Morphy Richards IB26004 Guida utente
Morphy Richards products are intended for household
use only. Morphy Richards has a policy of continuous
improvement in product quality and design. The
Company, therefore, reserves the right to change the
specification of its models at any time.
446/8 1/19 Rev 1
Imported by : Morphy Richards Ltd, Talbot Road, Mexborough, S64 8AJ
Two year guarantee
It is in your interest to retain the retailers receipt as proof
of purchase. Please quote the model number if the prod-
uct develops a fault. This number can be found on the
handle of the product.
All Morphy Richards products are individually tested
before leaving the factory. In the unlikely event of any
appliance proving to be faulty within 28 days of purchase
it should be returned to the place of purchase for it to be
replaced.
If a fault develops after 28 days and within 24 months of
original purchase, you should contact the helpline number
quoting the model number of the product, or write to the
address below. You will be asked to return the product
(in secure packaging) to the address below along with a
copy of proof of purchase.
The After Sales Division
Morphy Richards Limited
Mexborough
South Yorkshire
England
S64 8AJ
Helpline (8:3 -5: Mon-Thur/ 8:3 -4: Fri)
UK (local rate) 845 7777 ,
Republic of Ireland 18 4 9119
Morphy Richards Website
www.morphyrichards.co.uk
Male grooming system
MODEL : 26004
Instructions & Style Guide
Important safeguards
When using your appliance, basic safety precautions
should always be followed.
1Read all instructions carefully.
2Use the appliance for its intended use only.
3To protect against the risk of electric shock, do not
immerse the appliance in water or other liquids.
4Before use, make certain blades are aligned
properly.
Do not use this appliance with damaged or broken
combs or with teeth missing from the blades as
injury may occur.
6Never use the trimmer on wet hair.
7Switch off before placing down.
8Switch off before fitting or removing attachments.
To trim side burns
1Comb side burns following the
direction of your hair growth.
2Trim side burns using a downward
motion. (figure 6)
Stubble look
1Position trimmer guide to the 3mm setting and hold
the trimmer horizontally with the front of the
trimmer facing downwards or upwards.
2Trim hairs using a downward or upward motion
following the direction of your hair growth.
Note : For an even closer stubble look, remove the
trimmer guide and repeat the same procedure.
Oil (use clipper oil)
1To lubricate the blades use one or
two drops of oil and spread over
the cutters. (figure 7) Do not over
oil. Excess oil will cause
damage to your product.
Care and maintenance
•Never clean, remove or replace trimmer guide with
the motor on.
•Do not apply any pressure to cutters.
•Do not touch the cutters with hard objects as this
may damage the cutter.
•Do not use while bathing, showering or immersing
the unit in water or other liquids as damage to the
trimmer may occur.
•Never use harsh or corrosive cleaners such as
benzene or bleach.
Thank you for buying your new Morphy Richards male
grooming system. Please read these instructions
carefully before use and keep in a safe place for future
reference.
Key features
A Cutting blades
B Standard comb
C On/off switch
D Charging adaptor
E LED charging indicator
F Recharging base
G Cleaning brush
H Lubricating oil
I 5 Moustache comb
J Styling comb
Ni-cad batteries
Push down the battery door to open and then take
out the Ni-cad batteries.
Your beard trimmer is operated
by 2 x AA rechargeable
batteries. Ensure the batteries
are correctly fitted. Refit
battery door.
USE ONLY NICAD RECHARGEABLE BATTERIES in
order to avoid damage.
Batteries are not covered by the 2 year guarantee.
In the interest of environmental safety, dispose
of batteries safely.
Operating your trimmer
1Push the on/off switch upward to operate and down
to turn off the trimmer.
Before using the trimmer charge the unit overnight.
Make sure the LED indicator is on showing correct
charging.
To Recharge
1Use only the adaptor (charger) provided.
2Charge takes 8 hours.
3Connect plug to trimmer and plug adaptor into the
electrical socket.
4When charging, RED LED indicator will light up
showing correct recharging.
Attachment comb (trimming guide)
Your beard trimmer provides 2 attachment combs.
Styling Comb - provides 5 settings of cutting length
9, 11, 13, 15 and 17mm.
Standard comb - provides 5 settings of cutting length
1.5, 3, 4.5, 6 and 7.5mm.
Trim against the direction of the hair growth.
Start at a longer setting (15mm or 17mm) to prevent
accidentally trimming hair too short.
As you become familiar with the setting, adjust the
guide to the desired trimming length.
To trim beards
1Comb hair outward so they are at a
maximum height and in the same
direction.
2With the trimming guide in place,
set the guide to the desired
setting.
3Slide the On/off switch to the on
position and begin trimming. (figure 1)
To trim outer edge of beard
and add definition
1Remove trimming guide (figure 2)
and hold the trimmer diagonally
with the front of trimmer facing
away from you.
2Start at the chin and move back
towards the ear. (figure 3) Follow
the jawbone to cut away longer
hairs on the outer edge of the
beard.
To define the beard line
1Hold the trimmer vertically with the
front of the trimmer facing you.
2Start with the trimmed edge of the beard and with
a downward motion trim the area directly under the
beard line.
To thin and taper beard
1Use the moustache comb to hold hairs in place
while trimming.
2Hold the trimmer with front facing away from you.
Trim hair ends using an upward motion.
To trim moustache (with trimming guide)
1Ensure that the trimming guide is in place to avoid
over trimming the hair.
2Comb hairs outward to the maximum height and in
the same direction.
3Set the trimming guide to the desired setting.
4Hold the trimmer vertically with the front facing
you and trim hairs using a downward motion
following the direction of your hair growth or you
may trim against your hair growth.
Without trimming guide
1Place a finger on the upper lip only
to lift hair up, away from the skin.
Trim hairs using an upward motion.
2After achieving desired length, use a
downward motion to blend
moustache hairs. (figure 4)
3Hold trimmer perpendicular as
shown and move cutters sideways
to achieve the desired line above
the lip. (figure 5)
A
B
C
D
E
F
G
H
I
J
9 1.5
11 3
13 4.5
15 6
17 7.5
Questo manuale è adatto per i seguenti modelli
1
Altri manuali Morphy Richards Rasoio elettrico
