5
4
2
4
4
3
15
6
#17
12
3
4
5
6
7
Handles
for
models:
HD 6060
HD 6161
SERVICE, CLEANING AND OPERATION
HONDA ENGINES:
Refer to your Honda owner’s manual.
1. Before cleaning, servicing or repairing your screed, stop the engine and wait for
any moving parts to stop then remove the spark plug cap.
If the engine has been running, allow it to cool off for at least 15 to 20 minutes
before cleaning with water.
2.Grease: the housing weight must be greased approximately every ten hours
of operation. Do not
over grease.
An over flow (1) is located at the
opposite side of the grease fitting (2) and must be cleaned before each greasing
to prevent pressure from being applied by the grease on the bearing. Any such
pressure could seize the bearing or damage your housing weight.
3. Your screed should be disassembled frequently for proper cleaning in order to
prevent any concrete build-up that could break or prematurely damage your
equipment.
Warranty does not cover damage or performance problems on your
screed resulting from neglected maintenance or cleaning.
4. Take apart the blade and clean any concrete accumulation.
5. Take apart the housing weight from the handles and clean the concrete
underneath the handles and in the housing shaft.
6. Take the rubber cover off and clean any concrete or grease accumulation to
allow the counterweight to move freely.
7. Put everything back together making sure that the plastic spacers are between
the blade and the housing weight. Tighten the blade following the assembly
procedure to 85 to 100 Lb.-Ft. torque it is very important that the plastic
spacers are always between the vibrator and the blade.
MAGIC SCREED ASSEMBLY & STARTING PROCEDURE
1- Take the protective foam out of
the box.
2- Remove both adjustable handles and the
base handle (assembled with
vibrator and housing shaft).
3- Insert the adjustable handles
into the base handle (throttle
control on the right side) and
tighten the collar. Do not
overtighten.
Note:
If ordered with 360
0
adjustable handles, adjust
and tighten to comfort.
4-Stand
Place the stand with the flat
side against the support, ensuring
that one of the nylon washers
is on each side of the stand
(follow the drawing).
5- Assembly of the engine
Remove the engine from
the protective foam.Place
the engine on the housing
shaft, make sure that
the driveshaft is inserted
in the clutch adaptor, and
tighten. (Do not overtighten)
(See drawing).
6- Put the rounded end of the throttle
cable into the throttle control and
adjust so that the rubber handle
grip becomes the stopper.
7- Assembly of the blade
Assemble the blade (1) on the screed vibrator (2)
in the following order: bolts (3), washers (4),
blade (1), plastic spacers (5), washers (4), nuts (6).
(See drawing).Tighten all the above at approximately
85 to 100 Lbs. torque. It is very important
that the plastic spacers are always between the
vibrator and the blade. They are used as a cushion
and prevent blade damage. If both are not in place,
this could void the warranty. Replacement plastic
spacers are available at your Magic Screed dealer.
grease fitting (2)over flow (1)
