Me MELF8247W Manuale utente
Distributed by Marks Electrical ltd
King Richards Road, Leicester, LE3 5QG
www.markselectrical.co.uk
OPERATING INSTRUCTIONS
MELF8247W - Larder Fridge
PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE USE
WHEN USING ANY ELECTRICAL APPLIANCE, BASIC SAFETY PRECAUTIONS
SHOULD ALWAYS BE FOLLOWED
IMPORTANT –If the mains lead of this appliance becomes damaged then it must be
replaced by the manufacturer’s service agent, or a suitably qualified person using the same
rated cable in order to avoid a hazard.
Getting to know your fridge
DO NOT TURN ON THE REFRIGERATOR FOR 2 HOURS
After the refrigerator is in place it needs to be left for 2 hours, to allow the coolant fluid time
to settle.
1.
Temperature control
2.
Wire shelves
3.
Salad/vegetable crisper
4.
Balcony shelves
5.
Bottle rack
Installation
Location
When selecting a position for your refrigerator, you should make sure the floor is flat and
firm, and the room is well ventilated with an average room temperature of between 12°C
and 32°C.
Specification
Disposal information
Waste electrical products should not be disposed of with household waste. Please recycle
where facilities exist. Check with your local authority for recycling advice.
This appliance can be used by children aged from 8 years and above and persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge if they
have been given supervision or instruction concerning use of the appliance in a safe way
and understand the hazards involved. Children shall not play with the freezer.
Cleaning and user maintenance shall not be made by children without supervision.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
WARNING: Keep ventilation openings, in the appliance enclosure or in the
built-in structure, clear of obstruction.
WARNING: Do not use mechanical devices or other means to accelerate the
defrosting process, other than those recommended by the manufacturer.
WARNING: Do not damage the refrigerant circuit.
WARNING: Do not use electrical appliances inside the food storage
compartments of the appliance, unless they are of the type recommended by
the manufacturer.
Do not store explosive substances such as aerosol cans with a flammable propellant in this
appliance.
The instructions shall include the substance of the following:
This appliance is intended to be used in household and similar applications such as
Staff kitchen areas in shops, offices and other working environments;
Farm houses and by clients in hotels, motels and other residential type
environments;
Bed and breakfast type environments;
Catering and similar non-retail applications.
This appliance is not intended for use by persons including children with reduced physical,
sensory, or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety.
Children should be supervised to ensure that they do not play with this appliance.
THERE ARE NO USER SERVICEABLE PARTS INSIDE AND THE CASING SHOULD
NOT BE OPENED BY AN UNQUALIFIED PERSON
THIS APPLIANCE IS INTENDED FOR DOMESTIC USE ONLY
Electrical Connection
Ensure your supply is rated at 220-240v and 50/60Hz before operating the appliance. This
refrigerator is fitted with a rewirable plug incorporating a 13amp fuse. In addition this
appliance must be earthed or connected to an earthed supply. In the event of the fuse
needing replacement then a 13amp fuse approved by ASTA to BS1362 MUST be used.
IMPORTANT: If the plug fitted is not suitable for your socket, then the 13amp plug supplied
should be removed. Before wiring the appropriate plug, please note that the wires in this
mains lead are coloured in accordance with the following code:
BLUE - Neutral
BROWN - Live
GREEN & YELLOW - Earth
As the colours in the mains lead may not correspond to the coloured markings in your plug,
proceed as follows:
Connect the BROWN wire to the terminal marked ‘L’ or coloured RED, Connect the BLUE
wire to the terminal marked ‘N’ or coloured BLACK, Connect the GREEN & YELLOW wire to
the terminal marked ‘E’ or coloured GREEN or GREEN AND YELLOW. If in doubt consult a
suitably qualified electrician.
Avoid locating your refrigerator near a heat source, e.g. cooker, boiler or radiator. Also
avoid direct sunlight in sun lounges or conservatories. If you are placing your refrigerator in
an out-building such as a garage or annex ensure that the refrigerator is placed above the
damp course, otherwise condensation will occur on the refrigerator cabinet.
Never place the refrigerator in a wall recess or into fitted cabinets or furniture. When your
refrigerator is working, the grill at the back may become hot and the sides warm. To aid the
air flow around the refrigerator keep ventilation openings, in the appliance enclosure or in
the built in structure, clear of obstruction. It must also be installed so that there is at least
7cm (2 ¾”) of free space at the back, sides and above the refrigerator.
The refrigerator door can be fitted to open to either the right or the left, depending on its
location.
Levelling the Refrigerator
Once the refrigerator is sited in its final location, make sure it is level. To do this use the two
levelling feet at the front of the refrigerator. (If the refrigerator is not level, the doors and
magnetic seal alignments will be affected.)
Cleaning before use
Wipe the inside of the refrigerator with warm water using a soft cloth. Wipe completely dry
before replacing the shelves and baskets.
Before using your Refrigerator
Check that you have your power outlet is compatible with the plug supplied with the
refrigerator. If not, see the section called ELECTRICAL CONNECTION at the back of this
booklet.
DO NOT SWITCH ON UNTIL TWO HOURS AFTER MOVING THE REFRIGERATOR to allow the
coolant fluid time to settle.
Before placing any food in your refrigerator, turn the refrigerator on and wait for 24 hours,
to make sure it is working properly and to allow the refrigerator to fall to the correct
temperature.
Using Your Refrigerator
Switching on your refrigerator:
1)
Before connecting the refrigerator to the mains supply make sure that the
Temperature Control located inside the refrigerator is set between 3and 4, which
is the correct setting for use in a room of average temperature.
2)
Wait 24 hours before placing food in the cabinet to allow for the refrigerator to fall
to the correct temperature.
Adjusting the temperature
The internal temperature of your refrigerator is controlled by the Temperature Control.
There are 6 settings. Position 6 makes the refrigerator coldest. Position 1 makes it the
warmest. To adjust the temperature, turn the Temperature Control to the preferred setting.
The temperature of the refrigerator is best maintained around 0C to +5C. Avoid setting
the thermostat too high otherwise this may reduce the temperature to a point where certain
fresh foods may begin to freeze.
Noises inside the Refrigerator
If you have not owned a refrigerator before, you may notice that it makes some rather
unusual noises. Most of these are perfectly normal, but you should be aware of them!
GURGLING, WHOOSHING
These noises are caused by the circulation of the refrigerant liquid in the cooling system. It
has become more pronounced since the introduction of CFC free gases. This is not a fault
and will not affect the performance of your refrigerator.
HUMMING, PURRING OR PULSATING
This is the compressor motor working, as it pumps the refrigerant around the system.
Cleaning
Cleaning inside the Refrigerator
You should clean the refrigerator internally with warm water using a soft cloth. Wipe the
refrigerator dry before replacing the food. Plug in and switch on the mains supply.
Cleaning the drainage filter
The drainage hole which is located at the back of the compartment can get blocked and
affect the automatic defrost function. You can unblock it using a cotton bud, pipe cleaner or
drinking straw (don’t suck!).
Cleaning the outside of the Refrigerator
Use standard furniture polish to clean the refrigerator exterior. Make sure that the doors are
closed, to prevent polish getting on the magnetic door seal or inside. The grille of the
condenser at the back of the refrigerator and the adjacent components can be vacuumed
using a soft brush attachment.
DO NOT use electrical appliances inside the food storage compartments of the appliance,
unless they are of the type recommended by the manufacturer.
Cleaning tips
• Defrost and clean when food stocks are low.
Replacing the Light Bulb
1. Unplug the fridge.
2. Remove the lampshade.
3. Remove the bulb and replace.
4. Replace the lampshade.
5. Plug the fridge back in.
Troubleshooting
1)
The refrigerator is not working
Check it is plugged in and switched on. Check that the fuse in the plug has not
blown. Plug in another appliance, such as a lamp, to see if the socket is working.
2)
Condensation appears on the outside of the refrigerator
This may be due to a change in the room temperature. Wipe off any residue of
moisture.
Servicing and Maintenance
Repairs and maintenance of the appliance should only be performed by an authorized,
qualified technician.
WARNING! It is hazardous for anyone other than authorised personnel to carry out servicing
or repairs which involve the removal of covers. Do not damage the refrigerant circuit.
To avoid the risk of electric shock do not attempt repairs yourself.
Indice
Altri manuali Me Frigorifero
