Attaching DLS 2 mast assembly
Attaching DLS2 mast to an Inspire 2
1. Mount the DLS 2 unit on top of the mast using the provided M2 X 8 (Qty 2) screws.
2. Using the appropriate Allen key, remove the two M2.5 screws from the drone to install
DLS2 mounting plate (see image below)
3. Secure the mast to the top of the Inspire 2 using the provided M2.5 X 16 (Qty 2) screws
making sure the DLS 2 connector is oriented toward the front of the drone.
4. Use zip ties to secure any loose wires.
DLS 2 mounted on Inspire 2
Warning: Failure to properly secure loose wires may lead to interference with the
aircraft propellers. This may damage the Inspire, RedEdge-MX/Altum, or both.
Attaching DLS2 mast to a M100 or M600 series
1. Locate and remove the DJI mast kit from its packaging.
2. There are three carbon rod sizes. Choose the longest and insert it into the base mount.
3. Secure the base mount with the included M2 screw.
4. Place the top cap on the other side of the carbon rod.
5. Secure the top cap on the rod by screwing the M2 screw.
6. Screw in the base of the mast assembly into the aircraft frame using the provided M2.5
screws and mating cap.
7. Secure the DLS2 mounting disc to the mast using the provided M2.5 x 4mm screws.
8. Mount the DLS2 to the DLS2 mounting disc using the provided M2 x 6mm screws.
9. Ensure the DLS 2 connector is oriented toward the front of the drone.
Rev 02 - December 2019
PAGE 4
