Optoma ML500 Manuale utente
SERVICE MANUAL
Prepared: Checked: Approved:
Date Revise Version Description
2011.08.23 V1.0 Initial Issue
2011.09.5 V2.0 Modify Chapter 6 ,Chapter 3
2011.10.18
V3.0 Modify chapter 5,add new method to upgrade
multimedia FW
ML500
Copyright OCT. 2011 All Rights Reserved
Chris Amy Alick
ML500 Condential II
Preface
This manual is applied to ML500 projection system. The manual gives you a brief
description of basic technical information to help in service and maintain the product.
Your customers will appreciate the quick response time when you immediately identify
problems that occur with our products. We expect your customers will appreciate the
service that you offer them.
This manual is for technicians and people who have an electronic background. Please
send the product back to the distributor for repairing and do not attempt to do anything that
is complex or is not mentioned in the troubleshooting.
Notice:
The information found in this manual is subject to change without prior notice. Any
subsequent changes made to the data herein will be incorporated in future edition.
ML500 Service Manual
Copyright OCT. 2011
All Rights Reserved
Manual Version 3.0
ML500 Condential
III
Table of Content
Chapter 1 Introduction
Highlight 1-1
Compatible Mode 1-2
Chapter 2 Disassembly Process
Equipment Needed & Product Overview 2-1
Disassemble Top Cover Module and Key Pad 2-2
Disassemble LED Driver Board 2-4
Disassemble Main Board 2-5
Disassemble Fan 2-6
Disassemble Light Sensor Board 2-7
Disassemble Speaker and IR Board 2-7
Disassemble Engine Module and LED 2-8
Disassemble LVPS 2-10
Disassemble Bottom Cover Module 2-11
Re-write LED Usage Hour 2-12
Repair Action 2-13
Chapter 3 Troubleshooting
Equipment Needed 3-1
Main Procedure 3-2
No Power Troubleshooting 3-3
Power Troubleshooting 3-4
Image Troubleshooting 3-5
ML500 Condential IV
Remote Control Troubleshooting 3-9
Chapter 4 Function Test & Alignment Procedure
Test Equipment Needed 4-1
Test Conditon 4-1
I/O Port Test 4-2
Composite Port And Audio Test 4-7
S-Video Port Test 4-7
HDMI Port Test 4-7
3D test 4-8
SD Card /Mini USB/ USB ash disk test 4-8
Calibration 4-10
Run in test 4-12
Test Inspection Procedure 4-13
Chapter 5 Firmware Upgrade
Section 1: System Firmware Upgrade 5-1
Equipment Needed 5-1
DLP Composer Lite Setup Procedure 5-2
Firmware Upgrade Procedure 5-4
Section 2: Multi-Media Firmware Upgrade(USB) 5-7
ML500 Condential VI
USB Driver Upgrade Procedure 5-8
Multi-Media Firmware Upgrade 5-10
Section 3: Multi-Media Firmware Upgrade(SD Card) 5-13
Multi-Media Firmware Upgrade procedure 5-14
Section 4: 8051 Firmware Upgrade 5-17
Firmware Upgrade Procedure 5-18
Chapter 6 EDID Upgrade
EDID upgrade procedure 6-1
Appendix A Exploded Overview I
Appendix B Serial Number System Denition X
PCBA Code Denition XI
ML500 Condential 1-1
Chapter 1
Introduction
1-1 Highlight
No Item Description
1Dimensions (WxDxH) ●
220x170x41 mm
2Power Supply ●
Auto-ranging: AC100V ~ 240V ± 10%, 50-60Hz
3Power consumption ●Normal mode: 120W +/- 20%.@ 110Vac
●ECO mode: 60W +/-20% @ 110Vac
4 Keystone correction ● Vertical +/-40 degree
5Throw ratio ●WXGA 1280x800 1.4 +/- 5%
6 Projection lens ● YM102
7 LED life 20,000 Hours Bright Mode @ 75W +/-10 % , B50/
L50*Note Survival Rate
8 DMD Chip ●TI” DMD , 0.45” WXGA DMD
9System controller ● TI DPP6401
10 Throw Distance 0.52m ~3.00 m (mechanical travel range)
0.91m ~ 2.40 m (optical travel range)
11 Video compatibility
Standards :
● NTSC M/J, 3.58MHz, 4.43MHz
● PAL BG/DK/I/M/N , 4.43MHz
● 480i, 480p, 576i, 576p, 720p, 1080i
12 Input signal spec
● Analog RGB signal (PC)
- Analog RGB 0.7 +/- 0.1 Vp-p, 75 ohm
- Separate TTL H,V Sync.
● Video signalVideo signal
- NTSC/PAL Composite video 1.0 +/- 0.1 Vp-p, 75ohm
● Audio signalAudio signal
- 900mVrms, 22K ohm
Condential 1-2
ML500
Compatibility Resolution V-Sync [Hz]
VGA
640 x 480 60
800x600 60
1024x768 60
1280x720 60
1280x800 60
Video
480i/480p 60
576i/576p 50
720p 50/60
1080i/1080p 50/60
HDMI
480i/480p 60
576i/576p 50
720p 50/60
1080i/1080p 50/60
No Item Description
13 Altitude&Temperature
● Operating: 0 ~ 2,500 ft, for 5°C~35°C
2,500 ft ~ 5,000 ft, for 5°C~30°C
5,000 ft ~ 10,000 ft, for 5°C~25°C
● Operating: 5 ~ 35 °C
Non-operation:-20°C ~ 60°C
1-2 Compatible Mode
●Computer Compatibility
Condential 1-3
ML500
●Compatibility: Document
Ofce Version
Microsoft® Ofce 95
Microsoft® Ofce 97
Microsoft® Ofce 2000
Microsoft® Ofce 2003
Microsoft® Ofce 2007
Microsoft® Ofce 2010
- Compatible Document Format
- Compatible Document Format
Microsoft® Ofce Application File Extension
Word .doc
.docx
Power Point .ppt
.pptx
Excel .xls
.xlsx
Adobe PDF .pdf
●Media File Support List Video
File Type Video Resolution Bit Rate Frame Rate Audio Code Remark
AVI
MKV
XVID
MPEG4
H.264
M-JPEG
WMV3
1080P 20Mbps 30fps
AC3
DTS
MPEG1/2/3
PCM
ADPCM
AAC
No support VC-
1 AP
H.264 support
less
than 4 reference
frames
TS H.264 1080P 20Mbps 30fps
AC3
AAC
MPEG1/2/3
DTS
LPCM
H.264 support
less
than 4 reference
frames
DAT
VOB
MPG
MPEG
MPEG-1 1080P 20Mbps 30fps
MPEG1/2/3
AC3
DTS
LPCM
- Video
Condential 1-4
ML500
MOV
MP4
3GP
MPEG-4
H.264
H.263
1080P 20Mbps 30fps
AAC
AMR
PCM
ADPCM
H.264 support
less
than 4 reference
frames
RM
RMVB
RV3
RV4 720P 5Mbps 30fps
Cook(RA4)
AAC(RA9)
RACP(RA10)
WMV WMV3 1080P 20Mbps 30fps WMA2
WMA3
No support VC-
1 AP
- Image
Image Type (Ext
name)
Sub Type Encode Type Max Pixels
JPEG
JPG
Baseline
YUV400 No Limit
YUV420 No Limit
YUV422 No Limit
YUV440 No Limit
YUV444 No Limit
Progressive
YUV400
Width<=10240
& Height <= 6400
YUV420
YUV422
YUV440
YUV444
BMP No Limit
- Music
Music Type (Ext name) Sample Rate (KHz) Bit Rate (Kbps)
MP1/MP2/MP3 8-48 8-320
WMA 22-48 5-320
OGG 8-48 64-320
ADPCM-WAV 8-48 32-384
PCM-WAV 8-48 128-1536
AAC 8-48 8-256
Note: If the Computer Compatibility supportive signal is different from User’s Manual,
please refer to User’s Manual.
ML500 Condential 2-1
Chapter 2
Disassemble And Repair Action
2-1 Equipment Needed & Product Overview
1. Screw Bit (+) :107
2. Hex Sleeves 5mm
3. Screw Bit (+) :102
4. Hex Sleeves 7mm
5. Tweezers
6. ML500 unit
* Before you start: This process is protective level II. Operators should wear electrostatic
chains.
* Note: If you need to replace the main board, you have to get into service mode and
record the LED usage hour. please refer to section 2-12.
Altri manuali per ML500
5
Indice
Altri manuali Optoma Proiettore
Optoma
Optoma S331 Manuale utente
Optoma
Optoma TH1060 Manuale utente
Optoma
Optoma EH300 Manuale utente
Optoma
Optoma Projector Manuale utente
Optoma
Optoma FW5200 Manuale utente
Optoma
Optoma HD72 Manuale utente
Optoma
Optoma ThemeScene HD72i Manuale utente
Optoma
Optoma DS325 Manuale utente
Optoma
Optoma EH2060 Manuale utente
Optoma
Optoma DS550 Manuale utente
Optoma
Optoma PlayTime PT110 Manuale utente
Optoma
Optoma HD33 Manuale utente
Optoma
Optoma TX615-3D Manuale utente
Optoma
Optoma DS317 Manuale utente
Optoma
Optoma EP759 Manuale utente
Optoma
Optoma EX330 Manuale utente
Optoma
Optoma OMA-S Manuale utente
Optoma
Optoma TX-330 Manuale di installazione e funzionamento
Optoma
Optoma HD230X Manuale utente
Optoma
Optoma EcoBright TL30W Manuale utente
