MilDef Crete DT13 Manuale utente

TABLET COMPUTER

DT13

USER’S GUIDE

○

Notice

No part of this publication may be reproduced and modified without the written permission

of MilDef Crete Inc.

MilDef Crete Inc. reserves the right to make changes in the products or the product

specifications without any prior notice. Customers are advised to contact MilDef Crete Inc.

for updated product information.

MilDef Crete Inc. makes no representations or warranties, either expressed or implied, with

respect to the contents hereof and specifically disclaims any warranties for the correctness

of this book, nor any license grant of MilDef Crete Inc.'s patents or intellectual properties.

MilDef Crete Inc. assumes no liability for customer's loss or damage caused by using this

document.

Trademarks

Trademark Acknowledgments

Intel® is a registered trademark of Intel Corp.

All product and company names are trademarks or registered trademarks of their

respective holders.

Regulatory Information/Disclaimers

Installation and use of this computer must be in strict accordance with the instructions

included in the user documentation provided with the product. Any changes or

modifications (including the antennas) made to this device that are not expressly approved

by the manufacturer may void the user’s authority to operate the equipment.

The manufacturer is not responsible for any radio or television interference caused by

unauthorized modification of this device, or the substitution of the connecting cables and

equipment other than manufacturer specified. It is the responsibility of the user to correct

any interference caused by such unauthorized modification, substitution or attachment.

Manufacturer and its authorized resellers or distributors will assume no liability for any

damage or violation of government regulations arising from failing to comply with these

guidelines.

III

FCC (Federal Communications Commission) regulatory compliance

This device complies with part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) This device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may cause undesired

operation.

Note:

This equipment has been tested and found to comply with the limits for a class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and if not installed and

used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user

is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Important:

Changes or modifications to this product not authorized by MilDef could void the

electromagnetic compatibility (EMC) and wireless compliance and negate your authority to

operate the product.

In order to maintain compliance with FCC regulations, compliant peripheral devices and

shielded cables must be used with this equipment.

E Declaration of Conformity

It is confirmed to comply with the requirements set out in the Council Directive on the

approximation of the laws of the member states relating to Electromagnetic Compatibility

(2004/108/EC), Low-voltage Directive (2006/95/EC), the Amendment Directive

(93/68/EEC), and the procedures given in European Council Directive (99/5/EC and

2004/108/EC ).

The equipment was passed, and the equipment test was performed according to the

following European standards:

EN 300 328 V1.8.1 (2012)

EN 301 893 V1.7.1 (2012)

EN 301 489-1 V1.9.2 (2011)

EN 301 489–3 V1.4.1 (2002)

EN 301 489-17 V2.2.1 (2012)

EN62311 2008

EN300440-1 V1.6.1 2010

EN300440-2 V1.4.1 2010

UL, TÜV

AC Adapter (TÜV includes LVD EN60950)

Power Conservation

This tablet computer consumes less power compared to conventional consumer computers.

The power consumption may be further reduced by properly configuring the Power

Management Setup.

It is recommended that the power saving features be enabled even when not running on

battery power. Power Management features can conserve power without degrading system

performance.

Power Safety

There are specific power requirements for your tablet computer:

Only use an approved AC adapter designed for this tablet computer.

There is a 3-prong grounded plug for the AC adapter. The 3

prong is an important

mechanism for ensuring product safety. Please do not neglect the importance of this

mechanism. If you are unable to access a compatible outlet, please hire a qualified

electrician to install a compatible outlet for you.

When unplugging the AC power cord, please make sure to disconnect the cord by

pulling from the plug head instead of pulling from the wire to prevent wire damage.

Make sure the power outlet and any other extension cord(s) you use can support the

total current load of all the connected devices.

Before cleaning the tablet computer, please make sure it is disconnected from any

external power source.

Warning

Before any upgrade procedures, make sure the power is turned off, and all the

cables are disconnected (including telephone lines). Also, it is advisable to

remove your battery to prevent your tablet computer from accidentally turning on.

Battery Preservation

Precaution

Only use batteries designed for this computer. Using incompatible battery types may

cause explosion, leakage or damage to the computer.

Do not store your battery in high moisture condition, low temperature or high

temperature. Proper storage temperature is 5~20°C and capacity is suggested to

remain 50%.

Do not put your computer and battery near any heat source(oven, stove…).

Do not remove the battery from the computer while the computer is powered on.

Do not continuously use a battery that has been dropped, or that appears damaged

(e.g. bent or twisted) in any way. Even if the computer is able to continuously work with

a damaged battery, the circuit damage may occur and possibly cause fire.

Always use the charger designed for this computer to recharge the battery. Incorrect

recharging may cause the battery to explode.

Do not try to service a battery by yourself. For battery service or replacement, please

contact your service representatives.

Please dispose of damaged battery promptly and carefully. Explosion or leakage may

occur, if the battery is exposed to fire, improperly handled or discarded.

If the battery will not be used for a long period, please charge the battery to 50% and

remove AC adapter. If the battery is stored in a system, it should be recharged to 50

every 3 months. If the battery is stored solely, it should be recharged every 6 months.

This could prevent the battery from being over discharge and damaged.

If your system always connects the AC power supply, the battery should be discharged

to 50% every two weeks.

Battery Capacity Decline

The capacity of a Li-ion battery decreases over time due to it’s chemistry features.

Normal Li-ion battery can be fully charged and discharged 300~500 cycles. A battery which

is properly used in room temperature (25℃) can be charged and discharged about 300

times (or a year) before its capacity gradually decrease to 80%.

The decrease rate of battery capacity depends on factors including system design, model

number, power consumption, software program and system power management. With

extreme temperature or abusing the battery might lose 70% of its capacity in a relatively

VII

short time.

Battery protection

If a battery keeps being charged with high voltage, the cell would age faster. To prevent this,

once the battery is charged to 100%, the system will not keep charging it and the capacity

might decrease and remain between 90~100%.

Notice:

For safety, recharging will stop if the internal temperature of the battery is out of range(<0°C;

>50°C). Please note that recharging could have stopped before the ambient temperature

reaching these boundaries because the internal temperature of the battery does not equal

to the ambient temperature.

Battery Disposal & Caution

The product that you have purchased contains a rechargeable

battery. The battery is recyclable. At the end of its service life,

under various state and local laws, it may be illegal to dispose of

this battery into the municipal waste stream. Check with your

local solid waste officials for details in your area for recycling

options or proper disposal. Danger of explosion may possibly

occur, if the battery is incorrectly replaced. Replace only with the

same or the equivalent battery recommended by the

manufacturer. Discard the used battery according to the

VIII

Environmental Information, Material Safety & Recycling

All materials used in the manufacturing of this equipment are recyclable or environmentally

friendly. Please recycle the packing materials in accordance with local regulations at the

end of the product's service life.

Notice:

The equipment may contain insignificant amount of hazardous substances for health

and environment below control level.

To avoid spreading such substances into the eco system and to minimize the pressure

on the natural environment, you are encouraged to reuse or recycle most of the

materials in a safe way after the product’s service life.

For more information on collection, reuse and recycle of materials, please consult local

or regional waste administrations for more information. You can also contact your

dealer for more information on the environmental details of the equipment.

The symbol of the crossed out wheeled bin indicates that the product

(electrical and electronic equipment) should not be placed in municipal

waste. Please check local regulations for disposal of electronic products.

TABLE OF CONTENTS

CHAPTER 1 - GETTING STARTED.............................................................. 1

NPACKING

..................................................................................................................1

PPEARANCE

VERVIEW

...............................................................................................2

CHAPTER2 - OPERATING INFORMATION ................................................. 6

TART

SING

OUR

ABLET

OMPUTER

.........................................................................6

TOP

SING

OUR

ABLET

OMPUTER

..........................................................................7

NSTALLING

PERATING

YSTEM

....................................................................................8

SING

NDICATORS AND

EYPAD

....................................................................................8

ETTING

UNCTION FOR

UTTONS

A1~A3....................................................................10

PERATING

IRELESS

EVICES

...................................................................................12

CHAPTER3- MANAGING POWER............................................................. 17

DAPTER

..............................................................................................................17

ATTERY

....................................................................................................................18

ATTERY

ECALIBRATION

............................................................................................20

ACPI

UPPORT

..........................................................................................................21

CHAPTER 4 - BIOS SETUP........................................................................ 22

AIN

ENU

................................................................................................................22

DVANCED

ENU

........................................................................................................23

PCH-FW Configuration Sub-Menu...................................................................................... 24

Trusted Computing Sub-Menu ........................................................................................... 24

RF Devi e Control Configuration Sub-Menu ...................................................................... 25

AC In Boot Control Sub-Menu ............................................................................................ 25

USB CHARGE Control Sub-Menu ........................................................................................ 26

Battery Re alibration Sub-Menu ........................................................................................ 26

IT8760 Super IO Configuration Sub-Menu ......................................................................... 27

Network Sta k Configuration Sub-Menu ........................................................................... 27

CSM Configuration Sub-Menu ........................................................................................... 28

HIPSET

ENU

...........................................................................................................29

PCH-IO Configuration Sub-Menu ....................................................................................... 29

ECURITY

ENU

.........................................................................................................30

HDD Se urity Configuration Sub-Menu ............................................................................. 30

OOT

ENU

...............................................................................................................32

AVE

XIT

ENU

.....................................................................................................32

CHAPTER 5 – DRIVERS AND APPLICATIONS......................................... 33

CHAPTER 6 – SPECIFICATIONS............................................................... 34

LATFORM

..................................................................................................................34

CPU ..........................................................................................................................34

EMORY

....................................................................................................................34

Altri manuali MilDef Crete Tavoletta

MilDef Crete

MilDef Crete DE13 Manuale utente

MilDef Crete

MilDef Crete DR10 Manuale utente

MilDef Crete

MilDef Crete DT10 Manuale utente

MilDef Crete

MilDef Crete DK13 Manuale utente

MilDef Crete

MilDef Crete DR886EX Manuale utente

MilDef Crete

MilDef Crete DS13 Manuale utente

MilDef Crete

MilDef Crete DS11 Manuale utente

MilDef Crete

MilDef Crete DR13 Manuale utente

MilDef Crete

MilDef Crete DR786 Manuale utente

MilDef Crete

MilDef Crete DS13 Manuale utente

MilDef Crete

MilDef Crete DK10 Manuale utente

MilDef Crete

MilDef Crete DR13 Manuale utente

Manuali Tavoletta popolari di altre marche

Laser

Laser MID-1060 Guida utente

MUNBYN

MUNBYN IRT09J Guida rapida

Motorola

Motorola MC3090R - Win CE 5.0 Professional 520 MHz Manuale utente

Dell

Dell Latitude ST Manuale del proprietario

Lenovo

Lenovo IdeaTab S6000L Manuale del proprietario

Venturer

Venturer WT9L11 Manuale utente

EDUGEAR

EDUGEAR UnoBook Manuale utente

Philips

Philips PI3210G/58 Manuale utente

ADLINK Technology

ADLINK Technology IMT-BT Manuale utente

TwinMOS

TwinMOS TwinTAB-T102D1 Manuale utente

Archos

Archos 9.7 xenon Manuale utente

Getac

Getac E100 Manuale utente

HANNspree

HANNspree HANNspad SN70T3 Manuale utente

Philips

Philips PI3105W2/55 Manuale utente

LG LG-V935 Manuale utente

Zeki

Zeki TBDB763B Manuale utente

Ricoh

Ricoh eQuill Manuale utente

DT Research

DT Research DT365CT Istruzioni per il montaggio