NexSens X2 Manuale utente

X2 Environmental Data Logger Manual

The NexSens X2 Environmental Data Logger offers the latest in real-time monitoring technology with

wireless communication, large plug-and-play sensor library, and ultra-low power consumption. The

unit includes Integral Wi-Fi and smartphone connectivity with options for radio, cellular & satellite

telemetry. WQData LIVE web datacenter provides instant access on any web browser.

Table of Contents
Introduction
Unboxing
Apply Power
Configure System Telemetry
Connect Sensors
Sensor Auto-detection
WQData LIVE Overview
WQData LIVE Setup
Configure Logger Settings
Generate Data Reports
Technical Information
2

Unboxing

What’s included:

•X2 environmental data logger

•Quick Start Card with WQData LIVE Device Claim Code

•(3) Sensor port plugs

•(1) Power port plug

•(1) Magnetic screwdriver

•(1) Wireless antenna (telemetry units only)

Apply Power

Connect SP-Series Solar Power Pack or UW6-PW AC Power Adapter

SP6 UW6-PW

Configure Telemetry

Most cellular and iridium systems will be pre-configured by NexSens for plug-and-play transmissions to WQData LIVE. Wi-Fi and user-configured data

accounts may require set up.

Direct Connect –Establish permanent wireless data transmission for standard X2s.

Wireless Network Setup process

Cellular- a 4G Compliant Mini-SIM card is required for installation on cellular models of the X2. Factory-installation is recommended, but user installation is

possible.

SIM Installation process

Configure Network APN

Iridium- Factory-installed Iridium satellite modems allow for communication in the most remote deployment locations.

Iridium Setup process

Connect Sensors

All sensor cabling connected to the X2 must be configured with one of the following:

•NexSens factory installed UW plug connector.

•NexSens UW-FWP series field wireable plug.

Refer to the NexSens sensor listing at https://www.nexsens.com/support/product-manuals for sensor-specific wiring and configuration information prior to

integration with an X2 system.

UW-FWP UW-plug connector

Connect Sensors

Connect the antenna, power and sensors to the X2

1Connect the system antenna (if equipped) and move into an area

with strong signal coverage.

Remove the center power plug and required outer port plugs (1

for each sensor to connect)

Connect sensors to any outer port (8 pin). *Record the port

number (P0, P1, or P2) occupied by each sensor.

Connect power (5 to 24VDC) to the center port (6 pin)

*After the initial setup, sensors must always be reconnected to the same port for proper communication.

Sensor Auto-Detection

Following the configuration of the logger telemetry (if required) and the connection of all sensors to the X2, disconnect and re-apply power to the X2.

Following power-up, the logger will automatically begin to scan through a list of common sensors to build the deployment sensor list. Sensors discovered during

this process will automatically be updated on WQData LIVE via the X2’s on-board telemetry.

Sensor detection will take approximately 10 minutes. Leave the full system connected and powered while proceeding through the WQData LIVE setup. Following