2.0 AUTO GLIDE MECHANICAL INSTALLATION
6
TM
2.3 Auto Glide Control Box Installation
AUTO GLIDE
o
0
o
15
o
-15
BOW
STERN
o
0o
15
o
-15
PORT STARBOARD
TM
Determine where the Auto Glide control box will be installed.
- MUST BE INSTALLED ON A VERTICAL SURFACE WITH THE CONNECTOR FACING STERN (REAR OF
THE BOAT)! The top of the control box (sticker side) can face either port (left) or starboard (right). If a port or
TM
starboard vertical surface is not accessible, an optional Auto Glide control box mounting bracket is available. (See
section 2.4 below.)
o
- Install level. A 15 (+/-) tolerance in all directions is allowed. (See Figure 2.3.1)
TM
- Install within 4’ (1.21m) of the Auto Glide Key Pad. (If key pad must be installed further than 4’ use a CANBUS
Extension Cable 30260-XXX Series. See price list for different lengths.)
- Control box mounting hardware to be supplied by customer.
NOTE: DO NOT CONNECT POWER TO AUTO GLIDE CONTROL BOX AT THIS TIME
WARNING
!
Before drilling, make sure the mounting hardware will
not damage any existing wiring, structures, or hoses.
DO NOT CONNECT TO POWER AT THIS TIME.
CAUTION
Please read through the instructions in their entirety
prior to beginning installation! Proper function of this
product cannot be assured unless you follow these
instructions.
CAUTION
Figure 2.3.1
TM
2.4 Optional Auto Glide Control Box Mounting Bracket Installation
TM
Determine where the optional Auto Glide control box mounting bracket (Part # 70568-001) will be installed.
- L SHAPE MUST BE INSTALLED FACING EITHER PORT (LEFT) OR STARBOARD (RIGHT)! THE CONTROL
BOX MUST BE MOUNTED WITH THE CONNECTOR FACING STERN (REAR OF THE BOAT)! Top of the control
box (sticker side) can face either port or starboard. (See Figure 2.4.2 for some installation examples)
o
- Install level with the boat. A 15 (+/-) tolerance in all directions is allowed. (See Figure 2.3.1)
TM
- Install within 4’ (1.21m) of the Auto Glide key pad.
- Mounting bracket & control box mounting hardware included.
o
0o
15
o
-15
PORT STARBOARD
To remove existing control box:
- Disconnect control box from power.
- Disconnect control box from actuators.
- Disconnect control box orange wire from tach or mechanical on / off switch.
- Remove two mounting screws and remove box from boat.
- See section 2.3 above for Auto Glide Control Box installation instructions.
2.5 Replacing Existing 123 / 123DR LED Indicator / 124 Standard Control Box
Figure 2.4.1 Figure 2.4.2
6”
8” 2”
Rev 03-10-11
