When the filter mats are saturated, the air throughput of the cooker hood decreases
and the vapours are only cleaned to an inadequate extent.
Caution! When the hood is being installed, the distance between the lower edge of
the hood and the cooker must be at least 650 mm for gas cookers and at least
430 mm for electric cookers.
The cooker hoods EDIP 678.0 and EDIP 679.0 are intended for installation in a top
cupboard.
4 Technical Manual EDIP 678.0 / EDIP 679.0
For internal use only
2. Description of control:
EDIP 678.0 - EDIP 679.0
Control in one piece in the front pull-out drawer
2. Motor ON/OFF with sliding switch or
by pulling out/pushing in the drawer
3. Fat filter saturation display after 40 hours
(Reset switch on front left of drawer)
4. Control line with two yellow markings
1st marking on front input cable duct at bottom
2nd marking output cable duct at top
Note: If these markings are not observed, the drawer
either cannot be pushed in fully
or pulled out fully.
Technical Manual EDIP 678.0 / EDIP 679.0 5
For internal use only
3. Modes of operation
The appliance offers you the possibility of switching the fan to the setting you want
by hand or to select fully automatic operation, i.e. the cooker hood regulates the fan
setting automatically, depending on the cooking process involved.
3.1 Switching on
Pull out filter drawer with the handle and select the mode Manual or Automatic,
whichever you want:
1 Automatic display 6 Activated charcoal filter saturation
display
2 Intermittent ventilation display 7 Light On or Off switch
3 Setting display 1 - 4 8 Automatic/Manual switch
4 High-speed setting display 9 Program selector switch
5 Fat filter saturation display 10 Fan/Intermittent ventilation
Off switch
6 Technical Manual EDIP 678.0 / EDIP 679.0
For internal use only
3.2 Manual mode
When the button is pressed, the fans are activated at setting 3; this is indicated
on the LED display. By pressing the button again, setting 4 and the high-speed
setting can be selected; by activating the button, the fans can be turned down to
lower settings. The setting selected is shown in each case. The automatic display
does not come on.
3.3 Automatic mode
If the button is pressed once, the cooker hood is switched to automatic mode,
the A-lightcomes on. Fan setting 1 is the lowest setting and is always switched on. The
sensor probe checks the volume of steam and, when necessary, switches the fans
in increments up to the necessary setting. Thefan setting is regulated accordingly if
the steam volume changes.
FThe automatic function is only operable with the filter drawer pulled out.
3.4 Switching over between manual/automatic mode
When the button is activated, you can switch over from manual to automatic
modeandviceversa.
3.5 High-speed setting
At the high-speed setting the fans run with a greater air throughput.
It is switched on by pressing the button. The high-speed setting can be
switched off again by pressing the button or it switches itself off again
automatically after 10 minutes, i.e. ,
Fin manual mode to setting 3
Fin automatic mode to the setting determined by the sensor.
3.6 Intermittent ventilation
When intermittent ventilation is switched on, the fans run automatically after 55 minutes
at the lowest setting for about 5 minutes. This results in continuous ventilation of the
kitchen, e.g. also during the night. This is indicated by the light coming on.
FIntermittent ventilation only operates with the filter drawer pushed in.
FIntermittent ventilation can always remain activated.
Technical Manual EDIP 678.0 / EDIP 679.0 7
For internal use only
3.7 Switching off
The appliance can be switched off in various ways:
1. Switching off without automatic delayed stop
Press button,
intermittent ventilation is also switched off.
2. Switching off with automatic delayed stop
Push filter drawer right in full. The fans continue to run for about another
10 minutes at the setting last selected.
To switch on again, the filter drawer must be pulled out again.
The intermittent ventilation remains switched on.
If the high-speed setting is to be switched on when the filter drawer is pushed in,
automatic reset takes place during the delayed-stop time.
Manual mode at setting 3.
Automatic mode to the required setting but at least to setting 1.
3.8 Lighting
The lighting can be used at any time even when the fans are switched off or the filter
drawer is pushed in.
Saturation displays for:
Fat filter
FAn operating hour counter counts the operating time and after about
40 hours the LED comes on.
Charcoal filter
FAfter an operating period of 240 hours the LED comes on.
8 Technical Manual EDIP 678.0 / EDIP 679.0
For internal use only
3.9 Ultrasonic control
This control has 3 elements consisting of:
–Operation section (in the filter pull-out drawer)
–Control section (above the air guide housing)
–Sensor (in the filter pull-out drawer)
In the case of repairs the control section and sensor are to be replaced together
as these two components are matched to each other.
An ultrasonic sensor measures the change in the air density. This change can be
caused by:
–rising sources of heat
–vapours formed by the cooking process
The cooker hood control adapts the fan speed to the cooking process in line with the
sensor pulses.
The ultrasonic frequency is 200 kHz; it is thus 10 times above the hearing range
of domestic animals.
Technical Manual EDIP 678.0 / EDIP 679.0 9
For internal use only
3.10 Sensor sensitivity
The filter pull-out drawer accommodates a potentiometer to adjust the sensitivity of
the sensor.
It is supplied in the maximum setting (turned fully to right) as the optimum for electric
hobs. For operation above gas hobs, it is recommended to turn the potentiometer
back half a revolution (anticlockwise).
For complaints about automatic mode
–Control operates too slowly
–Activation in too high fan settings
the pulse number for the control can be adjusted. As a starting position, turn the
potentiometer clockwise right to the stop.
After dismantling the front filter, the adjustment feature is accessible.
If the cooking hood is switched on in this condition, the red LED flashes.
10 Technical Manual EDIP 678.0 / EDIP 679.0
For internal use only
Questo manuale è adatto per i seguenti modelli
1
Indice
Altri manuali Kuppersbusch Frigorifero
Kuppersbusch
Kuppersbusch KE3800-0-2T Manuale utente
Kuppersbusch
Kuppersbusch FKG9500.0I Manuale operativo
Kuppersbusch
Kuppersbusch IKE3390-1 Manuale utente
Kuppersbusch
Kuppersbusch KE 680-1-3T Manuale utente
Kuppersbusch
Kuppersbusch FKU1540.0i Manuale operativo
Kuppersbusch
Kuppersbusch KS 881 Manuale utente
Kuppersbusch
Kuppersbusch ITE 128 Series Manuale utente
Kuppersbusch
Kuppersbusch IKE1660-1 Manuale utente
Kuppersbusch
Kuppersbusch IKF 249-5 Manuale utente
Kuppersbusch
Kuppersbusch KE3800-1-2T Manuale utente
Kuppersbusch
Kuppersbusch KE 650-2-2T Manuale utente
Kuppersbusch
Kuppersbusch FK2500.0i Manuale operativo
Kuppersbusch
Kuppersbusch IKE 188-5 Manuale utente
Kuppersbusch
Kuppersbusch KE 9600-1-2T Manuale
Kuppersbusch
Kuppersbusch IKE 458-5-4T Manuale utente
Kuppersbusch
Kuppersbusch KSG 88 Manuale utente
Kuppersbusch
Kuppersbusch KS 882 Manuale utente
Kuppersbusch
Kuppersbusch IKE 159 series Manuale utente
Kuppersbusch
Kuppersbusch KSG882 Manuale utente
Kuppersbusch
Kuppersbusch IKE 178-5 Manuale utente
