LENCO IPD-4100 Series Manuale utente
Page 1 of 16
English
IPD-4100 Series iPod Speaker Dock with FM radio
User Guide
For information and support, www.lenco.eu
IMPORTANT: Please read all instructions carefully before use and keep for future reference
Page 2 of 16
Thank you for choosing this Lenco iPod Speaker Dock with FM Radio. Not only can it receive
radio stations, but you can also listen to your favourite tracks on your iPod and charge it up.
It’s really simple to use; you can fully operate your iPod from the control panel on the top or
from the remote control, and even connect another auxiliary device to it.
Throughout this User Guide, the iPod Speaker Dock with FM Radio will be referred to as the
Speaker Dock.
Safety is important
Use of any electrical equipment should be undertaken with care. Please read the safety section on Page 15
before using your iPod Speaker Dock. This appliance is for household use only.
Made for
iPod
An audio s ystem th at allows docking of
an iPod an d which fully supports the iPod
me nu system.
iPod Speaker Dock
Any iPod can be connected to the Speaker Dock, which allows all your songs to be played
through the speakers. The Speaker Dock features high quality speakers and a built in Subwoofer
to produce a high quality output. In addition, your iPod will charge while connected.
FM Radio
The Speaker Dock features an FM Radio allowing you to listen to all your favourite radio stations.
Up to 20 stations can be saved to memory for ease of use.
Page 3 of 16
Page 4 of 16
Page 5 of 16
Page 6 of 16
1.Setting up the iPod Speaker Dock
Insert the Mains Plug into a suitable wall socket and turn the socket on.Turn the ON/OFF Switch
at the rear of the Speaker Dock to the ON position.Press the STANDBY button to turn the Speaker
Dock on.
2.Using the Remote Control
The Remote Control can be used to operate the Speaker Dock. Before using the Remote Control,
the Safety Tab should be removed.
Simply pull out the Safety Tab from the remote control, as shown below.
To use the Remote Control, simply direct it towards the front of the Speaker Dock and press the
desired buttons.
DON’T FORGET! When replacing the battery make sure that you use the same size and type.
Page 7 of 16
3. iPod Docking
Any iPod can be connected to the Speaker Dock to allow all your songs
to be played through the speakers.
To connect an iPod to the Speaker Dock, select the compatible adaptor
from one of the 7 iPod Adaptors supplied. The iPod Adaptors have
markings on the bottom which clearly identify which iPod they should
be used with.
If your iPod is not compatible with any of the supplied iPod Adaptors,
use the adaptor supplied with your iPod.
Place the iPod Adaptor into the recess on the top of the Speaker Dock
and then insert your iPod into the Adaptor.
DON’T FORGET! Your iPod will charge while docked when the Speaker Dock is in Standby
mode.
Press the STANDBY button.
Press the MODE button repeatedly until iPod is displayed on the LCD Display.
To start playback, press the PLAY/PAUSE button.
4. Connecting to External Devices
Your Speaker Dock can be connected to a number of external devices using the supplied 3.5 mm
Stereo cable (supplied) or an RCA cable (not supplied).
Page 8 of 16
Switching On
1.To turn the Speaker Dock on, press the STANDBY button.
2.To turn the Speaker Dock off, press the STANDBY button again.
DON’T FORGET! Ensure the ON/OFF Switch is in the On position before turning the Speaker
Dock on.
Adjusting the Volume
1.To increase the volume, rotate the VOLUME CONTROL clockwise.
2. To decrease the volume, rotate the VOLUME CONTROL anti-clockwise.
3. You can also press the MUTE button to turn the sound off. To turn the sound back on, press the
MUTE button again, or rotate the VOLUME CONTROL clockwise.
Preset equaliser
The range of the sound can be adjusted to suit the different types of music that you are listening to,
by changing the preset equaliser settings. The available settings are:
• Jazz
• Pop
• Rock
• Classic
• Bass
1.Press the EQ button to select the setting which sounds best.
Modes
The iPod Speaker Dock has three modes of operation. These are:
• iPod
• Tuner
• Aux
Brightness
1.Press the BRIGHTNESS button on the remote control repeatedly to cycle through the 4 display
brightness settings.
Page 9 of 16
Memory Cards
You can play MP3 files stored on SD or MMC memory cards by inserting them into the Memory
Card Slot on the top of the Speaker Dock.
iPod
You can dock an iPod with the Speaker Dock and listen to all your favourite songs through the
Speaker Dock’s speakers. With the iPod docked, you can control all the basic functions of the iPod
using the Speaker Dock or Remote Control.
DON’T FORGET! The functions described in this User Guide can be performed using either the
Speaker Dock or the Remote Control.
Selecting iPod Mode
1.Press the STANDBY button.
2.Press the MODE button repeatedly until iPod is shown on the LCD Display.
3.Carefully inset your iPod into the iPod dock as described on page 7.
DON’T FORGET! Use the correct iPod adapter for your model, taking care not to damage the
connecting pins.
DON’T FORGET! The iPod battery is automatically charged when the Speaker Dock is in
standby mode.
4.To start playback, press the PLAY/PAUSE button.
Menu Navigation
You can access the menu system of your iPod using the Remote Control.
1.To access the iPod menu system, press the MENU button.
2.Use the UP and DOWN ARROW buttons to highlight the menu options.
3.Use the OK button to select a menu option.
Page 10 of 16
Radio
Tuning to a radio station
1.Press the STANDBY button.
2.Press the MODE button repeatedly until Tuner is shown on the LCD Display.
3.Press and hold either the FWD or RWD buttons to search for a station.
4.To fine tune a station briefly press either the FWD or RWD buttons.
DON’T FORGET! You may need to reposition the Speaker Dock to get the best reception.
Storing a radio station using the remote control
1.Tune to a radio station as described above.
2.Press the MEM button. MEM and a number will be shown on the LCD Display.
3.Press the UP or DOWN ARROW buttons to select the number you want to store the radio station
against.
4.Press the MEM button again to store the station.
5.Repeat this procedure to store other radio stations.
DON’T FORGET! You can store a maximum of 20 stations.
Moving a stored radio station to a new preset position
1.Tune the radio station as described above.
2.Press the MEM button on the Speaker Dock or the remote control once to show current preset.
3.Press the UP or DOWN ARROW buttons on the remote control to select the new preset number.
4.Press the MEM button to store the radio station in the new preset.
DON’T FORGET! This will overwrite any previous stored station on the selected preset
Listening to a stored station
1.Store a radio station as described previously.
2.Press the UP or DOWN ARROW buttons to cycle through the stored stations.
AUX in
Other audio devices, such as an MP3 player can be connected to the Speaker Dock. A 3.5 mm
stereo cable is supplied, and a pair of RCA phono sockets are located on the rear panel for this
purpose.
1.Connect your chosen audio device.
2.Press the MODE button repeatedly until AUX is shown on the LCD Display.
Indice
Altri manuali LENCO Altoparlanti docking
