Lafayette EZ-Charge V2 Manuale di installazione
EZ-Charge V2
Mul-Channel Remote
FCC Compliance
This device complies with Part 15 of the FCC Rules. Operaon is subject to the following two condions
[1] This device may not cause harmful interface, and
[2] This device must accept any interference received, including interference that may cause undesired op-
eraon.
Package Contents
1 x 15 channel remote
1 x magnec holder including wall xing screws
1 x 3V CR2450 baery
For Motorizaon Technical Support call 877-548-0612
EZ-Charge Programming Instructions
Installaon
Wall Mount Holder
Remove cover from base by prying with at
head screwdriver
Used supplied fasteners and anchors to
aach the base to the wall
Replace cover by pressing snap latches into
place.
Baery
Remove cover from remote press gently in
and down to disengage cover.
Install baery with posive (+) side facing
up.
For Motorizaon Technical Support call 877-548-0612
Programming
Pairing Motor to a Remote
Select channel on controller Hold P1 buon on the motor head
for 1 jog
Hold STOP on controller
Motor Response Motor Response
Check Motor Direcon
To check travel direcon of shade, press UP
or DOWN on controller.
To reverse shade direcon, hold both UP
and DOWN.
Motor Response
Seng Limits
Move shade to desired highest or lowest
posion by pressing the UP or DOWN
buons
Holding DOWN will make the shade travel.
Pressing DOWN buon moves the shade in
small movements. You must press the
STOP buon if the shade is traveling.
Holding UP will make the shade travel.
Pressing UP buon moves the shade in
small movements. You must press the
STOP buon if the shade is traveling.
Once you are at your upper limit, hold UP and
STOP.
Once you are at your lower limit, hold DOWN
and STOP.
DONE!
For Motorizaon Technical Support call 877-548-0612
Adjusng Upper Limit
You can do this at ANY posion. Shade does not need to be at the current upper limit.
Hold UP and STOP on the
controller.
Move shade to desired
posion
Hold UP and STOP on the
controller.
Adjusng Lower Limit
You can do this at ANY posion. Shade does not need to be at the current lower limit.
Hold DOWN and STOP on
the controller.
Move shade to desired
posion
Hold DOWN and STOP on
the controller.
Copy / Delete channels
Hold P1 buon on the motor
head for 1 jog.
Select channel you wish to
add or delete
Hold the STOP buon on the
controller
Delete All Sengs
Hold P1 on the motor head
for 4 connuous jogs
For Motorizaon Technical Support call 877-548-0612
Favorite Posion
You will need to put a motor to sleep if you are going to program mulple shades on the same channel or adjust a limit for a
specic shade on a group channel. To wake the shade up just press and release the P1 motor head buon.
Hold P1 on the motor head
for 2 connuous jogs
Pung motor to sleep
Move shade to the desired favorite posion
Remove baery door on remote.
Press and release P2 on the upper
le corner. The shade will jog once.
Press and release the STOP
buon on the controller
and the shade will jog
Press and release the STOP
buon on the controller
and the shade will jog
For Motorizaon Technical Support call 877-548-0612
Tilt Mode
Hold UP and DOWN on the
controller for 1 jog
Hold UP and DOWN on the
controller for 1 jog
In this mode if you just press and release a direcon the shade will only move in small increments. This is nice for the Transional
shades. If you want the shade to travel all the way up or all the way down , press and HOLD that direcon. To exit this mode and
revert back to Roller Mode, do the same steps.
Adjusng Motor Speed
Remove baery door on remote.
Press and release P2 on the upper
le corner. The shade will jog once.
Press UP shade will make 1
jog
Press UP shade will make 2
jogs
To Increase speed
Press DOWN shade will
make 1 jog
Press DOWN shade will
make 2 jogs
To decrease speed
For Motorizaon Technical Support call 877-548-0612
EZ-Charge V2
Surface Mounted Wireless Wall Switch
FCC Compliance
This device complies with Part 15 of the FCC Rules. Operaon is subject to the following two condions
[1] This device may not cause harmful interface, and
[2] This device must accept any interference received, including interference that may cause undesired op-
eraon.
Package Contents
1 x Switch
1 x Single gang Decora style wall plate (incl 2 mounng screws)
1 x 3V CR2430 baery
For Motorizaon Technical Support call 877-548-0612
Installaon
Wall Mount Holder
Open rear baery cover by gently separang
switch covers with screwdriver
Install CR2430 baery with posive side facing
up. Snap covers back together.
Baery
For Motorizaon Technical Support call 877-548-0612
Used supplied fasteners and anchors as
needed to aach base.
Programming
Pairing Motor to a Remote
Select channel on controller Hold P1 buon on the motor head
for 1 jog
Hold STOP on controller
Motor Response Motor Response
Check Motor Direcon
To check travel direcon of shade, press UP
or DOWN on controller.
To reverse shade direcon, hold both UP
and DOWN.
Motor Response
Seng Limits
Move shade to desired highest or lowest
posion by pressing the UP or DOWN
buons
Holding DOWN will make the shade travel.
Pressing DOWN buon moves the shade in
small movements. You must press the
STOP buon if the shade is traveling.
Holding UP will make the shade travel.
Pressing UP buon moves the shade in
small movements. You must press the
STOP buon if the shade is traveling.
Once you are at your upper limit, hold UP and
STOP.
Once you are at your lower limit, hold DOWN
and STOP.
DONE!
For Motorizaon Technical Support call 877-548-0612
Adjusng Upper Limit
You can do this at ANY posion. Shade does not need to be at the current upper limit.
Hold UP and STOP on the
controller.
Move shade to desired
posion
Hold UP and STOP on the
controller.
Adjusng Lower Limit
You can do this at ANY posion. Shade does not need to be at the current lower limit.
Hold DOWN and STOP on
the controller.
Move shade to desired
posion
Hold DOWN and STOP on
the controller.
Copy / Delete channels
Hold P1 buon on the motor
head for 1 jog.
Select channel you wish to
add or delete
Hold the STOP buon on the
controller
Delete All Sengs
Hold P1 on the motor head
for 4 connuous jogs
For Motorizaon Technical Support call 877-548-0612
Indice
Altri manuali Lafayette Telecomando
