TDY
8 Demand Moore Reliability
Model and Serial Numbers Moore Industries uses
a system of model and serial numbers to keep track
of all of the information on every unit it sells and
services. If a problem occurs with a TDY, check
for a tag axed to the unit listing these numbers.
Supply the Customer Support representative with this
information when calling.
If additional units are needed, use the information
printed in bold text in the table above to “build” a
model number for the type of transmitter required.
Each TDY order comes with one copy of our Interface
Solution Conguration Tools and Installation Manuals
CD.
To order additional copies of the Interface Solution
Conguration Tools and Installation Manuals CD,
specify Moore Industries’ part number
750-75E05-01.
To order cables, specify Moore Industries’ part number
803-040-26, or 803-039-26 for the special cable
equipped with its own, self-powered input-to-output
isolation circuit for operation in areas of high ground
potentials. Use Moore Industries’ part number 804-
030-26 for Fuse Protected USB cable.
Ordering Information
Unit
TDY
PC-Programmable
Temperature
Transmitter with
Display
Input
PRG
Programmable
with supplied
Conguration
Software (see
Table 1 for
descriptions of
available input
types; Factory
Conguration
available)
Output
4-20 MA
User
scaleable
with
supplied
software
Housings
BH2NG* 2-Hub, explosion-proof enclosure with two, ½-inch
entry ports and a glass cover
BH2TG* 2-Hub, explosion-proof enclosure with two, ¾-inch
entry ports and a glass cover
BH2MG* 2-Hub, explosion-proof enclosure with two, M20 x 1.5
entry ports and a glass cover
BH3NG 3-Hub, explosion-proof enclosure with three, ½-inch
entry ports
BH3TG 3-Hub, explosion-proof enclosure with two, ¾-inch side-
entry ports, one ½-inch bottom-entry port, and a glass cover
BH3MG 3-Hub, explosion-proof enclosure with two, M20 x 1.5
side-entry ports, one ½-inch bottom-entry port, and a glass cover
D2LC 2-Hub, low base, clear cover, NEMA 4X (IP66) enclosure
HP Hockey puck housing and spring clips
DN Snap-in mounting for HP case on TS-32 DIN rail
FL Mounting anges on HP suitable for relay track or screw
mounting
FLD Mounting anges on HP suitable for 3½” relay track
mounting
A sux indicates ANZEx (TestSafe) Ex d approval (i.e. BH2NGA).
E sux indicates ATEX (ISSeP) Ex d and Ex tD approval (i.e. BH2NGE).
2-inch pipe mount standard for A or E sux.
P sux indicates enclosure comes equipped with base and U-bolts for mounting on a
2-inch pipe (i.e. BH2NGP)
To order, specify: Unit / Input/ Output / Power [Housing]
Model Number Example: TDY / PRG / 4-20MA / 10-42DC [BH2NGP]
Default Factory Conguration
for TDY
The following are the factory default conguration
settings for your TDY unit:
Input:
RTD 4W Pt3850 100 Ohms 0-100degC
Display:
Input
Settings:
Input Trim OFF
Broken wire:
ON
Filter:
60Hz
Sensor Failure:
Up 24mA
Output:
4-20mA
Damping:
0s
Options
-IS Option
(cFMus,
ATEX and
IECEx
Intrinsically
Safe ap-
proval)
Power
10-42DC
10-30DC
for -IS
option
