YTD350 Operation Manual
- 3 -
1. Before you use it, add gear oil into reducer, make oil level between the marks;
2. To lift the drum, you just have to push the truck to the drum, open the staple bolt in front of the facility to the limited position, push it to the drum, make the opening position be
tightly and contrapuntally appressed to the center of the drum (notice: during the contraposition, make sure the cover of the drum is located dead ahead), lock the staple bolt by the
handle of the clamp, however, don’t hoop too much and make it flat. Before lift the drum, step on the brake of the universal wheel, fix the truck, and the drum will be lifted by
stepping on the hydraulic cylinder pedal at the right-back of the product or pulling the lifting handle of the jack;
3. To convey the drum, if the universal wheel is braked, firstly loosen the brake, adjust the height of the drum and make it 2 -3 inches above the ground (50mm-75mm). Alarm:
don’t move the drum when it is at the highest position. Then push or pull the truck to the necessary place. Alarm: don’t park the truck holding a drum on a slope. If this
case happens, it might cause automatic rolling of the truck and lead to property loss or personnel injury;
4. To rotate the drum, screw off the cover and exchange a special cover with unidirectional valve before the drum leaves the ground, after it is lifted, turn the handle at the input of
the redactor, rotate the drum and discharge, rock the handle, the drum can be rotated clockwise or anticlockwise and discharge in any angle.
5. To let the drum fall down, move the uninstall handle, oil return valve is open, under the action of gravity of the goods and fork, working oil in the piston-cylinder goes back into
the tank through oil return valve, the piston rod and fork fall to the lowest position, after the drum falls to the ground or tray, you just have to open the staple bolt and then pull the
truck off the drum. Alarm: when the goods is falling down, the operation of the handle of the oil return valve should be slow and light to prevent sudden fall when falling
down too rapidly and cause unsafe result. When the goods is falling down rapidly, the oil return valve can not be shut down suddenly because the inertial acceleration in
the rapid falling process will produce strong force to damage the facility and goods if it is shut down suddenly.
IV Structural features
YTD350 drum lifter & truck consists of hydraulic system, framework and rotary mechanism, etc.
This truck needs manual hydraulic pressure jack (hydraulic equipment) as power to lift goods. Push, pull or transit the goods by men. There is an oil return valve in the hydraulic
equipment, and the falling speed of fork is controlled by handle. It also makes the hydraulic system act correctly, safely and reliably. The upright mounting is welded of high quality
profiled bar; and it has high rigidity and intension. The rear wheel needs a universal wheel with brake device, then it can rotate freely and turn portably and flexibly. Both of the front
wheels and rear wheels are installed onto the axle by ball bearings, so they can run flexibly. The wheels are made from nylon; and they are not only wear resistant and durable, but also
bring little damage to working floor.
VWork condition
The condition in which YTD350 drum lifter & truck works should accords with those followings: 1.Work circumstance temperature：-25℃～+40℃。
2.Circumstance relative humidity should be less than 90%RH。
3.Work in circumstance with no rain and noxious gases.
4.Work in rooms with flat, hard ground.
VI. Maintenance explanations
1. The oil should be clean and enough.
