98
www.linergy.co.zawww.linergy.co.za
FEATURES
CELL FEATURES
■Extremely high cycle life LiFePo4 cells. Up to 6000 Cycles
■No Maintenance required on the cells.
■Unmatched high and low temperature performance.
■Cells operate safely on a high charge and discharge rate.
■Stable output voltage.
■ High energy density = lightweight congurations with great capacity
■ Cells do not explode or cause re when crushed, punctured or drop tested.
Unlike NMC, Pol-ymer etc cells.
■Low internal resistance.
■The warranty claims are excluded for direct or indirect damage due to
items above.
BMS DESIGN FEATURES
■Solid state design with no internal moving parts.
■ Integrated Bluetooth function for easy monitoring and conguration.
■Bluetooth dongle soldered to PCB to decrease loose components.
■Integrated heatsink to dissipate heat quickly.
■Integrated cell balancing function.
BMS SAFETY FEATURES
■Short Circuit Protection
■Overcharge Voltage protection
■Over discharge voltage protection
■Charge over current protection
■Discharge over current protection
■Low temperature charge protection
■Low temperature discharge protection
■High temperature charge protection
■High temperature discharge protection.
■ Optional* built in self-re extinguishing device.
APPLICATIONS
Our LiNERGY FLEXi range are suitable for the following applications:
■ Residential or Ofce backup power solutions
■Auxiliary battery in boats, trailers, RV’s, Caravans, Canopies etc.
■Can also be used in an engine bay as an auxiliary battery.
■The smaller 8AH model can be used in Garage motors, Alarm systems,
CCTV systems etc.
■Portable power supplies on site or out camping.
■Street lighting applications with solar charging.
■Telephone towers.
■Other small traction applications.
The range can be mounted in any orientation with medium to high
vibration toleration. We have carefully designed the internal structure of the
components assembly to ensure no moving of parts are possible within the
battery case and within reasonable handling.
INSTALLATION & USE
CONNECTING THE BATTERY
The 12.8V FLEXi range is protected internally using solid state electronics.
These electronics will not resist extreme operation or abuse outside of the
limits given in this document. It is thus important to connect these batteries
to suitable equipment. The following points are of primary relevance:
* The connected equipment must not cause excessive inrush current when
connected to the battery – should excessive inrush current (from inverter
capacitors for example) be suspected, the DC bus must be pre-charged
using a 50-100 Ohm 100W resistor before connecting the battery onto the
DC bus
* The inverter or other load(s) must not be capable of exceeding the current
ratings in the specica-tion sheet for discharge and must be set correctly
for the maximum charge current, which is possible in most devices. For
chargers where it is not possible to limit the charge current the model
selected must not be capable of delivering a current higher than the
standard charge current given in the specication table.
* It is imperative that the correct nominal DC voltage is selected on the
connected equipment i.e. 12V, 24V, 36V or 48V.
* Please note: The FLEXi range is not designed for, or capable of, starting
internal combustion en-gines. The cranking current demands are far too
high.
