The valet switch allows you to temporarily bypass all alarm functions eliminating the need to hand
your transmitter to parking attendants or garage mechanics. When the system is in valet mode, all
alarm functions and remote start functions are bypassed, however the remote panic feature and
remote door locks will remain operational. To use the valet mode, the system must first be
disarmed either by using your remote transmitter, or by operating the manual override sequence.
Valet Mode (System in Disarm or Valet Mode)
Enter the Valet Mode:
1. In the disarmed mode, turn the ignition to “ON”
position.
2. Push and hold the valet switch for 2 seconds
until the LED turns on solid. The LED will
remain on solid while the unit is in the valet
mode.
Exit the Valet Mode:
1. To return to normal operation, turn “ON” ignition.
2. Push and hold valet switch for 2 seconds. The LED will turn off to indicate the system is now
out of the valet mode.
Remote Door Lock Remote Door Unlock
While in the armed mode, press the button to activate car locator function. The siren/horn will
chirp six (6) times. The parking lights will flash 12 times to help you locate your car.
Car Locator
The transmitter can be used as a remote panic switch to manually trigger the alarm system in case
of an emergency.
1. Press and hold the button for 3 seconds. The security system will begin to sound and
the parking lights will begin to flash.
2. During panic mode, the normal functions of this transmitter becomes temporarily inoperable.
The transmitter and buttons can be used to lock and unlock the door
(if the option is installed), however, once the button is pressed, the vehicle’s starter
disable device, (where installed) will be enabled allowing the vehicle to start.
3. To stop the alarm, press and hold the transmitter or buttons on the
transmitter again for 3 seconds. Also, if any transmitter button other than or is pressed and
release, the panic mode will be turned off immediately.
4. If the button is not pressed, the alarm will automatically stop after 30 seconds.
Panic Function
When armed, your vehicle is protected as follows:
1. Light impact will trigger the warn-away signal.
2. Heavy Impacts/Doors Open/Hood Open/Trunk Open/Ignition Key Activated will trigger the
programmed sequence. The starter disable relay (if installed) prevents the vehicle’s starter from
cranking. The siren, horn, parking lights and dome light will turn on to alert of an intrusion for
60 seconds. If one of the sensors or detectors are still active, the security system will sound a
maximum of 6 times for 30 seconds.
Trigger the System
8
