Temperature: 10˚C ~50˚C Humidity: 10%~95%RH
Temperature: -10˚C ~60˚C Humidity: 10%~95%RH
How to take your body temperature
1. Press ON/OFF button to activate. The unit will beep and display for 1 second with blue
backlight.
2. Then, the last memory will be displayed. You will hear “ please measure ” after 2 seconds and the
device will check itself and display “ Err ” if any problem occurs. At the same time it will speak ” Error,
please measure again! ”, after 60 seconds (±10seconds), it will power off automatically.
3. If self-checking result is normal, LCD will display ” Lo ˚C ” and start measurement, a beep sound will
remind you when the measurement is finished in 8-10 seconds, voice report the result come after with
blue backlight. If your body temperature is too high, the display backlight will be red.
4. If you want to start another measurement, turn off the thermometer and then activate again. It will
power off after standby for about 1 minute (±60seconds). Or press ON/OFF key to shut off directly.
Language selection
Language selection: Under the thermometer is on off mode, press ON/OFF button holding for about 8
seconds till “01” display and release ,then press ON/OFF button to switch between “01“, “02“, “03“,
“04“, “05“, “06“, a beep signal confirms each change. Language code as below for ref.:
Replacing the battery
The battery in your digital thermometer need to be replaced when “
” appears in the lower right
corner of the display. Replace the battery with three 1.5V AG13 batteries or equivalent.
To replace the battery,
Open the battery cover
Remove the batteries
