Kyocera Ci1000 Manuale utente
Operating Instructions for the Ci1000 Color
Printer
FINAL Draft August 6, 1998
i General
(FCC) and Safety Information
General
Warning
• To prevent fire or shock hazard, do not expose this product to rain or any type
of moisture.
Caution
• Do not open covers and do not attempt to repair the unit yourself. Refer
servicing to qualified personnel.
Power source
Warning
• The power source voltage of this unit is listed on the nameplate. Only plug the
unit into an outlet with the proper voltage.When you operate this equipment,
the outlet should be near the equipment and accessible.
• To ensure safe operation the AC cord supplied must be inserted into standard
three-prong AC outlet which is effectively grounded (earthed) through the
normal wiring.
• The fact that the equipment operates satisfactorily does not imply that the
power point is grounded(earthed) and that the installation is completely safe.
For your safety, if in any doubt about the effective grounding (earthing) of the
power point, consult a qualified electrician.
• If the plug cannot be inserted into the AC outlet, contact a licensed electrician
to replace the outlet with a properly grounded (earthed) one. Do not defeat the
purpose of the grounding (earthing) plug (ex. do not use a conversion plug).
Laser safety
Caution
• This printer utilizes a laser. Use of controls or adjustments or performance of
procedures other than those specified here may result in hazardous radiation
exposure.
For Your
Safety
ii General
Ozone release
Warning
• Make sure that the printer is installed in a well ventilated room so as not to
increase density of ozone in the air. Since ozone is heavier than air, it is
recommended that air at floor level be ventilated.
Moving the unit
The printer weighs approximately 47.9 kg {105.5 lb}. It must be handled by two
people.Turn the power off and remove the power cord when handling the unit.
iii General
Caution labels
ATTENTION:
SURFACE
CHAUDE
CI-INTERIEUR
VORSICHT:
HEISSE FLÄCHE
INTERN
ATENCION:
SUPERFICIE
CALIENTE
EN EL INTERNO
CAUTION:
HOT SURFACE
INSIDE
CAUTION:
HOT SURFACE INSIDE
CAUTION:HOT SURFACE BELOW
ATTENTION:SURFACE CHAUDE CI-DESSOUS
VORSICHT:HEIßE OBERFLÄCHE DARUNTER
ATENCION:SUPERFICIE CALIENTE ABAJO
CLASS
KLASSE
CLASSE
CLASE
1 LASER PRODUCT
1 LASER PRODUKT
1 LASER PRODUIT
1 LÁSER PRODUCTO
ATTENTION:
Rayonnement laser invisible
dangereux en cas
d'ouverture et lorsque
la sécurité est neutralisée.
EXPOSITION DANGEREUSE
AU FAISCEAU.
VARNING:
Osynlig laser-
strålning när denna
del är öppnad och
spärrar är
urkopplade.
STRÅLEN
ÄR FARLIG.
VARO!:
Näkymätöntä
avattaessa ja
suojalukitus
ohitettaessa olet
alttiina lasersäteilylle.
ÄLÄ KATSO
SÄTEESEEN.
VARNING:
Osynlig laserstrålning
när denna del är
öppnad och spärren är
urkopplad.
BETRAKTA EJ
STRÅLEN.
ADVARSEL:
Usynlig laserstråling
ved åbning når
sikkerhedsafbrydere
er ude af funktion.
UNDGÅ
UDSÆTTELSE FOR
STRÅLING.
PELIGRO:
Cuando se abre y se
invalida el bloqueo, se
producen radiaciones
invisibles de láser.
EVÍTESE LA
EXPOSICIÓN
A TALES RAYOS.
DANGER:
Invisible laser radiation
when open and interlock
defeated.
AVOID DIRECT
EXPOSURE TO BEAM.
CAUTION:
Invisible laser radiation
when open and
interlocks defeated.
AVOID EXPOSURE
TO BEAM.
VORSICHT:
Unsichtbare Laserstrahlung,
wenn Abdeckung geöffnet
und Sicherheitsverriegelung
überbrückt.
NICHT DEM STRAHL
AUSSETZEN.
ADVARSEL:
Usynlig laserstråling
når deksel åpnes og
sikkerhedslas brytes.
UNNGÅ
EKSPONERING
FOR STRÅLEN.
(220-240 VAC equipment)
Laser diode properties
Laser output : 5 mW max
Wavelength : 780 nm
Emission duration : Continuous
iv General
FOR USERS IN U.K.
IMPORTANT:
FOR YOUR SAFETY PLEASE READTHE FOLLOWING TEXT
CAREFULLY
This printer is supplied with a moulded three pin mains plug each for your safety
and convenience. A 13 amp fuse is fitted in this plug. Should the fuse need to be
replaced please ensure that the replacement fuse has a rating of 13 amps and that
it is approved by ASTA or BSI to BS 1362.
Check for the ASTA mark or the BSI mark on the body of the
fuse.
If the plug contains a removable fuse cover you must ensure that it is refitted when
the fuse is replaced. If you lose the fuse cover the plug must not be used until a
replacement cover is obtained. A replacement fuse cover can be purchased from
your local Panasonic Dealer.
IFTHE FITTED MOULDED PLUG IS UNSUITABLE FOR THE SOCKET
OUTLET IN YOUR HOME THEN THE FUSE SHOULD BE REMOVED
ANDTHE PLUG CUT OFF AND DISPOSED OF SAFELY.THERE IS A
DANGER OF SEVERE ELECTRICAL SHOCK IFTHE CUT OFF PLUG IS
INSERTED INTO ANY 13 AMP SOCKET.
If a new plug is to be fitted please observe the wiring code as shown below. If in
any doubt please consult a qualified electrician.
WARNING:THIS APPLIANCE MUST BE EARTHED.
IMPORTANT: The wires in this mains lead are coloured in accordance with the
following code.
Green-and-Yellow: Earth Blue: Neutral Brown: Live
ASA
v General
As the colours of the wire in the mains lead of this appliance may not correspond
with the coloured markings identifying the terminals in your plug, proceed as
follows.
The wire which is coloured GREEN-AND-YELLOW must be connected to the
terminal in the plug which is marked with the letter E or by the Earth symbol
, or coloured GREEN or GREEN-AND-YELLOW.
The wire which is coloured BLUE must be connected to the terminal in the plug
which is marked with the letter N or coloured BLACK.
The wire which is coloured BROWN must be connected to the terminal in the
plug which is marked with the letter L or coloured RED.
How to replace the fuse: Open the fuse compartment with a screwdriver and
replace the fuse.
.
FOR USERS IN AUSTRALIA
This mark shows that the product complies with AS/NZS 3548.
LN
vi General
Contents
For Your Safety
General
i
Power source i
Laser safety i
Ozone release ii
Moving the unit ii
Caution labels iii
FOR USERS IN U.K. iv
FOR USERS IN AUSTRALIA v
Chapter 1: Before You Start
Cautions
1-1
CD-ROM 1-2
Static electricity damage 1-3
Interface cable 1-3
Waste disposal method 1-3
System requirements
1-4
With a Windows computer 1-4
With a Macintosh computer 1-4
Features of the Ci1000
1-5
High quality 1-5
High speed 1-5
Easy operation 1-5
Networking and client capabilities 1-5
Color capabilities 1-6
Color management 1-6
Fiery WebTools 1-7
Minimum space requirements
1-7
Power source
1-8
Unpacking
1-8
viii Contents
Part names
1-9
Front side view 1-9
Rear side view 1-9
Control panel overview
1-10
Activity Lights 1-10
Buttons 1-10
Chapter 2: Printer Setup
Setting up the printer
2-1
Preparing the imaging unit 2-1
Setting up the output tray 2-2
Installing the toner cartridges 2-3
Loading media 2-5
Connecting the printer to a computer 2-7
Using a parallel interface cable 2-8
Using the control panel
2-15
Status messages 2-15
Error messages 2-16
Top-level menus 2-16
Printing pages from the control panel 2-18
Chapter 3: Connecting the Printer to a Network
Network connections
3-1
Ethernet network connections 3-1
Token Ring network connections 3-3
Parallel cable connection
3-3
Setting up TCP/IP printing
3-4
Setting up the printing environment 3-5
UNIX server print queues 3-5
Verifying theTCP/IP network connection 3-9
Setting upTCP/IP clients for printing 3-10
Setting upTCP/IP clients for running Fiery WebTools 3-11
Printing and administering print jobs 3-11
Altri manuali per Ci1000
1
Indice
Altri manuali Kyocera Stampante
Kyocera
Kyocera ECOSYS M6230cidn Manuale utente
Kyocera
Kyocera FS-1300D Manuale utente
Kyocera
Kyocera ECOSYS P6035cdn Manuale utente
Kyocera
Kyocera Ecosys P2235dw Manuale di istruzioni
Kyocera
Kyocera ECOSYS MA4000cifx Manuale di installazione e funzionamento
Kyocera
Kyocera PA2000w Manuale di istruzioni
Kyocera
Kyocera KM-4800w Manuale utente
Kyocera
Kyocera ECOSYS FS-C5400DN Manuale utente
Kyocera
Kyocera ECOSYS P2135dn Manuale utente
Kyocera
Kyocera FS-C8026N Manuale utente
Kyocera
Kyocera PA2000w Manuale utente
Kyocera
Kyocera ECOSYS FS-C8650DN Manuale utente
Kyocera
Kyocera KM-2560 Manuale utente
Kyocera
Kyocera TASKalfa 8353ci Manuale utente
Kyocera
Kyocera KYOCERA FS-C8100DN Manuale utente
Kyocera
Kyocera Laser Printing ELP Manuale utente
Kyocera
Kyocera TASKalfa 8353ci Manuale utente
Kyocera
Kyocera DP-3600 Manuale
Kyocera
Kyocera TASKalfa 3051ci Manuale utente
Kyocera
Kyocera Taskalfa Pro 15000c Manuale utente
