marsden MS-4200 Manuale utente
MS-4200
MS-4201/MS-4202L/MS-4203
Baby/Baby&Teenager/Adult
Operation Manual
INTRODUCTION
Thank you for purchasing a Marsden Professional Medical Scale. This is a precision
Class III Weighing Instrument and it will reward considerate use with many years of
accurate weighing results
The MS-4100 and MS-4101 come complete with a plastic baby tray, plastic cover,
Aluminium base, and a large easy to read LCD display, the model MS-4102 is intended for
Adults only and no baby tray is supplied
User Keys –The MS-4100 has 3 function keys consisting of ON/ZERO/OFF, HOLD and
TARE
The MS-4101 and MS-4102 have 4 function keys consisting of 2 x ON/ZERO/OFF, HOLD
and TARE
USING THE SCALE
The scale is suitable for able body users only. The user should step directly on to the centre
of the scale to ensure safe use.
POWER SUPPLY & LOW BATTERY
1. The MS-4100, MS-4101 and MS-4102 scales can be run from six ‘AA’ alkaline batteries
or can be connected directly to the mains power supply using the included mains power
adaptor
2. (Low battery indication) will display on the scales LCD display when the battery
power is insufficient to power the scale
3. When is displayed, please replace the 6 alkaline batteries
SPECIFICATIONS
MODEL No
MS-4200
MS-4201
MS-4202L/4203
Capacity/Division
20 kg x 10 g
0~20kg x 10g
20~50kg x 20g
0~150kg x 50g
150~200 x 100G
Baby Tray
Yes
Yes
No
Units of Measure
Kg
Function keys
ON/ZERO/OFF, HOLD, TARE
Stabilisation Time
1-2 seconds
Operating Temp.
0°C - 40°C
Power supply
Six AA size alkaline batteries or Mains Adaptor
Indicator display
1.0” LCD display with 5 active digits
Dimensions
(w x d x h)
Base: 340 x 330 x 50 mm
Baby Tray: 585 x 280 x 120mm
POWER SUPPLY
The scales use six "AA" size Alkaline batteries for operating. The battery is contained in a
cavity inside the scale. Access is via a removable cover on the rear of the scale, as shown
below.
INSTALLING THE BATTERY
1. 2.
3. 4.
CONNECTING THE MAINS POWER SUPPLY
FUNCTION KEYS
On/e = 0.05 kg
Adult
Max 150kg
Min 1kg
Net
Adult
Max 150kg
Min 1kg
Tare On/
Hold Off
Zero/
Hold
Zero/Off
0
e = 0.05 kg
ON/ZERO/OFF
1. Press this key to power up the scale, the display will go to 0.00kg
2. MS-4101/MS4102 Pressing the Single ON/OFF/ZERO key on the opposite side of
the display will cause the scales display to reverse, therefore the display can be set
to be viewed by the patient or the operator
3. If the scale shows a figure other than 0.00kg with no weight applied then press the
ON/ZERO/OFF key once to Zero the display.
4. Press and Hold the ON/ZERO/OFF key to switch off the scale.
Note: The scale has a built in Battery save function that will switch off the scale after a period of
inactivity, usually around 5 minutes
HOLD
1. When weighing a patient press the Hold key once and the scale will ‘lock’ onto the
patients weight once a stable reading as been taken.
2. Press the Hold key again to release the display.
TARE
1. The Tare key can be used to Zero the weight of any unwanted item, example –
When weighing a baby it is normal for some paper towels or similar to be placed
MS-4101 and MS-4102 Only
onto the scale, press the Tare key once and the weight of the paper towels will be
zeroed off.
2. After weighing the baby, remove the paper towels and press Tare again to cancel the
tare value and return to Zero.
BMI
1. After the patient stands on the scale, press and hold the BMI key for 3 seconds.
2. The scale will enter Height entry mode.
3. Use the +/- keys to adjust the display to the patients height in centimeters.
4. Press the BMI key once and the patients BMI result will be shown on the display.
5. Press the BMI key once again to return to normal weighing mode.
ERROR MESSAGES
1. Low Battery
2. Over Load
3. High/Low Zero Count
4. Low Zero Count
This indicates that the scales load
sensor/s have been overloaded, re-
calibration may fix this problem but it
usually indicates a faulty load sensor
1) The scale is above its Zero Range,
remove any weight on the scales
and try to power on again. If the
scale still shows the error message
then it indicates a fault with the
scales electronics.
2) The scale is below its Zero range,
check there is nothing jammed
underneath the scale and try to power
on again, if the scale still shows the
error then it indicates a fault with the
scales electronics
The scales alkaline AA type batteries
are flat.
Replace the batteries with new ones
Questo manuale è adatto per i seguenti modelli
3
Indice
Altri manuali marsden Scala
marsden
marsden BAS-250 Manuale utente
marsden
marsden M-999 Manuale utente
marsden
marsden MS-150 Manuale utente
marsden
marsden BS-250BT Manuale utente
marsden
marsden V-25 Manuale utente
marsden
marsden B-100 Manuale utente
marsden
marsden VS 250E Manuale utente
marsden
marsden M-640 Manuale utente
marsden
marsden M-100 Manuale utente
marsden
marsden MSS-I-400 Manuale utente
marsden
marsden MPMS-300 Manuale utente
marsden
marsden M-800 Manuale utente
marsden
marsden M-210 Manuale utente
marsden
marsden M-310 Manuale utente
marsden
marsden V-180 Manuale utente
marsden
marsden B-450 Manuale utente
marsden
marsden BFA-220P Manuale utente
marsden
marsden MBF-6000 Manuale utente
marsden
marsden M-600 Manuale utente
marsden
marsden PB-1200-I-400-APP Manuale utente
