Motorola PMLN7632 Manuale utente

Tactical PTT/VOX

Interface Module

with Ear Microphone

PMLN7632

Accessories

MN003507A01.book Page 1 Tuesday, November 22, 2016 2:24 PM

MN003507A01.book Page 2 Tuesday, November 22, 2016 2:24 PM

FOREWORD

RF Energy Exposure and Product Safety

Guide for Portable Two-Way Radios

ATTENTION!

Before using this product, read the RF Energy

Exposure and Product Safety Guide that ships with

the radio which contains instructions for safe usage

and RF energy awareness and control for

compliance with applicable standards and

regulation.

ACOUSTIC SAFETY

Exposure to loud noises from any source for

extended periods of time may temporarily or

permanently affect your hearing. The louder the

radio’s volume, the less time is required before your

hearing could be affected. Hearing damage from

loud noise is sometimes undetectable at first and

can have a cumulative effect.

To protect your hearing:

• Use the lowest volume necessary to do your job.

• Turn up the volume only if you are in noisy

surroudings.

• Turn down the volume before connecting

headset or earpiece.

• Limit the amount of time you use headsets or

earpieces at high volume.

• When using the radio without a headset or

earpiece, do not place the radio’s speaker

directly against your ear.

MN003507A01.book Page 1 Tuesday, November 22, 2016 2:24 PM

DESCRIPTION

The Tactical PTT/VOX Interface Module with Ear

Microphone consists of two parts, the Push-To-Talk

(PTT) / Voice Operated Transmission (VOX)

Interface Module and the Bone Conduction Ear

Microphone.

The PTT / VOX Interface Module is equipped with

high performance VOX interface and a large PTT

button. The guarded ring around the PTT button

secures the PTT button from any accidental actuate

and can be removed when situations require.

The superior VOX interface is enhanced by high

speed Digital Signal Processor (DSP) and detects

only signal matching to human voices. The VOX

circuit will be set off and recognized steady and

trouble-free VOX transmission even under intense

noise.

The module ensures transmission without clipping

the initial part of the speech by temporarily storing

the voice in memory and release it in tune with the

radio’s ready to transmit state. The built-in digital

audio amplifier helps to increase the radio’s volume

with a lower audio output. The module operates on

electrical power supplied from the radio.

The Bone Conduction Ear Microphone is equipped

with a high performance bone conduction

microphone and receiver built into the ear piece.

Unlike the conventional boom microphone, the bone

conduction microphone picks up your voice directly

from the ear canal, so ambient noise is minimized to

its lowest level.

MN003507A01.book Page 2 Tuesday, November 22, 2016 2:24 PM

Figure 1. Overview of Interface Module

PTT / VOX Change-Over

Switch

Removeable

Guard Ring

External PTT

Te r m i n al

Covered with

Waterproof

Cap

PTT

Button

Audio Accessory Jack

Cloth Clip

Waris

Connector

MN003507A01.book Page 3 Tuesday, November 22, 2016 2:24 PM

Figure 2. Overview of the Bone Conduction Ear

Microphone

Eartip

Isolator

Receiver

Bone conduction

microphone

Connector

MN003507A01.book Page 4 Tuesday, November 22, 2016 2:24 PM

OPERATION

Attaching Bone Conduction Ear Micro-

phone to Interface Module

1. Insert the Bone Conduction Ear Microphone’s

connector into the accessory jack of interface

module.

2. Securely tighten the waterproof ring.

Note: Always ensure the waterproof ring is securely

tighten at all times, if the ring is loose,

waterproof function will be lost.

Figure 3. Location to Attach Bone Conduction Ear

Microphone to Interface Module

MN003507A01.book Page 5 Tuesday, November 22, 2016 2:24 PM

IMPORTANT: When not in use, cover the external

PTT terminal with waterproof cap to

keep out dust and water.

Attaching Interface Module Connector To

The Radio

1. Turn the radio OFF.

2. Connect the Interface Module connector to the

radio.

3. Turn the radio ON, adjusting the audio volume to

an appropriate level.

Wearing Bone Conduction Ear Micro-

phone

1. Insert the ear microphone

into the ear canal and place

the cable behind the ear as

shown in the picture. The

Bone Conduction Ear

Microphone can be worn in

the right or left ear.

Note: Once the kit has been installed, the radio

microphone and the radio speaker will be

disabled. The user must use the Bone

Conduction Ear Microphone to transmit and

receive calls.

Performance

To minimize interference and optimize the Bone

Conduction Ear Microphone performance, make

sure the accessory cable does not coil around the

radio antenna during use.

DO NOT set the volume level too loud.

MN003507A01.book Page 6 Tuesday, November 22, 2016 2:24 PM

Figure 4. PTT / VOX Change-Over Switch

Transmitting By Using PTT Mode

1. Rotate the change-over switch to PTT mode as

shown in Figure 4-A.

2. Press and hold down the Interface Module or

Remote PTT button and begin speaking in order

to transmit.

3. Your radio will return to receiving mode when you

release the PTT button.

Transmitting By Using VOX Mode

1. Rotate the change-over switch to VOX mode as

shown in Figure 4-B.

2. VOX automatically sets the radio on transmit

mode, allowing hands free transmission without

pressing the PTT switch.

Beep Sound

Beeps are emitted at the start / end of the

transmission. A high-pitched sound at the start and

low-pitched sound at the end.

PTT Mode VOX Mode

Figure 4-A Figure 4-B

MN003507A01.book Page 7 Tuesday, November 22, 2016 2:24 PM

Detaching Interface Module Connector

From The Radio

Turn the radio OFF before removing the Interface

Module connector from the radio.

Detaching Bone Conduction Ear Micro-

phone from Interface Module

1. Loosen the waterproof ring.

2. Remove the Bone Conduction Ear Microphone’s

connector from the accessory terminal of

Interface Module.

Figure 5. Attaching and Detaching Bone Conduction Ear

Microphone

Attaching Detaching

MN003507A01.book Page 8 Tuesday, November 22, 2016 2:24 PM

Indice

Altri manuali Motorola Cuffia

Motorola

Motorola H790 - Headset - Monaural Manuale utente

Motorola

Motorola Tracks Air Manuale utente

Motorola

Motorola H550 Manuale utente

Motorola

Motorola PMLN6635 Manuale utente

Motorola

Motorola QG-HS801 Manuale utente

Motorola

Motorola HS830 HANSFREE Manuale di istruzioni

Motorola

Motorola H390 - Headset - In-ear ear-bud Manuale utente

Motorola

Motorola HK250 Manuale utente

Motorola

Motorola FINITI Manuale utente

Motorola

Motorola H690 Manuale utente

Motorola

Motorola HS805 Manuale utente

Motorola

Motorola H670 - Headset - Over-the-ear Manuale utente

Motorola

Motorola HK100 Manuale utente

Motorola

Motorola 98405RH Manuale utente

Motorola

Motorola HK250 Manuale utente

Motorola

Motorola H710 - Headset - Over-the-ear Manuale utente

Motorola

Motorola H555 Manuale utente

Motorola

Motorola S805 - -QSG-EMEA Manuale utente

Motorola

Motorola H790 - Headset - Monaural Manuale utente

Motorola

Motorola MOTOSTART H3 Manuale utente

Motorola

Motorola H385 Manuale utente

Motorola

Motorola HX550 Manuale utente

Motorola

Motorola HS850 - Headset - Over-the-ear Manuale utente

Motorola

Motorola HT820 - Headset - Behind-the-neck Manuale utente

Manuali Cuffia popolari di altre marche

Sena

Sena SMH10 Manuale utente

IASUS

IASUS Stealth IA-NT4-BASIC-BT Manuale utente

Sennheiser

Sennheiser EPOS ADAPT 230 Manuale utente

Doro

Doro Flexus HS2005 Manuale utente

GE 98971 Manuale utente

Hama

Hama 00184070 Manuale utente

Plantronics

Plantronics Blackwire 3200 Series Manuale utente

Blue Tiger

Blue Tiger Advantage PLUS Manuale utente

Jawbone

Jawbone Icon Manuale utente

Jabra

Jabra FR 20 Manuale utente

Roxcore

Roxcore Flow A+ Manuale utente

Turtle Beach

Turtle Beach XP 510 Manuale utente

Philips

Philips SHB6101 Manuale utente

Jabra

Jabra PRO 9460 Duo Manuale utente

HyperX

HyperX HyperX Cloud Flight Manuale utente

Bose

Bose MIE2 Mobile Manuale utente

Jabra

Jabra Steel Manuale utente

HyperX

HyperX cloud ii Manuale utente