Metra Electronics 95-6556 Manuale utente

INSTALLATION INSTRUCTIONS

95-6556

Attention! Let the vehicle sit with the key

out of the ignition for a few minutes before

removing the factory radio. When testing the

aftermarket equipment, ensure that all factory

equipment is connected before cycling the

key to ignition.

KIT FEATURES

• ISO DDIN radio provision

• Painted to match the factory ﬁnish:

• 95-6556G - Gray

• 95-6556DK - Dark Khaki

KIT COMPONENTS

• A) Radio bezel • B) Radio brackets • C) Retaining caps • D) Philips screws (4)

TOOLS REQUIRED

• 9/32” Socket wrench • 5mm Allen screwdriver

• Cutting tool • Panel removal tool

• Phillips screwdriver • Solder gun

TABLE OF CONTENTS

Dash Disassembly ..................................................2

Kit Preparation .......................................................3

Kit Assembly ..........................................................3

WIRING & ANTENNA CONNECTIONS

(sold separately)

Wiring Harness: CHTO-01

Antenna Adapter: 40-CR10

A B C D

Jeep Commander (without NAV) 2006-2007

Visit MetraOnline.com for more detailed information about the product and up-to-date vehicle

speciﬁc applications

386.257.1187

MetraOnline.com

1. Remove (16) 5mm Allen screws securing

the dashboard trim panel. (Figure A)

2. Unclip and remove the dashboard trim

panel. (Figure B)

3. Remove (4) 9/32” screws securing the

radio. Slide the radio out, then unplug

and remove.

Continue to Kit Preparation

DASH DISASSEMBLY

(Figure B)

(Figure A)

(4) screws (4) screws (4) screws (4) screws

REV. 4/14/2020 INST95-6556 3

From the factory dashboard trim panel:

1. Using either a solder gun or cutting tool,

remove the plastic welds holding the

factory radio bezel in place. (Figure A)

2. Using a pry tool, remove the factory

radio bezel from the center of the

factory dash panel.

Note: Be sure NOT to damage the holes

in the dash panel, so they can be used for

mounting the radio bezel in the next step

3. Clip the radio bezel in, then place the

retaining caps over the (4) screw holes.

Using a manual screwdriver, secure

using (4) Phillips screws provided.

(Figure B)

Continue to Kit Assembly

KIT PREPARATION KIT ASSEMBLY

(Figure A)(Figure A)

(Figure B)

1. Secure the radio brackets to the radio

using screws supplied with the radio.

(Figure A)

2. Locate the factory wiring harness and

antenna connector in the dash and

complete all necessary connections to

the radio. Metra recommends using

the proper mating adapter from Metra

and/or Axxess. Test the radio for proper

operation.

3. Slide the radio into the dash, then

secure using the factory screws.

Reinstall the dash in reverse order of

disassembly to complete the installation.

KNOWLEDGE IS POWER

Enhance your installation and fabrication skills by

enrolling in the most recognized and respected

mobile electronics school in our industry.

Log onto www.installerinstitute.com or call

800-354-6782 for more information and take steps

toward a better tomorrow.

Metra recommends MECP

certiﬁed technicians

INSTALLATION INSTRUCTIONS

95-6556

If you are having difﬁculties with the installation

of this product, contact our Tech Support line

either by phone at 386-257-1187, or email at

techsupport@metra-autosound.com. Before

doing so, look over the instruction booklet a

second time and ensure that the installation was

performed exactly as the instruction booklet

is stated. Have the vehicle apart and ready to

perform troubleshooting steps before contacting

Metra/Axxess Tech Support.

Altri manuali Metra Electronics Accessori per automobili

Metra Electronics

Metra Electronics 99-7308 Manuale utente

Metra Electronics

Metra Electronics 99-7309 Manuale utente

Metra Electronics

Metra Electronics 95-9607B Manuale utente

Metra Electronics

Metra Electronics 95-6513B Manuale utente

Metra Electronics

Metra Electronics 107-TO1HG Manuale utente

Metra Electronics

Metra Electronics 99-7300 Manuale utente

Metra Electronics

Metra Electronics 95-6542 Manuale utente

Metra Electronics

Metra Electronics 70-2103T Manuale utente

Metra Electronics

Metra Electronics 95-7322 Manuale utente

Metra Electronics

Metra Electronics KIA OPTIMA 99-7324 Manuale utente

Metra Electronics

Metra Electronics 99-7804B Manuale utente

Metra Electronics

Metra Electronics 95-2009 Manuale utente

Metra Electronics

Metra Electronics 2004-2009 99-3303 Guida utente

Metra Electronics

Metra Electronics 108-FD7B Manuale utente

Metra Electronics

Metra Electronics 99-7819 Manuale utente

Metra Electronics

Metra Electronics 99-7311 Manuale utente

Metra Electronics

Metra Electronics 95-5817 Manuale utente

Metra Electronics

Metra Electronics 95-7323 Manuale utente

Metra Electronics

Metra Electronics 99-5800 Manuale utente

Metra Electronics

Metra Electronics GMRC-02 Manuale utente

Metra Electronics

Metra Electronics 70-1722 Manuale utente

Metra Electronics

Metra Electronics 95-3009 Manuale utente

Metra Electronics

Metra Electronics 99-7334 Manuale utente

Metra Electronics

Metra Electronics 95-7953 Manuale utente

Manuali Accessori per automobili popolari di altre marche

James Baroud

James Baroud Odyssey Manuale utente

Motorola

Motorola i50sx Manuale utente

Yakima

Yakima 9MM STANDARD BIKE MOUNT Manuale utente

Feniex

Feniex T3 Manuale utente

Renault

Renault 77 11 423 180 Manuale utente

Kia

Kia E8300-4D000 Manuale utente

Brink

Brink 756843 Manuale utente

Whispbar

Whispbar K085W Manuale utente

v.link

v.link CI-VL2-PC-HSD Manuale utente

Viking

Viking Stack-Rack Guida rapida alla configurazione

Aries

Aries 203015 Manuale utente

Choetech

Choetech AT0005 Manuale utente

ZZ2

ZZ2 ZZAIR-PRO Manuale utente

Holman

Holman 4A80L Manuale utente

Thule

Thule 2075 Manuale utente

Motorola

Motorola T325 Manuale utente

TAUBENREUTHER

TAUBENREUTHER 16-3950 Guida all'installazione

DV8

DV8 FBJL-02 Manuale utente