Connect the AP150
to the Internet
STEP 3
Install the Desktop Mounting Bracket and
Attach the AP150
STEP 2
If you would like to permanently install the desktop
mounting bracket onto a horizontal surface prior to
attaching the AP150 device, screw the thread-forming
screws included in the mounting package through the
foot of the bracket.
Push the AP150 device gently down into the bracket.
The tabs on the back of the bracket fits into the slots
on the middle and top of the device’s back. Use a T8
screwdriver to insert the T8 security screw into the top
of the device to secure the unit to the bracket.
Press the tab to open the desktop mounting bracket’s
cable guide. Feed the included Ethernet cable through the
guide to connect to the ETH0/POE in port on the back of
the AP150. Close the guide to secure it. Connect the other
end of the cable to an active Internet connection.
BEST PRACTICE: Make sure to install the Ooma AP150
on a low desk located closest to the area where you need a
strong Wi-Fi®signal, and that the Ooma AP150 is oriented
with its front side facing the direction where you would like
to have the strongest Wi-Fi®signal.
IMPORTANT: If you are using Ooma Connect internet
service, connect the ETH0/POE in port to the LAN port
on the Connect Base Station.
Ooma AP150
Mounting Bracket
NOTE: If you don’t have a means of directly connecting this
device to the Ethernet, and if you have additional AP150s
or AP250s connected to the Internet, skip this step and
proceed to STEP 4. This device will automatically connect
to the mesh network created by the existing devices
Ethernet
Connection
ETH0 / POE IN
Mounting Bracket
with Ooma AP150 Mounted
67
