MEITRACK TC68E Plug-and-Play Vehicle GPS Tracker User Guide
Copyright © 2022 Meitrack Group All rights reserved. - 6 -
interval platform or mobile phone at the preset time interval.
Tracking by distance After you set the distance, the device will report its location information to the
platform based on the preset distance.
Cornering report Set the cornering angle. When the driving angle is greater than the preset value, the
device will report its location information. This report is used to make the driving
route smoother when no data is sent at the preset time interval or distance interval
while the vehicle corners.
3.3.2 Alerts
Function Description
External power supply
cut-off alert
When the device is removed from the OBD connector, an alert will be reported to
the platform or be notified to the user.
Speeding You can set the maximum speed threshold by using the platform, Meitrack
Manager software or SMS. When the driving speed exceeds the preset value, an
alert will be sent.
Geo-fence With a coordinate and radius, you can set a circular geo-fence.
When the vehicle enters or exits the preset geo-fence, an alert will be reported
to the platform or be notified to the user by SMS. A maximum of eight circular
geo-fences can be set.
SOS alert When the SOS button is pressed, an alert will be sent.
Low battery alert for the
external power supply
When the voltage of the external power supply is lower than 11.4 V, an alert will
be sent.
Device status alert When the device is powered on or powered off, a device status alert will be sent.
When the internal battery power is low, a low battery alert will be sent.
Harsh
acceleration/braking alert
When the driving speed exceeds the preset harsh acceleration/braking threshold,
an alert will be sent. The TC68L supports this function because it can obtain OBD
data. However, the TC68SL does not support this function.
3.3.3 Other Functions
Function Description
Over-the-Air (OTA)
update
Update the device firmware by OTA.
GPS log When the GPS is valid, the device will record the driving routes at the preset time
interval. You can use Meitrack Manager software to read these records. A maximum
of 130,000 records can be stored.
GPS + LBS positioning When a valid GPS signal cannot be received, the GSM base station will be used for
assisted positioning to ensure that the vehicle can be located at any time.
GPS blind spot report When the vehicle enters or exits an area without GPS signal, the device will send a
report to the platform.
Auto data storage in a
GSM blind spot/Data
resending
When data fails to be sent to the platform in a GSM blind spot, the data will be
automatically stored. When the GSM becomes valid, the data will be automatically
sent to the platform. The built-in 8 MB flash memory can store 8,192 pieces of GPRS
