8 GB
Start-up/Maintenance and CleaningSafety/Preparation/Prior to installation/Start-up
Replace defective bulbs with new ones immedi-
ately. Before changing bulbs, always first re-
move the fuse or switch off the circuit breaker.
0.5 m
FIRE HAZARD! Fit the light so that
it is at least 0.5m away from the
material to be illuminated. Excessive
heat can result in a fire.
Do not leave the light or packaging material
lying unattended. Plastic film or bags, plastic
parts, etc. can be dangerous for children to
play with.
J Do not use cold light lamps with
reflector.
Only use halogen light bulbs with
cover glass or low-pressure
technology.
Safe working
Only use the light bulbs specified in chapter
"Technical Data".
Mount the light so that it is protected from
moisture and dirt.
Carefully prepare for assembly and allow your-
self adequate time. Organise all parts and any
necessary additional tools or materials before
starting so they are easy to reach.
Always be attentive! Always pay attention to
what you are doing and use common sense.
Never install the light if you are having diffi-
culty concentrating or do not feel well.
Preparation
Required tools and material
The tools and materials specified are not included.
This information and these values are non-binding
and are only provided as a reference.
The nature of the material is determined by the
individual local conditions.
- Pencil/making tool
- Voltage tester
- Screwdriver
- Electric drill
- Bit (ø approx. 0.6cm)
- Side cutting pliers
- Ladder
Prior to installation
Important: The electrical connection must be
established by a qualified electrician or a person
trained to perform electrical installations. This per-
son must be familiar with the properties of the light
and the connection regulations.
Familiarise yourself with all the instructions and
diagrams in this manual, as well as with the light
itself, before you install it.
Before installation ensure that the circuit, to which
the light will be connected, is not energised. To
do so, remove the fuse or switch off the circuit
breaker in the fuse box (0 position).
Use the voltage tester to verify the de-energised
status.
Start-up
Mounting the light
Remove the locating screws 3visible at the
side of the connection housing 5and remove
the mounting bracket 2at the back.
Use the slotted holes for the screws 4on the
mounting bracket 2to mark the drill holes.
Be careful not to damage the supply line.
Now drill the mounting holes (approx. 6mm,
approx. 40mm deep).
Insert the wall plugs 1into the drill holes.
Fasten the mounting bracket 2with the
screws 4provided.
Feed the mains connection cable (external) 9
through the protective tube 8.
Now connect the connection housing for the
light to the mains connection cable (external) 9
using the terminal block 7.
