C2000 Debugger | 3
©1989-2023 Lauterbach
SYStem.Mode Establish the communication with the target 48
SYStem.Option.AHBHPROT Select AHB-AP HPROT bits 49
SYStem.Option.AXIACEEnable ACE enable flag of the AXI-AP 49
SYStem.Option.AXICACHEFLAGS Configure AXI-AP cache bits 50
SYStem.Option.AXIHPROT Select AXI-AP HPROT bits 50
SYStem.Option.DAPDBGPWRUPREQ Force debug power in DAP 51
SYStem.Option.DAPNOIRCHECK No DAP instruction register check 51
SYStem.Option.DAPREMAP Rearrange DAP memory map 52
SYStem.Option.DAPSYSPWRUPREQ Force system power in DAP 52
SYStem.Option.DEBUGPORTOptions Options for debug port handling 53
SYStem.Option.ExecutionMode Sets the CPU execution mode 54
SYStem.Option.IMASKASM Disable interrupts while single stepping 54
SYStem.Option.IMASKHLL Disable interrupts while HLL single stepping 54
SYStem.Option.TargetServer Use target server from Texas Instruments 55
SYStem.RESetOut Reset target without reset of debug port 55
TrOnchip Commands ........................................................................................................ 56
TrOnchip.state Display on-chip trigger window 56
TrOnchip.RESet Set on-chip trigger to default state 56
ERAD Commands .............................................................................................................. 57
ERAD Embedded real-time analysis and diagnostic module 57
ERAD.OFF Turn ERAD features off 57
ERAD.ON Turn ERAD features on 57
JTAG Connection .............................................................................................................. 58
Mechanical Description of the 20-pin Debug Cable 58
Electrical Description of the 20-pin Debug Cable 59
Mechanical Description of the TI Connector 60
FAQ ..................................................................................................................................... 60
Operation Voltage ............................................................................................................. 61
