Modena CX 9761 Manuale del proprietario

User

Manual Book

Hood

CX 9761

2 
 
Contents 
 
Part 1: Important Safety Information 3 
Electrical Shock Hazards 4 
Part 2: Name Of Parts 5 
Part 3: Installation 6 
Installation Precaution 7 
Installation Diagram 8 
Part 4: How To Use 9 
Part 5: Maintenance 11 
Cleaning The Cabinet 11 
Cleaning The Filter 11 
Aluminum Filter 11 
Carbon Filter 12 
Changing The Light Bulb 12 
Part 6: Problem And Solution 13 
Part 7: Precaution 15 
Part 8: Specification 16 
 
 
 
 
 
 
 
 
 
 

•Do not allow children to operate the unit.

•This exhaust hood is designed for home use only, not suitable for the

environmental condition, bake shop, barbecue, and other commercial

purposes.

•The exhaust hood should be cleaned periodically so that its power is

maintained.

•Clean the exhaust hood according to the instructions contained in

this book and keeps it away from the danger of being burnt.

•No direct grilling on a gas stove.

•Keep your kitchen remains good circulation.

•Before connecting the unit to a power source, make sure the power

cord is in good shape. If there is damage to the power cord, the

replacement must be performed by qualified personnel or contact the

MODENA Service Center for replacement process.

•The room should have good ventilation during the use of exhaust

hood on gas stoves or other fuels.

•The exhaust hood waste pipe should be separated with an air-duct.

•Regulations regarding the air exhaust must be met.

•The unit is not intended to be used by persons (including children)

with a physical, sensory, or mental disability, or lack of experience

and knowledge unless they have been given supervision or

instructions concerning the use of the appliance by the person who

is responsible for their safety.

•Children should be supervised to ensure that they are not playing

with the unit.

•Do not strike a fire under the sucker of the exhaust hood.

•The exhaust hood is not aimed to be installed on top of the stove that

had more than four burners.

PART 1: IMPORTANT SAFETY INFORMATION

Electrical Shock Hazards

•Connect the unit only to a grounded power socket correctly. If you

are in doubt, ask advice from an experienced technician who is

suitably qualified.

•The failure to follow these instructions may cause electric shock, fire,

or other hazards that are fatal.

PART 2: NAME OF PARTS

1. Control Panel

2. Glass

3. Stripe

4. Main chimney

5. Upper chimney

6. Charcoal filter

1. Determine the location: According to the product model, refer to

the installation diagram, and mark the corresponding position on

the wall. The installation position shown in the figure in installation

diagram.

2. Install the hanging plate: in the horizontal position with the marked

height, drill a hole with a diameter of ∅10mm and a depth of about

50mm in the corresponding position on the wall according to the

corresponding illustration or the hole position of the hanging plate

provided with the plastic expansion tube Install it in the wall hole

and fix the hanging plate on the wall with the fixing screws.

3. Install the air outlet component: install the air outlet component

with the sponge pad in place, fasten it with the screws provided,

check and ensure that the air outlet blades rotate flexibly (if

installed, this step can be omitted)

4. Install the air outlet pipe: Insert one end of the air outlet pipe into

the groove of the air outlet assembly, and fix the air outlet pipe to

the air outlet with the two self-tapping screws provided.

5. Installation of the body: Align the hanging holes on the back of the

body with the hanging buckles of the hanging plate, and check by

shaking the body by hand to confirm that the body is installed

horizontally and firmly. The expansion tube fixes the anti-fall

pressure block (or anti-fall screw) on the top of the range hood;

finally, lead the other end of the air outlet pipe to the outdoor or

public flue.

6. Install the enclosure board: Remove the screws used to fix the

enclosure board, align the installation holes of the enclosure board

with the box, then replace the screws used to secure the enclosure

board, and finally attach the enclosure board bracket with the

screws provided Fixed on the fence (if installed, this step can be

omitted).

PART 3: INSTALLATION

Installation Precaution

•Only professionally trained and qualified installers can install this

range hood.

•If your kitchen is being decorated, then do not expose the cooker

hood to avoid corrosion and tarnishing of the cooker hood surface.

•When handling and installing the range hood, please do not carry

the glass and the front panel by hand, otherwise the glass may

break or loosen.

•Do not install the range hood on the top of a solid fuel stove.

•When drilling holes in the wall, avoid the electric wires buried in the

wall to avoid the risk of electric shock.

•The range hood must be grounded, it is equipped with a three-pin

plug, this plug must be plugged into a grounded socket.

•Please confirm that your home's power supply system (current,

voltage, and connecting wires) can meet the normal load

requirements of the hood.

•Do not install the range hood on the wall of wood or other

flammable materials.

Installation Diagram

Hanging Panel

Air Outlet

Screw

Gasket

Outlet Base

After the power is turned on, all the indicator lights are displayed. After

about 1 seconds, the indicator lights are off, then the system enters the

somatosensory standby state.

1. On / off key: When this key is touched in the off state, entering the

standby state and waiting for other key operations. When you

touch this key again, it returns to the off state. Time-delay function

when the motor is running, touch this key to enter a 1-minute time-

delay shutdown state, the indicator light flashes during the delay.

In the off state, long press this key for 2 seconds to turn off the

somatosensory function long press again for 2 seconds to turn on

the somatosensory function.

2. Low/Middle speed key: Press this button when in the standby

state, then the button will light up while the fan will enter the slow

running state. Press the button once again, the fan enters a

medium-speed running state. Press the button repeatedly to stop

the fan and return to the stand by state.

3. Fast speed key: Touch this key in standby state, the key lights up

and the fan enters the fast running state. Touch the key again to

return to the standby state, and the fan stops running.

4. Light key: In any state, touch this key to turn on the light. When

you touch this key again, the light will turn off. (The lamp is

PART 4: HOW TO USE

Cooling

function

Light

Fast speed

Low/middle

speed

On/off

controlled independently, it can be turned off by manual

shutdown)

5. Cooling function key: In any state, touch this key to turn on the

Cooling function.

6. Gesture Motion Sensor: Wave your hand from left to right to turn

on the cooker hood. The cooker hood will start to operate with high

fan speed and LED light will turn on. Wave your hand from right to

left to turn off the cooker hood. The cooker hood will stop operate

and turn off immediately. (Tips: When using a somatosensory

switch, please align your palm with the left and right sensing area!

The ideally gesture motion speed from left to right or right to left

shall within two seconds! The ideally distance of gesture motion

from control panel is from 5 –10 cm）

Indice

Altri manuali Modena Cappa di ventilazione

Modena

Modena CX 6761 Manuale del proprietario

Modena

Modena Celato Series Manuale del proprietario

Modena

Modena SX Series Manuale utente

Modena

Modena Piazza Series Manuale del proprietario

Modena

Modena RX Series Manuale utente

Modena

Modena PX Series Manuale utente

Modena

Modena PX 9022 Manuale utente

Modena

Modena Fresco Series Manuale del proprietario

Modena

Modena CX Series Manuale utente

Modena

Modena PX Series Manuale del proprietario

Modena

Modena SX 9502 V Manuale del proprietario

Modena

Modena CX 9306 Manuale utente

Modena

Modena Imola Series Manuale del proprietario

Modena

Modena BX 9603 Manuale utente

Modena

Modena Luce Series Manuale del proprietario

Modena

Modena RX Series Manuale del proprietario

Modena

Modena PX 7111 Manuale utente

Modena

Modena Avanzare Series Manuale del proprietario

Modena

Modena IX Series Manuale utente

Modena

Modena Moderno Series Manuale del proprietario

Modena

Modena Cesena Series Manuale del proprietario

Modena

Modena CX 9150 Manuale del proprietario

Modena

Modena DX Series Manuale utente

Modena

Modena Esile Series Manuale del proprietario

Manuali Cappa di ventilazione popolari di altre marche

emmeti

emmeti RECUPA MED A-140 Guida

Nibe

Nibe F135 Manuale utente

Kuppersberg

Kuppersberg INTRO 60 Istruzioni di installazione e manutenzione

Zephyr

Zephyr Spruce AK9834BS Guida all'installazione

Hisense

Hisense MH6INBG Manuale utente

Miele

Miele DA 1255 Manuale utente

Broan

Broan 46000 Manuale utente

GE Profile PV977 Istruzioni originali

FALMEC

FALMEC FFRIA24W5FS Manuale utente

Whirlpool

Whirlpool RH2600XL-1 SERIES Manuale utente

Küppersbusch

Küppersbusch DX ISLA Manuale utente

ETNA

ETNA AV360RVS Manuale utente

JUNO

JUNO JDF603E6 Manuale utente

Miele

Miele DA 6708 D Manuale utente

Tricity Bendix

Tricity Bendix LE 150 Manuale

AEG

AEG X68163BV1 Manuale utente

AEG

AEG 125 D Manuale utente

Smeg

Smeg KSEV97X Manuale utente