Midea HS-65L Manuale utente
Instruction Manual
Refrigerator
Model: HS-65L
1
General
This refrigerator is widely used in places such as hotels ,offices,
student dormitories and houses. It is small size, lightweight,
low electric consumption and easy use, most suitable for
refrigerating and preserving foods such as fruits and beverage.
Instructions for Installation
1.Do not tilt the refrigerator more than 450form upright during
moving. Do not apply force on any part such as condenser
and door to prevent the refrigerator from deforming as this
can influence its performance.
2.Allow the refrigerator enough space to operate well.
3.Do not install it in areas of high temperature or humidity to
avoid damage.
Cautions for Safety
1.Before the refrigerator is plugged in, ensure that the local
electric voltage (e.g. 240V) is the same as the rated voltage.
The power plug should have its independent socket as
adapter may cause the socket to overheat.
2.Do not store inflammable materials such as ether, benzine,
LP gas and glue etc. in the refrigerator.
3.Do not splash water on the refrigerator as it may cause
malfunction or electric shock.
Instructions for Use
1.When operating the refrigerator for the first time, run it
without loading any food until it automatically stops at the
desired temperature. Usually it takes 2 or 3 hours. Then, set
the thermostatic dial at the setting desired and put food in the
refrigerator.
2
2.The temperature of the refrigerator can be adjusted by
turning the thermostatic dial. A medium setting of the
thermostatic dial is the most suitable for general operation.
3.Defrost the freezing compartment whenever the layer of frost
on the surface of the evaporator reaches 3 or 4 mm. When
defrosting, remove all food and set the thermostat at “OFF”
position. Put the drip tray under the evaporator to collect
melted water. After the frost has melted, discard the melted
water and dry up the interior of refrigerator. The refrigerator
can then be restarted by turning its thermostat to the desired
setting.
Cautions for Use
1.The more food is put in or the more and the longer the door
is opened, the more electric it consumes, which may
eventually lead to malfunction.
2.Better not to place objects which are too heavy, pointed or
corrosive on table board.
3.Re-plugging in the power plug at the interval of over ten
minutes.
4.Do not store bottled drinks in the freezer as they may break
and damage the refrigerator.
5.Open the door as little as possible during power-cut.
6.When defrosting, never use any sharp or metallic objects to
remove the frost on the surface of the evaporator as it will
damage the evaporator.
7.Do not touch any food or container in the freezing
compartment with your wet hands to prevent frostbit.
3
Maintenance
1.While cleaning the refrigerator, pull out the electric power
plug. Wipe the refrigerator carefully with a piece of cloth
soaked with natural cleanser before wiping it with clean
water. Abrasive cleaning powder, alkali cleansers, chemical
cloth, thinner, alcohol, acid petroleum product and hot water
are not suitable for cleaning the refrigerator as they may
cause permanent damage to the painting cover and plastic.
2.Clean the door gasket whenever it is dirty.
3.If the refrigerator is out of use for a long time, pull out the
plug, clean and dry the freezing compartment then close the
door tightly.
The following cases are not malfunction
1. Sound of flowing water:
The sound of flowing water can be heard under normal
operation.
2. Outside condensation:
Outside condensation is normal in areas of high humidity.
You may wipe off the condensation with a cloth.
3.It takes some time for the temperature of the freezer and
refrigerator compartment to become cold after the
refrigerator starts to operate. If the environmental
temperature is higher, it will take a longer time to cool the
compartments.
4. The surface of the compressor becomes hot:
The surface of the compressor may become hot under
normal operation. Do not touch it with your hands.
4
Troubleshooting
If any case of malfunction, please inspect and rectify it
according to the checklist shown in the following table.
case
Inspection
Not refrigerating
Is there no electric current?
Is the voltage normal or not?
Has the socket fused?
Is the plug inserted into the socket correctly?
Not efficient
Is the thermostatic dial set to the correct
position?
Is there sufficient clearance space around
the refrigerator?
Has the door been opened too frequently or
for too long?
Is the refrigerator exposed to direct sunlight
or placed near heating devices?
Are there too much food inside?
Are the food too hot?
Is the room temperature too high?
Food frozen in
the refrigerator
compartment
Is the thermostatic dial set to the correct
position?
Have the food been put too close to each
other?
5
Noises
Is the refrigerator placed on a leveled
surface?
Has the refrigerator been struck by some
other objects?
Compressor
does not stop
automatically
Are the food stored too much at one setting?
Are the doors opened too frequently or for
too long?
If the above methods are not effective, please contact your
local Midea Service Centre for assistance.
DANGER or WARNING:
1. Risk of child entrapment. Before you throw away your old
refrigerator or freezer:
-Take off the door.
-Leave the shelves in place so that children may not easily
climb inside.”
2. Do not use extension cords.
For household refrigerating appliances
Try not to open the door too often, especially when the weather
is wet and hot. Once you open the door, mind to close it as
soon as possible.
Every now and then check if the appliance is sufficiently
ventilated (adequate air circulation behind the appliance).
6
For household refrigerating appliances, in normal temperature
conditions, please arrange the thermostat at the middle setting.
Before loading the appliance with packages of fresh
foods, make sure they are cooled to ambient temperature.
Ice and frost layer increase energy consumption, so do clean
the appliance as soon as the layer is 3-5 mm thick.
If it is the outer condenser, the rear wall should be always
clean free of dust or any impurities.
Always consider instructions stated in sections Positioning and
Energy Saving Tips, otherwise the energy consumption is
substantially higher.
7
WARNING
1) The appliance has to be unplugged after use and before
carrying out user maintenance on the appliance.
2) This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning
use of the appliance by a person responsible for their
safety.
3) Children should be supervised to ensure that they do not
play with the appliance.
4) If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
5) Please abandon the refrigerator according to local
regulators for it use flammable blowing gas.
Indice
Altri manuali Midea Frigorifero
Midea
Midea TMF No Frost Series Manuale utente
Midea
Midea MDRB424FGF Series Manuale utente
Midea
Midea MDRT346MTF28AP Manuale utente
Midea
Midea SBS Series Manuale utente
Midea
Midea Olson SBS Series Manuale utente
Midea
Midea UR-BD390WE-ST Manuale utente
Midea
Midea MDRT333FGF01 Manuale utente
Midea
Midea SBS Series Manuale utente
Midea
Midea MDRT385MTE46 Manuale utente
Midea
Midea MB46W Manuale utente
Midea
Midea MDRB470MG Series Manuale utente
Midea
Midea BMF No Frost Series Manuale utente
Midea
Midea MT18DDSCR1RCM Manuale utente
Midea
Midea COMPACT Series Manuale utente
Midea
Midea HS-455LWEN-W1 Manuale utente
Midea
Midea MTM258W Manuale utente
Midea
Midea Vandelo MRD410 Manuale utente
Midea
Midea UR-BCD326WE-DQ Manuale utente
Midea
Midea MDRB438FG Series Manuale utente
Midea
Midea UR-BC67CM-ST Manuale utente
